Question about 2000 GMC Jimmy

1 Answer

Car doesnt idle properly and when you put it in drive or come to a stop and push the gas it jerks really bad

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 52 Answers

Possibly bad motor and or transmission mounts, if when the car is running you can see the motor rocking back and forth excessively that is definately your problem.

Posted on Mar 30, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi my name is Don while drive in my car it's fine until I cut Da ac on then it starts jerking like it have bad gas like Da plugs in there bad I done got egr lines new coals an New plugs it stop for about 2...


Hello, Don with da a/c on...
Although "jerking" doesn't rhyme with "plugs," I think I understand your question.
Depending on what kind of car it is (you didn't say), there is likely either an air bypass or an Idle Air Controller, which is designed to maintain the idle under the load of the a/c compressor. If the air bypass or IAC is not functioning correctly, the idle will be allowed to fall below specification, making the car idle rough because the idle is too low.
Check to be sure that your air bypass or IAC is working properly.

Jul 17, 2014 | Cars & Trucks

1 Answer

What is a Bank1 and Bank 2 mean had codes #po171 and P)174


Bank 1 is the cylinder bank that has #1 cylinder in it, bank two is on the opposite site of the bank 1.

Mar 16, 2017 | 2001 Ford Mustang

1 Answer

Causes car jerk


Car needs to warm up properly so that the automatic choke disengages completely,
After allowing the car to run at idle for a minute or two,
Give the accelerator pedal a quick push to about 1/3 throttle,
Idle speed should drop back to normal running speed and the car drive properly

Jul 27, 2017 | Toyota Corolla Cars & Trucks

1 Answer

I drive a 95 pathfinder. When I am driving and push on the brake to lower my speed, or even stop at a stoplight it will die, not all the time does this happen but it is very scary when it does. Sometimes...


it sounds like a tps or tbs. it a throttle position (body) sensor. it a plug that will be on or near the intake, have you had any work done to it lately?

Oct 10, 2013 | 1995 Nissan Pathfinder

1 Answer

Jerking when gas is pushed or in idle


It has been my experience with nissan that from your description, the EGR valve is bad."exaust gas recurculater" However it also may have a fuel filter issue due to perhaps water in fuel, trash,etc. If the engine operates correctly once you get it past the "shaky"area then the chances of the EGR valve being bad are better.
Hope this helps.....Good Luck!

Mar 28, 2013 | 2000 Nissan Xterra

1 Answer

Engine runs bad, sometimes dies when put into drive or reverse


CHECK FOR OIL LEAK ONTO SPARK PLUGS REPAIR AS NECCESSARY

Aug 19, 2012 | 1993 Saturn SL2

1 Answer

04 mazda6 sedan...100000miles and engine jerks?


lets break this down ,there is a little sensor on the air intake known as the air filter [i hope you have changed] it detects the amount of air flowing into the engine.it can be faulty.2if your weather is good for a long time little rubber joints get dried up and like to make noises but sometimes its good to get them checked out,adrian

Jun 25, 2010 | 2004 Mazda 6

1 Answer

Same problem


Is the clutch properly adjusted?

Oct 09, 2009 | 2003 Chevrolet Cavalier

Not finding what you are looking for?
2000 GMC Jimmy Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...