Question about 1998 Subaru Forester

1 Answer

How to remove the lock cylinder from the driver's side door on my 98 Subaru Forester?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 231 Answers

Hi by removing the door card and removing a retaining surclip that holds it onto the door handle from the inside it should then just slide out

Posted on Apr 05, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do. You tighten the drivers side door handle on a 04 subaru forester


remove the door trim and up on the inside of the door skin there will be screws or nuts to tighten the handle.

Jan 19, 2015 | Subaru Cars & Trucks

1 Answer

How to replace rear differential carrier bearing without removing differential?- 2004 subaru forester


I can't see how that is possible given what needs to be removed to access the bearings. The rear diff is not very difficult to remove from the car

Aug 09, 2014 | 2004 Subaru Forester

1 Answer

How do you remove the door panel drivers side for a subaru forester 2001, I have most of the screws out but the top of the panel will not come lose for some reason,


Once all screws and connections (plastic pops at the bottom of frame and window control module) are disconnected slide plastic frame away from the dash. Should slide out with a little force, also, make sure to remove the screw in the tweeter speaker compartment, often forgotten. Hope this helps.

Dec 31, 2010 | 2000 Subaru Forester

1 Answer

Where is the re-set button to program a remote door lock for my 2000 Subaru Forester?


Obtain all keys/remote controls. Remove driver's side kick panel/lower 'A' pillar trim. Connect central locking registration connectors (white) - black wire and black/blue wire Fig. 2 . Unlock the vehicle using the key. Program first key/remote control as follows: Press unlock button Fig. 1 [1], then lock button [2]. The door lock should lock and unlock in sequence confirming programming of first key/remote control. Repeat programming procedure for remaining key(s)/remote control(s). Once the last key/remote control is programmed disconnect central locking registration connectors. Check operation of all programmed keys/remote controls.

Sep 03, 2010 | 2000 Subaru Forester

1 Answer

Electrical-check engine light blinking & door lock, lock/unlocks


first unhook the battery for 15seconds and hook it up......if that dnt work jus say somthing i pretty sure i can help u figure this out

Mar 28, 2010 | 1999 Subaru Forester

1 Answer

2000 Subaru Forester drivers side outside door handle has jammed


take off inside door panel and check the linkage on the lock may be broken

Sep 15, 2009 | 2000 Subaru Forester

1 Answer

Installing replacement side mirror on 2007 Subaru Forester


yes... you'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you can access the bolts holding the mirror on and disconnect the wiring harness as well..

Aug 20, 2009 | 2007 Subaru Forester 2.5X L.L. Bean...

1 Answer

Window stuck - 1998 Forester Limited


I installed speakers in my door panels.
Pop up the window controlls unplug switches,
remove plastic screw hiders to expose phillips screws
remove screw from door latch lever
pull out on door panel, then lift up
its not too hard good luck
lowrob77@yahoo.com

Jan 10, 2009 | 1998 Subaru Forester

1 Answer

2003 Forester, only driver's side window works


the first thing i would check is the master window switch, on the drivers door, the window lock circuit locks out the operation of the other three windows. the intermittent operation of the windows suggests a possible loose connection or contact.

Dec 14, 2008 | 2001 Subaru Forester

1 Answer

My 2003 Forester driver side window wont work.


You need power window regulator as the cable of the regulator is out its place ,

  1. Remove the gusset cover.
  2. Pull up the inner door handle cover toward you to remove the upper hook. Pull down it to remove the lower hook. Remove the inner door handle cover.
  3. Remove the power window switch assembly.
  4. Using a trim panel remover, remove the clips of the trim panel.
  5. Remove the speaker.
  6. Using a spatula, remove the door sealer.
  7. Remove the outer mirror assembly.
  8. Remove the front end of the door weatherstrip and gusset.
  9. Remove the stabilizers.
  10. Remove the rear end of the door weatherstrip (inner and outer).
  11. Operate the power windows switch so the bolts from the regular assembly are visible through the service holes. Remove the mounting nuts.
  12. Take out the door glass. CAUTIONDo not turn the regulator in closing direction after removal of the glass. Otherwise gear may be disengaged.
  13. Loosen the nuts to remove the rear sash.
  14. Disconnect the power window motor wiring harness.
  15. Loosen the four bolts and two nuts to pull out the regulator assembly.
  16. Remove the screws to remove the motor from the regulator assembly.
  17. Installation is the reverse order of removal.0759a6d.jpg23cb1e4.jpg

Good luck...

Oct 21, 2008 | 2001 Subaru Forester

Not finding what you are looking for?
1998 Subaru Forester Logo

303 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...