Question about 2007 Jeep Commander Rocky Mountain

1 Answer

2007 Jeep Commander - Rear break light not working and I need to replace it. I can't figure out how to take off the red light covering. I even called a Jeep service station and he was clueless. HELP amico301@hotmail.com

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 44 Answers

Open the liftgate, then look along the inside edge of the tail lamp. There should be a couple of fasteners holding the lamp in place. Pull those out, then pull directly backward on the tail lamp. At this point, the only things keeping the it in place are 2 nubs that are behind the tail lamp. You may need to use something (preferably not metal so as to keep from scratching the paint) to help pry the tail lamp backward away from the vehicle. This should be done along the forward-most edge of the tail lamp. There should be a soft popping noise when each nub is pulled out of the rubber socket.

Hope this helps!

Posted on Mar 30, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Jeep Commander


check the back off the seat there is a switch turn it and then it unlocks the seat.

Mar 09, 2014 | 2007 Jeep Commander 5.7

1 Answer

The check engine light is on my 2007 jeep commander


Usually is one of your sensors but you can get it checked by auto zone for free on the diagnostic machine..

Mar 16, 2013 | 2007 Jeep Commander 3.0

1 Answer

My jeep commander wont start all interior lights and extra functions but wont start


To every one here Jeep has a problem with the positive battery Cable, check battery first then replace cable with new one, the Jeep Commander is the best thing ever it will run forever and take a beating and keep on running

May 25, 2012 | 2007 Jeep Commander Rocky Mountain

1 Answer

How to remove 2007 jeep commander climate control panel for light bulb replacement


The lights in the climate control panel are not bulbs, they are LED and the entire panel will need to be replaced. I would check for a bad connection before replacing the panel assembly.

Dec 28, 2010 | 2006 Jeep Commander

1 Answer

Service 4 wheel drive light


Mine does the exact same thing i had to take it to the dealer while the light was on they told me it was a switch in the rear diff. I also have heard that its the wires going to that switch shorting out mine only pops up the message when its cold or wet out. The dealer told me they would fix it but then by the time they could figure out what it was my warantee had expired and they wont help me now.

Dec 31, 2009 | 2007 Jeep Commander Rocky Mountain

4 Answers

2007 Jeep Commander will not start


Check the battery cables, then go to the starter relay, then the starter, (If the lights are bright when you turn them on)

Aug 01, 2009 | 2007 Jeep Commander Rocky Mountain

1 Answer

Can't locate air filter...


1. Loosen clamp (1) and disconnect air duct at air cleaner cover (3). 2. Pry over 4 spring clips (5) from housing cover (spring clips retain cover to housing). 3. Release housing cover (3) from locating tabs on housing and remove cover (3). 4. Remove air cleaner element (filter) from housing.
cecdf0c.jpg

Jun 30, 2009 | 2007 Jeep Commander Rocky Mountain

1 Answer

Brake lights quit working. All fuses and bulbs are good. There is a blue wire labeled "electric brake" hanging by the pedal switch. where is this supposed to go?


I have had this problem for over 8 months. Break light would work, blinker would not . . . then blinker would work, break light would not . . . turn headlights left break light would go out . . . FINALLY my 75 year old father figured it out !!!! It was the STOP SWITCH - even though it showed it was working - Please replace it anyway !!! It's only $14.00 for the part. Also the other part needing replaced was the Flasher Relay - $34.00 !! NOONE not even JEEP could figure out this problem !!!

Jul 20, 2008 | 2000 Jeep Grand Cherokee

2 Answers

Jeep 2007 Commander


Is the hand brake working properly because if the rubber and springs used to brake the rear wheels is loose, the security assist system goes off and usually a bell rings and what not.

May 25, 2008 | 2007 Jeep Commander Rocky Mountain

Not finding what you are looking for?
2007 Jeep Commander Rocky Mountain Logo

178 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...