Question about 1992 Acura Integra Hatchback

4 Answers

1990 accura Integra won't star. Will turnover but won't start. seems to be totally random sometimes it will go for a long time and not do it sometimes a feww times a day. Could it be the distributor?

Posted by on

  • zane the pan Aug 30, 2008

    my 1990 integra won't start. sometimes it does this, but not this bad, ever. could it be the crankshaft sensor?

×

Ad

4 Answers

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Starter... or main relay they both are what ive been told lucky mine was a started but main relays are know to go bad with hondas

Posted on Sep 23, 2013

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

2 possibilities:
- the relay board under the driver side dash needs resoldering
- the computer has leaky capacitors that have corroded the
traces. The one I replaced was 100uf/35v electrolytic. Its easy to spot because there is a little area around it that looks wet. the corroded trace is on the component side. scrape off the conformal (waterproofing) and solder a thin piece of wire over it. clean all electrolyte off. Also resolder all connectors while in there. If not used to soldering pc boards, take it to any competent electronics tech. ;)

Posted on Sep 03, 2008

Ad

Check relay under the driver's side dash, apparently it's prone to failure when the car is left parked in the sun

Posted on Aug 27, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 232 Answers

CHECK WITH THE MANUFACTURE TO SEE IF THE FACTORY SECURITY SYSTEM HAD A RECALL FOR DEFECTS.THE DISTRIBUTOR IS NOT USUALLY OFF OR ON EITHER IT WORKS OR IT DON'T . U CAN CHECK THE SPARK PLUG WIRES AND SPARK PLUGS FIRST

Posted on Aug 04, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 Acura starts & runs fine but has been stalling out when accelerating after stopping at an intersection.


1) Turn on all electric systems- AC/wipers/radio/lights etc

2) if car stalls randomly at low RPM - Replace the Alternator
These cars are very sensitive to fluctuations in voltage and it will stall.

Aug 06, 2013 | 1990 Acura Integra Hatchback

1 Answer

1998 accura integra ls 1.8 are the valve seats steal or alluminum


Aluminum is way too soft to take the hammering of the valve for any period of time.
Check out this neat page on valve seats.
http://www.aa1car.com/library/ar993.htm

Jul 10, 2010 | 1994 Acura Integra

1 Answer

1994 accura integra how do you replace water pump without replacing timing belt


Hi:
Sorry, but the timing belt must come off to remove the water pump, because that is what spins the water pump.

Common sense says to replace the timing belt and tensioner when the water pump gets changed, and change the waterpump when you change the timing belt...

Apr 30, 2010 | 1994 Acura Integra

2 Answers

I need a wiring diagram for a 1994 accura integra


Visit the autozone.com website and register the car's information. It's free and you will have access to an online repair manual for the car. The wiring diagrams can be found there. ( I checked). Hope this helped and best wishes.

Sep 11, 2009 | 1994 Acura Integra

1 Answer

1990 acura integra ls wont start


bros. check the main fuel pupm relay

Jan 11, 2009 | 1990 Acura Integra Hatchback

1 Answer

Cold ignition


It sounds like it could be the throttle position sensor.

There is a seriously good vidoe on how to test the TPS here:

http://www.wonderhowto.com/how-to-test-replace-cars-throttle-position-sensor-267168/

Sep 03, 2008 | 1997 Acura Integra Type R

1 Answer

I need to replace the power window motor in a 1990 Accura


Ok, I'm assuming you verified that in deed the motor is faulty. You will need to remove the door inner trim panel switches, entry lighting and inner door handle will need to be unplugged/removed there should be a inner weather seal also this seal is important if you would like to keep the inner trim panel from rotting away so carefully remove it. Attached to the window motor is the regulator. The window is directely connected to reg. by two fastening nuts 10 mm. window stops at top of door as well remove. I mark there location when removing this makes adjust alot easier and most times no adjustment needed if marking is right once window is out regulator and motor can be removed I strong suggest that if possible to move the reg. and window motor in full up position to remove motor this is because the reg. has a spring assit to help raising window glass and is under tension to be wary of this fact Three screws attach motor to regulator these screws will in most cases be tight sometimes requiring " Impact Driver Tool" this is a hand used with a ball peen hammer once screws are out reassembliy time If this is your frist time with this type of repair I suggest help of assitant window glass will need to be very carefully handled.. good luck

Jul 14, 2008 | 1990 Acura Integra Hatchback

Not finding what you are looking for?
1992 Acura Integra Hatchback Logo

433 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...