Question about 2002 Mazda Miata

Open Question

Mx5 rear fog light wiring diagram inclusive of relay to operate

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 88 Answers

SOURCE: need wiring shematic for fog lights 2005 toyota corolla

im pretty sure these cars were already prewired for fog lights .there should be some plugs behind the bumper to fit them.if not get back i will explain how to wire them up.best of luck.

Posted on Oct 17, 2008

Ad
ButtFuzz
  • 463 Answers

SOURCE: i need a wiring diagram for fog lights oem to my toyota

The link below is a Typical fog lamp / driving lamp hookup. Keep in mind that in most states, for these lamps to be 'legal' (and thus pass inspection), you must wire them such that:

1. You can cut them off (in other words, there must be a switch installed to turn them off)

and

2. They may only be operated with the low beams. (therefore, you must power your on/off switch from the low beam circuit)

http://www.accessconnect.com/fog_driving_lights_wiring.htm

Posted on Feb 28, 2009

  • 6 Answers

SOURCE: dashboard and fog lights don't work

change fuse

Posted on May 17, 2009

  • 1 Answer

SOURCE: NEED WIRING DIAGRAM TO INSTALL SWITCH FOR REAR FOG LIGHT

problem had to do with the ballast resistance...

Posted on May 21, 2009

co7196
  • 3433 Answers

SOURCE: fog lights not turning on

Sounds good to me except, the switch light shout be on the relay primary circiut and light off until you turn it on. When you turn the switch on, it lights up and energizes the relay, the relay closes and completes the secondary circiut for ythe fog lights. VIOLA' I have a silverado. done deal thanks

Posted on May 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Scenic 54 reg hi beams and front fogs not working


It would be easier to find clues to the fault using a circuit diagram.

There are slight differences how the fog lights are wired and generally are intended to be used only with dipped headlights but for exact operational details the vehicle handbook should be consulted.
You didn't mention what the rear lights including the rear fog lights are doing?

The fog lights usually derive the supply or the control for the circuit from the main lighting circuit so it would seem the fault is before the point in the lighting circuit of that connection.

Nov 20, 2017 | Cars & Trucks

1 Answer

My NISSAN NV200 2011 front fog lights do not work.


Both fuse and relay are located in engine compartment fusebox.
Click the link below to go through fuse box diagram:----

http://schematicsdiagram.blogspot.com/2013/02/nissan-fog-lamp-relay-and-fuse-box.html


-------
This will help.
Thanks.

Feb 14, 2013 | Cars & Trucks

1 Answer

How to install fog lights


To do it right you will need several things. Go to Autozone.com and register your vehicle to get a free wiring diagram and fusebox diagram.

This will help you wire the Fog lights. Here is how you plan this. You will need a light Relay to go inline between the lights and the Power supply. Get a Relay which needs a trigger wire to activate and fuse the power line going to the Relay.

This means that the Relay only needs power from the trigger wire to activate the connection between the power and the lights.

Then you need to pass the trigger wire through the Firewall(Cabin) in a manner that will not chaff the wire. This wire should be fused too! You can try to use an unused position in the Fusebox or inline fuse.

The power for this trigger wire should be controlled by the Ignition switch

This means that it will only have power when the Ignition is on. You do not want it to receive power when the Ignition is in ACC or OFF.

Wiring it in this sequence will prevent you from leaving the Fog lights burning without having the Ignition switch in the RUN position. Doing it this way will also let you leave the Fog lights switched ON between uses so you need not bother to turn the Fog lights off/on each time you get in your car.

Each power wire is protected by a fuse so if something shorts on one side of the Relay, the other end of the Relay may be unharmed.

Then it is just a matter of chosing the switch, lighted will indicate if the Fog lights are on, but not necessary to the basic operation of the switch. Then chose wisely for where you drill a mounting hole. Sometimes it is good to chose a panel that can be replaced if you change your mind about its' location.

Please rate my solution.

Oct 21, 2012 | 2011 Chevrolet Cruze

1 Answer

Wiring for Bosch Hologen Fog Lights? Wiring harness has 5 wires from relay, Red to battery, 2 Black - 1 to each light?, 1 Yellow to?, 1 Blue to?, & where do the xtra Black and Green wires go to? These...


Look on the relay for the terminal numbers.
Terminal 30 goes to the battery positive.Red Wire
The two terminal 87 go to the fog lights.Black Wires
Match the color wire with what you have on the relay connection for the rest of the wires.
Terminal 86 should connect to your low beam headlight.
Terminal 85 should go to the fog light switch.
The fog light switch should connect to the terminal 85 and the other terminal on the switch will connect to ground.

Dec 21, 2009 | 1987 Nissan Pickup

2 Answers

I want to install aux. backup lights and not wiring them to the jeeps backup ligts. I don't understand the switch. It has three prongs on the back The diagram shows one is power coming from the relay one...


What diagram? What switch? Are you using a switch that salready in the Jeep, or a switch that you bought? You really need a relay to handle th ecurrent of the lights. The relay will have 4 terminals, The relay is really just a remote switch. Let the relay take the power, not the switch. Buy a relay for fog lights and it should have a diagram you can use.

Dec 19, 2009 | 2004 Jeep Wrangler

1 Answer

1988 range rover - The brake light switch operates the brake lights but also: operating the brake light switch makes the fog lamp switch illumination bulb come on - if the fog light switch is already on...


Yep it happens
http://www.rangey.com/page7.html
Look for cutts in the wiring, tape up. Check all plugs and relays, you can find.
As for diagrammes, either a Haynes of down load a manual, if you have no joy on Google or Alltheweb try http://www.landroverweb.com/Land-Rover-Range-Rover-manual-pdf.htm
There are no front fogs fitted, only the driving lights in the air dam, the switch with the 2 on it lower front dash cluster with rear fog light switch etc.

Nov 15, 2009 | 1988 Land Rover Range Rover

2 Answers

2004 Saab 9.3 Conv Passenger side front & rear fog lights will not work. New bulbs. Why? What to do? Is there a fuse for just those on right side? All other lights work fine.


Sounds like similar problem I had on my older 93 - one side main beam and brake light not working. Turned out to be a problem with the filament testing relay. Got it resoldered and now ok.

Oct 16, 2009 | 2008 Saab 9-3

1 Answer

Have a mazda eunos year 1990. switch for fog light lights up when switched on ...cant find fog light on rear? which bulb is for fog light please!


Many MX5 owners convert the extra brake light on the boot lid to a fog light. Has this been done to yours?

Jun 15, 2009 | 1990 Mazda MX-5

3 Answers

Windshield washer Pump doesn't run, but the pump checks out good


there is another small relay box just below the windshield washer reservoir about 11/2" wide x about 4" long the washer pump relay is in there



Nov 23, 2008 | 1999 Ford Explorer

Not finding what you are looking for?
2002 Mazda Miata Logo

Related Topics:

429 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8575 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...