Question about 1999 Honda Passport

Open Question

4wd when i was trying to fix my mirrors today i accidently pressed the 4wd button. i turned it off but now it still says that it is on 4wd and it doesnt run as well. HELP PLEASE!!!

Posted by on

  • luckyu Sep 09, 2008

    same problem only it does make a sound . Something like a rolling on wheel sound almost a clicking sound. This started after my 4wd like keep coming on and off. The sound came when like just stays on.



Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 tundra 4wd takes forever to engage, 4 low will not

try pushing button and then put in reverse back up a bit and then put in drive see if it goes in quicker. put truck in nuetral befor putting into 4 low

Oct 01, 2012 | Cars & Trucks

1 Answer

Where in the onstar module in a 2004 pontiac grand prix?

On this website (link below) you find fuse box diagram and description for Pontiac Grand Prix 2004

Pontiac Grand Prix mk7 Seventh Generation 2004 fuse box diagram Auto Genius

Nov 16, 2011 | Cars & Trucks

1 Answer

Hi i have a 2000 Chev Blazer, the service 4WD light appears now and then , we never use 4WD so was not worried about it until today i tryed to put into 4WD and it would not work the lights on the buttons...

one of my vehicles is actually a 2000 blazer and i had that same problem believe it or not. you should check all the connections to the brain of the 4wd. take off the passenger side right side kick panel. the kick pannel is that piece on the side right there next to the door. take that off and you will see a grey box. pull the wires out and look at the ends. i cleaned mine out with a q tip because there was crud in one of them which screws things up. if that doesnt fix it you may need a new one. they can be really expensive from a dealer so i went to a wrecking yard and pulled one out of another blazer and it only cost $20. it works fine now :) i hope that helps.

Jan 06, 2011 | Chevrolet Blazer Cars & Trucks

1 Answer

I have a 1994 chevy blazer 4door with real time 4wd but the button when i press it doesnt lockin an the 4wd lite doesnt come on what should i do

I've replaced about 100 of these buttons. For some reason the spring lock goes bad on them. It can be found at a salvage yard for about 20 dollars. Try to locate one near you. If the dash switch isn't listed, try looking for a dash of other such item just to locate a vehicle that is compatible and then call them . Please rate my assistance and leave a testimonial

Dec 28, 2010 | 1994 Chevrolet S-10 Blazer

2 Answers

My 2000 Chevrolet Blazer is stuck in 4low. Today my "service 4wd" lit up on my dash. I asked a friend to check it out really quick. He tried putting the car into auto 4wd with my push button switch over...

Start with the simple and check the fuses and replace any one that has gone bad. Pay attention to the 4WD fuse and replace it is it has gone bad.
Thank you for using fixya and keep me posted, be glad to help you get your Blazer running 100% again soon.

Jun 02, 2010 | 2000 Chevrolet Blazer

1 Answer

4wd is not turning on. its electronic 4wd and i push the buttons and it wont turn on

I have a 2004 Yukon and today I got no lights and a check 4WD anouncement. I need help too. If I fix mine I'll let you know what I did.

Apr 24, 2010 | 2003 GMC Yukon

1 Answer

04 Z71 4wd problems

can you hear the shifter motor trying 2 shift? if not its the shifter motor open the door and try 2 listen when your trying 2 shift it

Feb 13, 2010 | 1999 Chevrolet Silverado 1500

3 Answers

1994 GMC Jimmy 4WD not working

I'm not entirely sure this may be the problem, but I think I know what it is. On the older model S series blazers and jimmy's, they had an air actuation that locked your front differential. Which essentially means that when you press the button for 4wd, there is a little valve that opens and creates a vaccum. That vaccum pulls a pin, activating your 4wd. What may have happened is that it may be stuck halfway between 4wd and 2wd. Your symptoms sound like this is the problem. You may have to do to a shop to get that repaired. It should not be costly, as it may just be a matter of them hooking up a damaged vaccum line. Or you can go an alternate route, and go to a 4wd store (such as desert rat) and purchase a differential lock cable (runs about 125 dollars.) and have that installed. All in all, either route you take, you are probably looking somewhere around 150 to 200 dollars to have it repaired. But it does'nt sound like there is anything majorly wrong with your 4wd. Just the 4wd activation system.

Dec 23, 2008 | 1994 GMC Jimmy

Not finding what you are looking for?
1999 Honda Passport Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides