Cars & Trucks Logo

Related Topics:

Posted on Mar 30, 2011

1996 mitsubishi eclipse has a code p1294 when i clear it and drive it just comes back on.

4 Related Answers

Anonymous

  • 32 Answers
  • Posted on Jun 20, 2009

SOURCE: location of fuel filter on a 1996 Mitsubishi Eclipse

on a 95 model, it is located above the fuel tank in the rear of the vehicle

Ad
alicantecoli

Colin Stickland

  • 22516 Answers
  • Posted on Nov 06, 2008

SOURCE: the a/c pwr steering drive

if all the pulleys line up ,then problem is the a/c pump is full of **** and rust and its sticking causing the belt to burn up and if the pulley shaft is worn the it can turn slightly throwning the belt off.to repair this take vehicle to an a/c specialist as this sort of repair is beyond the weekend mechanic and requires special tools in the way of a machine to extract the gas before any repair can take place.the gas used on older vehicle is R12 and is extremely toxic to the ozone layer,R134 is not as bad but it is still dangerous,plus the pressure used in the system which can cause blinding so do not touch it ....

Anonymous

  • 214 Answers
  • Posted on Mar 15, 2009

SOURCE: radio locked up

Yeah! Pull the radio out .. Write down Serial Number.. Call Mitsubishi.. And THEY CAN give you a code.. Thank you

Nick Tumolo

  • 245 Answers
  • Posted on Jun 18, 2011

SOURCE: i have a 1999 mitsubishi

I kept getting this code on my 2001 stratus it had the 3.0. The problem for me was my egr valve. I was able to clean mine with card cleaner and it worked for me. But every six months it came back and had to clean it again. Later found out I had some vacuum leaks which were causing car to run rich as cause more junk to clog egr. After fixing those the problem stopped. Good luck.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

1996 dodge caravan 2.4 code p1294

on dodge motors
fitted a lot of parts and still no better

the fault code clears and comes back as a intermittent problem

could be electrical voltage drop off or heat related failure

i wonder if your 02 sensor ,the catalytic converter
or other related sensors
are causing the fault to come back
if needed .....fit a new air filter...

how the test is determined

P1294-TARGET IDLE NOT REACHED 3.3L/3.8L
When Monitored and Set Condition:
P1294-TARGET IDLE NOT REACHED 3.3L/3.8L
When Monitored: With the engine idling and the transmission in drive, if automatic.
There must not be a MAP sensor trouble code or a Throttle Position Sensor trouble code.
Set Condition: The engine idle is not within 200 rpm above or 100 rpm below the target
idle for 40 seconds. One trip fault.

POSSIBLE CAUSES
INTERMITTENT CONDITION
IAC MOTOR PASSAGES
VACUUM LEAKS
AIR INDUCTION SYSTEM
THROTTLE BODY AND THROTTLE LINKAGE
TEST ACTION APPLICABILITY
images-trsfwikau0d5dnlwn4zno1ix-3-0.jpg
0helpful
1answer

P1294 what would be the solution

Check the iac motor wiring ,if that looks ok its prob the iac motor itself ,this will cause probs with idling issues ,carbon builds up on the valve,this valve is located by the throttle plate in the back,below the tps sensor
1helpful
1answer

I have a 1999 mitsubishi eclipse with the stock 420a (non-turbo) engine. The check engine light turner on with two codes, p1494 and p1495. I fixed p1294 but still have no clue what p1495 is or how to fix...

I kept getting this code on my 2001 stratus it had the 3.0. The problem for me was my egr valve. I was able to clean mine with card cleaner and it worked for me. But every six months it came back and had to clean it again. Later found out I had some vacuum leaks which were causing car to run rich as cause more junk to clog egr. After fixing those the problem stopped. Good luck.
0helpful
2answers

My 1996 mitsubishi eclipse will not turn on

check the battery. if it has a little clear eye on top it should be green if it is black replace the battery.
0helpful
1answer

2003 mitsubishi code comeing up is po441,po107 motor was jerking then it stoped.now the service enigne light is on and when clear it ,it still comes back on. this is a 3.0 v6

p0441
Evaporative emission control system incorrect purge flow

p0107

Manifold absolute pressureor barometic pressure circuit,low input
0helpful
1answer

1999 mitsubishi eclipse

is it an awd or just a front wheel drive
0helpful
1answer

Radio locked up

Yeah! Pull the radio out .. Write down Serial Number.. Call Mitsubishi.. And THEY CAN give you a code.. Thank you
0helpful
1answer

Mitsubishi eclipse 2001

Drive cycle is performed by driving the car at hiway and city speeds over a few days and perhaps 50 miles or so, if the system detects the same issue after a few days of driving and completion of drive cycle then the check engine light will come back on.
Not finding what you are looking for?

153 views

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...