Question about 2004 Audi A4

1 Answer

Hi my gas cap actuator is no working i can't lock it and there is no release botton

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,793 Answers

From inside the trunk,pull away the carpet trim inside where the cap should be and you will find a release wire.

Posted on Mar 30, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 Cadi Deville, can't get any locks to operate with remote or dash push buttons, the remote operates everthing but the locks! When the remote door lock is pressed, lites flash,horn blows locks not.


Power Door Lock Operation
The vehicle is equipped with power door locks. Each lock actuator is powered and controlled by the door module mounted in the individual door, but the rear integration module (RIM), which is the master control for the door lock system, determines when the lock functions are permitted. The RIM receives and examines the requested lock function from the individual door modules, or from the remote function actuator (RFA) via the class 2 serial data circuit. The RIM also examines the transmission shift selector position and the ignition switch position information available over the Class 2 serial data circuits. If the RIM determines that a lock or unlock function is permitted, it sends a class 2 message back to the individual door modules commanding them to perform that Lock or Unlock function.
Power Door Lock Components
The power door lock system consists of the following components:
?€¢
Driver door lock switch


?€¢
Passenger front door lock switch


?€¢
LH rear door lock switch


?€¢
RH rear door lock switch


?€¢
LH middle door lock switch (w/ V4U)


?€¢
RH middle door lock switch (w/ V4U)


?€¢
Driver door switch assembly (DDSA)


?€¢
Driver door module (DDM)


?€¢
Passenger front door module (PDM)


?€¢
LH rear door module (LRDM)


?€¢
RH rear door module (RRDM)


?€¢
Left middle door module (LMDM) (w/ V4U)


?€¢
Right middle door module (RMDM) (w/ V4U)


?€¢
Driver door lock actuator


?€¢
Passenger front door lock actuator


?€¢
LH rear door lock actuator


?€¢
RH rear door lock actuator


?€¢
LH middle door lock actuator (w/V4U)


?€¢
RH middle door lock actuator (w/ V4U)


?€¢
Driver door cylinder unlock switch


?€¢
Rear integration module (RIM)


?€¢
DRVMDL fuse (10-amp)


?€¢
PASS MDL fuse (10-amp)


?€¢
RRDR MDL fuse (10-amp)


?€¢
Class 2 serial data link

Sep 27, 2016 | 2002 Cadillac Deville

1 Answer

Fuel door won't open on a 2008 g8 pontiac


Fuel Fill Door Description and Operation
The fuel door latch actuator shares the circuit with the driver door latch assembly. The body control module (BCM), upon receipt of a lock switch lock or unlock signal, will switch the appropriate door lock actuator, as well as a fuel filler door release actuator control circuits to battery positive voltage. The opposing side of the door lock and fuel filler door release actuators is connected to ground by the I/P fuse block through the other door lock actuator control circuit and the doors, along with the fuel filler door release, will lock or unlock as commanded.
Circuit/System Testing
  1. Ignition OFF, disconnect the harness connector at the fuel door release actuator.
  2. Test for less than 1 ohm between the control circuit terminal 1 and ground.
  3. ?‡'
    If greater than the specified range, test the control circuit for a short to voltage or an open/high resistance.

  4. Test for less than 1 ohm between the control circuit terminal 2 and ground.
  5. ?‡'
    If greater than the specified range, test the control circuit for a short to voltage or an open/high resistance.

  6. Connect a test lamp between the control circuit terminal 1 and control circuit terminal 2.
  7. Ignition ON, command the doors to LOCK and UNLOCK by using the door lock switch. The test lamp should illuminate while commanding the LOCK and UNLOCK states.
  8. ?‡'
    If the test lamp remains OFF during either command, test either control circuit for a short to ground.

