Question about 1991 Buick Skylark

1 Answer

Speedomiter my speedomiter is spoatic it will work for a while then stop then start again on it own. can you tell me what I can do to fix it myself.

Posted by on

  • fotodawg98 Mar 22, 2009

    Did you replace the spedometer cluster? It did not say in the answer.


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

I had same problem with a 1990 skylark form what I have seen on the net this is problem with the older skylarks. I got one from a junk yard for $45. It was easy to put in. I could have sent the old one out to be fixed but I was told $250-$300. Hope this helps

Posted on Mar 09, 2009

  • greenie812 Feb 04, 2010

    sorry i never got back till now but yes i replaced the complete cluster very easy and is still woking


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1993 dode ram 250 speedomiter and horn stop working

short probably in the radio. if it is after market radio there is bare wires some were some radios like kenwood when shorted just need to disconnect the power like your key on/off and it will reset

Nov 01, 2012 | Dodge Cars & Trucks

1 Answer

Speedomiter stops working and transmition gears start blinking

Sounds like the transmission speed sensor.
Its mounted on the side of the transaxle.

Jul 08, 2012 | Cars & Trucks

1 Answer

Finding a 1992 nessan maxima speedomiter sensor on the engin i think if i clean it it might make the speedomiter work agin

could be the speed sensor is the problem, replace if not works after cleaning. and it be found at the top rear of the transmission.

Apr 07, 2011 | 1992 Nissan Maxima

1 Answer

My speedomiter quit working. Does my truck have a electronic or cable hookup?

All you have to do is look at the transmission in order to tell.
A cable will be thick and straight, while an electronic unit will use a thin, flexible, wire.

Aug 07, 2010 | 1994 Nissan Pickup

1 Answer

1997 monte carlo speedometer stops working and also shifts hard when the speedomiter stops working

the speed sensor is located near the passenger axle ck the wiring first for damage then replace speed sensor.

Jul 31, 2010 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

Gges and speedomiter stopped working how do i fix it

check ur fuses under the hood first - get a cheap test light from walmart - about 5 dollars - - test every single fuse with the key on ----
then - take down the vin number - call the dealer and ask about recalls

Dec 27, 2009 | 1995 Honda Accord

1 Answer

I have the same exact front blower not blowing issue on a dodge caravan 2005. also is there a reset switch for the electrical brain(system) if so, where would i find it???re the blower, the rear one works...

There is no single reset switch for the electical system.
There may be a indivdual circuit breaker resetable fuse for your blower system.
If you can tell if a fuse is bad try swaping fuses with similar amp rating with others.Most little fuses you can tell by holding in a light to see the single wire inside has a gap in it--blown.

Nov 27, 2009 | 2000 Dodge Caravan

1 Answer

Now speedomiter in my truck.

in a 1998 it should be electronic. if it's a fuse. it is either in the power distribution center in front of the brake master cylinder or in the driver side of the dashboard at the drivers door opening. but my honest guess is the electronic speed sensor on the transmission. go to a auto parts store and they can tell you exactly where it's located.

May 27, 2009 | 1998 Chevrolet K1500

1 Answer

Cruise control stop working can someone tell me how to fix myself

If all the brake lights are out it is likely your stop lamp switch is bad, it controls lights and cruse, and also supplies input to ecm/tcm. The old ones would just pop apart, you can put them back together but to replace the switch it is only 20-30 bucks. Try that.

May 26, 2009 | 2000 Hyundai Sonata

Not finding what you are looking for?
1991 Buick Skylark Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

71338 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7018 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides