Question about 2003 BMW 325

1 Answer

On my x5 2001, i have filled my coolant and the warning light comes on when start and stop the engine. how can i get rid of this as the coolant is fine.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,871 Answers

Hello! The coolant level sensor is defective...See photo below...Cost is under $10...Guru..Saailer...



on my x5 2001, i - saailer_151.jpg?RO PARTS Part # 17137524812

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Posted on Mar 28, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a ford five hundred 2005 changed the thermostat and have air in the system how do i get it out ?


NOTE: The addition of Cooling System Stop Leak Pellets, darkens Motorcraft Premium Gold Engine Coolant from yellow to golden tan.
  1. Fill the degas bottle with the correct engine coolant mixture to the degas bottle seam line.
  1. Install the pressure relief cap.
  1. Remove the retaining clip and the fill tab on the top of the thermostat housing and fill through the thermostat housing until full.
  1. Install the fill tab and retaining clip.
  1. Select the maximum heater temperature and blower motor speed settings. Position the control to discharge air from the A/C vents in the instrument panel.
  1. Start the engine and allow it to idle until engine reaches normal operating temperature. While the engine is idling, feel for hot air from the A/C vents.
  1. CAUTION: If the air discharge remains cool and the engine coolant temperature gauge does not move or the low coolant light comes on, the engine coolant level is low in the engine and must be filled. Stop the engine, allow it to cool and fill the cooling system.Run the engine at 3,000 rpm for 10 minutes. Hot air should discharge from the A/C vents. The engine coolant temperature gauge should maintain a stabilized reading in the middle of the normal range, and the upper radiator hose should feel hot to the touch.
    • Shut the engine off and allow it to cool.
    • Check the engine for coolant leaks.
    • Check the engine coolant level in the degas bottle and fill to the seam line.

May 15, 2018 | Ford Cars & Trucks

1 Answer

I have a 99 Cavalier with a coolant warning light on. I have filled the coolant and the light is still coming on. Any suggestions?


On a cold engine did you check the coolant level in both the reservoir and radiator? If so, most radiators have a coolant level switch, that switch could be causing you a problem? Mounted to the radiator, two wire connector.

Jul 02, 2017 | Cars & Trucks

1 Answer

How to bleed air from cooling system after refitting bottom hose


Raise the front of the car as high as possible off the ground, this allows the air to migrate to the top radiator. Fill the coolant recovery tank all the way up, then run the engine until it reaches the normal zone on gage, do not overheat, Turn off the engine and let it stand, the coolant will be pulled from the recovery tank and the air expelled.

Jul 14, 2016 | Cars & Trucks

1 Answer

PROBLEM WITH WARNING LIGHTS BEFORE IGNITION ON C5


most likely yes..when starting..each time it does a self diagnostic..once started if all the lights go out.. and it runs fine.. drive it..

Jan 05, 2014 | Citroen C5 Cars & Trucks

1 Answer

My coolant warning light has come on????


coolant sensor going bad, more then likely located on the radiator or near the thermostat housing.

Jan 15, 2013 | 2006 Audi A3

3 Answers

Where to add coolant for radiator on a 95 vw jetta?


Add Coolant to spherical reservoir at right rear of engine compartment as viewed from front. If it is low the coolant gauge flashing light will warn you of a low condition.

Jan 01, 2010 | 1995 Volkswagen Jetta

1 Answer

Low coolant warning light stays on.


Bad coolant level sensor in the tank. Look around the bottom of the reservoir and find a plug connection, unplug it and see if the light goes out. I think the tank has to be replaced dont think you get the sensor out. You could try by take the tank off and see if it will come out of tank but I dont think it will.

Sep 03, 2009 | 1994 Chevrolet Camaro

1 Answer

Coolant disapearing


maybe ur correct it goes to the exhaust.

1. open the radiator cap, with coolant full observe when starting the engine. If the coolant comes out on the radiator it indicate there is a crack in the cylinder head.

2. Check engine oil if it is not deluted with the coolant (oil color changes), if deluted the cylinder gasket has cuts/cracks.

If this indication/observation is present, you need to have ur engine overhaul (semi-overhauling)

Apr 05, 2009 | 2002 Dodge Caravan

Not finding what you are looking for?
2003 BMW 325 Logo

221 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Anthony Jones
Anthony Jones

Level 2 Expert

128 Answers

Chris Bowser

Level 1 Expert

18 Answers

Nyte_Ryder

Level 2 Expert

102 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...