Question about Honda Accord

1 Answer

I'm not getting any fire to spark plugs.I replaced distributor cap and rotor button,fuel ok,fuel fiter and pump ok,new plugs and wires.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,399 Answers

Thanks for choosing FixYa. Since you have replaced most of the ignition system, have you checked your cam sensor or crank sensor? Check them with a voltage meter and make sure they are getting power if you can. Are you sure that your vehicle is in time, TDC? If so, my next move would be checking the cam sensor, unless yours is built in with the distributor. It could be the distributor itself.

Posted on Mar 31, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ok so i have 95 chevy silverado i change plugs wires,plugs,rotor button, distributor cap, fuel pump,fuel fiter and it still is missing up i have to hold it to the floor and it takes a bit to crank anyone...


Check distributor I have a 93 1500 pull cap and trun engine over watch the shaft if nothing turn truck off and check free play on rotor bug shaft

Jan 28, 2013 | 1995 Chevrolet K1500

2 Answers

94 chevy 1500 4.3 no spark no fuel


Sounds like you replaced alot of parts for nothing.
The pickup coil in the distributor "fires" the module which grounds the coil and the injectors.
Those components would need to be tested. The coil fires the plugs when the ground is removed by the module or the key switch.

Jan 08, 2013 | GMC C1500 Cars & Trucks

3 Answers

I have a 1993 chev pick-up v6 4.3, i just installed new spark plugs,new plug wires, distributor cap and rotor button.All plug wires are back in the right position,and i used the firing order 1-6-5-4-3-2...


This diagram is for 1998-1995 Chevy 6 cylinder 4.3L engines.
Your got the firing order exactly correct, at 1-6-5-4-3-2, but here's the thing to double-check:
The distributor rotation is clockwise (note badly rendered arrow in picture).



archaeology_96.jpg

Since you probably got everything right, then you're left with really unusual/rare causes of
failure of the ignition system:
(a) rotor button misaligned/failing to make contact?
(b) rotor button not pressed onto distributor shaft far enough therefore failing to provide correct
proximity to distributor cap contacts when coil fires
(c) coil wire or contact loose/disconnected - press coil wire firmly down into distributor cap.
(d) distributor shaft of other damage caused during installation of rotor.
(e) spark plug wires defective from factory
(f) spark plugs defective from factory
(g) battery low - may need a charge to start
(h) ICM (ignition control module) failure - hook up your HEI (high energy ignition) tester, and
watch the quality of the spark on each cylinder.
(i) fuel problem? If spark is being properly delivered, its gotta be a fuel problem...
(j) distributor cap not screwed down flush to top of distributor? maybe just on one side?

Inspect the inside of the distributor cap - if there are lots of little metal bits all over the inside
of the distributor cap, then you know you have a misalignment of some type in there, and the
rotor and cap are destroying each other. normal operation will throw a quota of spark-ed off
metal bits inside the distributor cap, but since your cap is brand new, your attempts to start
the engine should have rotated the distributor so few times, you should see no metal debris.

Inspect the distributor cap contacts to see if any spark marks are more of less in the middle
of the cap's proper "contact zone". If not, you've diagnosed an internal misalignment, which
you know how to correct.

Sep 14, 2011 | Chevrolet 1500 Cars & Trucks

2 Answers

92 civic engine stalled while driving; fuel pump works; replaced all plugs seeing some oil on old ones. only one plug fires; is coil still working? or the distributor? haven't checked fuel...


Hi,
Check the ignition distributor cap and clean the electric contact points it might be already dirty.

if one has a spark that means your ignition coil is still okay. Remove the whole cap and check the inside part and clean it, use emery board.
Check also the high tension wires( spark plug wires ).
Hope Fixya helps you!

Aug 28, 2011 | 1992 Honda Civic

1 Answer

Replaced bad fuel pump, installed new relay and fuel filter, engine turns over but is not firing on..... positive the fuel pump is pumping gas and checked to see if gas was going thru fuel filter. Tried...


