Question about 2005 Suzuki Swift

1 Answer

I've changed the battery in my key fob and the light flashes on the fob but will neither open the car or let me start the car unless I use the key.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

Might need reprogrammed. Is it factory installed if so go see the dealer

Posted on Mar 30, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Battery changed in key fob now will not start


You have lost programming, contact your local dealer.

Jan 18, 2017 | Cars & Trucks

1 Answer

2008 Altima with push button start. Why won't the fob unlock doors?


Insert key into and remove it from ignition more than six times in 10 seconds. When the hazards lights will flash twice insert key into ignition and turn to ACC position.
Then push any button on key fob once, the hazard lights will flash twice. Then open drivers door to END.
Should be all working again.

Jun 06, 2015 | 2008 Nissan Altima

1 Answer

I have a 2007 ES 350. Changed key fob battery,now nothing works. Only immobilizer security light is flashing and engine start stop button has amber colored light on


Be sure to use the correct battery, properly in place, clean the key contacts , See owner's manual for additional information.
There are specialized locksmiths for car keys

Oct 02, 2014 | 2007 Lexus ES 350

1 Answer

My immobilizer does not recognise my key fob


Put key in ignition.
Press unlock button on key fob.
Immobilizer should now recognize it, if it was original fob but car or fob battery was changed or is now low.

Saabs are particular about batteries that are otherwise good, but just below 12 volts.

Mar 29, 2014 | 2005 Saab 9-3 1.8

1 Answer

I changed my car battery, now my 2008 Nissan Altima key fob won't work


There is a special procedure involved in keying your fob to your car once the battery has been changed. You must lock and open the door with your key. Turn the ignition to "on"(not start) then push the fob's open and close button, then shut off ignition. This procedure is done everything the key battery is changed. Hope this can help you!
------------
Motorcycle Diagnostic Scanner

Oct 31, 2012 | Cars & Trucks

1 Answer

My 2005 Cadillac STS has a completely dead battery. Nothing lights up when I pull on the door handle. I just moved and I have no clue where my key is since I've only used the FOB since I've owned...


Raise the car up,support it in the front

Put a battery charger on the battery cable
at the starter and the ground to the sub frame

Charge the battery for a couple hours,then try to
open the door with key fob

May 21, 2011 | Cadillac STS Cars & Trucks

4 Answers

My 2006 cadillac sts key fob all of a sudden is not working it says no fob detected and i have the fob what can b wrong??


Some late model fobs contain electronics beyond the push buttons.
Batteries are replaceable...small screws may let you do this.
If the battery is not the cause....a replacement fob may be expensive. A road service technician can probably troubleshoot and replace cheaper than dealer !

Sep 07, 2010 | 2006 Cadillac STS

2 Answers

Key fob / immobilizer not unlocking door


sounds like the security part of the system went bad
take the key fob to the dealer and have it reflashed
if that fails replace the security computer or you can disconnect it from the car you won't have the system but the hazards won't come on unless you turn them on

Feb 25, 2010 | 1997 Volkswagen Golf

1 Answer

I changed the battery on my 2001 Tiboron and now the factory alarm system will not let me start the car. I do not have a key fob


In order to 'RESET' burgular alarm, you MUST have the remote keless entry fob programmed for the vehicle - no other way unless you want to bypass/disable the burgular alarm relay and alarm horn. This, however, does not disable the 'flashers' when the alarm is activated. Bypassing the relay will allow you to start the engine, but you'll be driving around with your parking lights flashing.

Sep 06, 2009 | Hyundai Tiburon Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

290 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...