  9. If all circuits test normal, test or replace the fuel door release actuator.
Component Testing
  1. Ignition OFF, disconnect the harness connector at the fuel door release actuator
  2. Install a 15A fused jumper wire between the control terminal 1 and 12V. Momentarily install a jumper wire between the control terminal 2 and ground. The fuel door release actuator should perform the LOCK/UNLOCK function.
  3. ?‡'
    If the function does not perform as specified, replace the fuel door release actuator.

  4. Reverse the jumper wires. The fuel door release actuator should perform the UNLOCK/LOCK function.
?‡'
If the function does not perform as specified, replace the fuel door release actuator.


Remove the rear compartment side trim (right) panel. Refer to
Rear Compartment Side Trim Panel Replacement .

Apr 06, 2016 | Pontiac Cars & Trucks

2 Answers

My trunk won't open. What's wrong


Hi Annette, Im AL the owner of Big As Auto Repair.

Annette, if you are already able to get inside the trunk, remove the lever that goes to the lock actuator because the actuator may be locked up. Then see if it will open. NOTE: If the lock solenoid is mounted to the latch this will not work. If that doesn't help, then see if you can remove the bolts that hold the latch to the trunk and open the trunk that way so you can see better what the problem could be. Keep me posted at my auto-repair-website here: http://www.bigasautorepair.com/

Feb 26, 2015 | 2000 Buick Regal

1 Answer

Saab troubleshoot


The central lock system won't exactly lock the fuel "cap" but it does have an actuator that extends to prevent the fuel door from opening when the doors are locked. Easy to test, as long as that's working then you're lucky enough to not have to bother with a locking gas cap & more keys!
7_17_2014_4_04_29_am.jpg

Jun 29, 2014 | 2008 Saab 9-3

2 Answers

2008 Toyota Camry gas-cap door release is stuck; how do you release it?


Hi fellow,
Your problem has two options ;first, you have to inspect the interior wire that pulls the lock of the gas cap.If found cut you should replace it at the mechanic's. Secondly, once the wire remains uncut or undamaged by any reason, the lock itself might be jammed due to the rust or misuse. Therefore, you are advised to use some anti rust liquid it wil work. Good Luck.

Jun 09, 2014 | 2008 Toyota Camry

1 Answer

The key fab will lock and unlock all doors except the drivers door and the lock botton in the car on the drivers door will not lock or unlock the drivers door either. How do I fix this problem?


sounds like the lock actuator in the driver door has failed, probably have to replace the actuator, but first check the fuses for the locks, chevy has a habit of using a fuse for the drivers door that doesnt power the other doors. If the fuses are ok, then its probably the actuator

Apr 19, 2011 | 2008 Chevrolet Equinox

1 Answer

I clicked on the button to open the gas cap and it won't open. can't get to tank to refuel.


DOES THIS VEHICLE HAVE A POWER GAS CAP OPENER. IF SO THEN THE ACTUATOR WHICH RELEASES THE FUEL DOOR IS NOT WORKING

Jan 27, 2011 | 1998 Lincoln Continental

1 Answer

Door locks not working


check the lock actuators in the doors to see if they are sticking and also check all fuses and relays

Feb 11, 2009 | 1998 Jaguar XJ8L

1 Answer

Gas Cap


There is a lock inside there, but it should only be actuated when you've locked your doors. By pushing the lock button on your key fob it locks your doors, rear hatch and your gas cap cover. Once you push the unlock button the lock inside will retract back allowing you to push on the cover. If you do have your doors unlocked, then it could be either the lock is not retracting as it should or the metal clip that the lock contacts with when in the out position may be bent out of shape and still in contact with the lock when the lock is retracted.

Feb 04, 2009 | 2004 Nissan Murano

1 Answer

Son apparently locked the outer gas tank access cover....I don't know how to release it to allow me to refill the gas tank. Please help.


there should be a leaver by driver seat to release if you mean the fuel door if you mean locking cap then a screewdriver with a little force will remove the cap then you will need to replace with new cap

Dec 09, 2008 | 2000 Porsche Boxster

Not finding what you are looking for?
2004 Audi A4 Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...