Hi, Ok you have confirmed that it's not a fuel problem. You need to check for spark. Pull the coil wire off of the coil(secondary lead-looks like a spark plug wire) Have some one crank it over and listen for a popping sound. IF yes, spark is at the coil, that means all ignition sensors are working. Next check for spark at ends of wires after cap. IF no replace cap and rotor. IF yes remove a couple spark plugs and check for fouling(wet, fuel etc...) IF yes replace or clean plugs and retest for starting. IF no spark is present at coil you need to scan computer and watch for rpm signal. IF no rpm signal, replace crankshaft sensor with OEM delco part. BIGGEST problem with these engines is Cap and Rotor burn out.

May 23, 2011 | 2002 Chevrolet Blazer

1 Answer

Low power and missfire, have replaced bad distributor and rotor. 2000 Oldsmobile Bravada AWD. Where are the fuel pump and filter located?


I have replaced Distributor cap, rotor, wires, and spark plugs in my 2000 Oldsmobile Bravada AWD smart track. To replace one spark plug I had to collapse the steering column, but everything went O.K. Did you marked the wires?. Did you reconnect them in the firing order?
The fuel pump is located In the fuel tank. Remove the fuel tank and take the fuel pump out from the top. This is part cost $300 and need some skills to be replaced.
The fuel filter it is directly in front of the fuel tank. Another one is incorporated with the fuel pump.

Sep 10, 2010 | 2000 Oldsmobile Bravada

1 Answer

'99 silverado will turn over but won't start. I have a new battery, 6 month old starter, new plugs, new distributor cap and rotary button. I used to be able to turn the ignition on and off real quick and...


I'd start with one of these and move on to the next.

Fuel
Spark.

Is it getting fuel? You should have an "in tank" electric fuel pump. When you turn the key halfway (just before turning the engine/starter over), you should hear the fuel pump prime. Easy way to check is to look in the throttle body while someone turns the key to the "on" position. You should see/smell the fuel. You can also listen to the gas tank while the key gets turned. You should hear the fuel pump run.

To check spark, pull a spark plug out, put it back on the plug wire and rest the electrode end of the plug up against the engine or exhaust manifold and have someone turn the engine over. You should see the spark plug firing. Don't hold the plug or wire while doing this. You'll get zapped if it's working ok.

If these both check out ok, then take a look at your firing order. If it's off by a significant amount, it may not fire. I've seen this happen when a cap/rotor/wires were changed and the wire/rotor was not positioned on the correct cylinder. (Most of the time they will at least fire or backfire, but either not stay running or run REALLY badly if the firing order is off.

Jan 18, 2010 | 1999 Chevrolet Silverado 1500

2 Answers

Starting problem sometimes 4cly


change the fuel fiter and if that dont work then it the fuel pump

Nov 21, 2009 | 1995 Toyota Camry

5 Answers

1995 dodge dakota 2wd 3.9 no spark to plugs,or coil,orfuelpump


First of all let's explain how the spark gets to the plugs. There is a crankshaft position sensor and a cam sensor. They are what determines when to fire the coils and injectors. The crank sensor is located on the passenger side on top of the bellhousing, the cam sensor is the pickup plate in the distributor. As the engin turns the send refernece pulses to the computer which grounds and ungrounds the ignition coil causing it to discharge and send voltager from the secondary coil wire to the center tower in the distributor cap. The rotor button recieves the voltage and distributes it to the 6 towers (1 for each cylinder) If you say you're getting spark from the rotor that tells me the primary side of the ignition system is working, and the secondary side is working into the distributor cap. I'd check for spark out of the plug wires at the plugs. Pull a wire and insert a #2 phillips screwdriver into it, hol the shaft of the screwdriver aprox 1/8"(no more) from the exaust manifold and observe the spark as someone turns over the engine. You should see a nice blue spark. If theres spark, spray a little gum cutter in the throttle body an crank it, if it fires you have a fuel problem. Install a fuel pressure gauge on the schrader valve on the fuel rail and observe it as you crank it. If theres no fuel pressure maks sure there's fuel in the tank, if so climb underneath and beat on the bottom of the tank with a rubber hammer, the pump may be going bad, sometimes you can jar them and make them run.

Aug 24, 2009 | 1995 Dodge Dakota

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...