Question about 1995 Toyota Camry

1 Answer

1995 camry 6 cyl misfires and runs rough at low speeds but travels like a jet in higher speeds, the back three coil packs misfire doesnt matter if you switch the coils around...had a new gas tank installed could it be an injector problem?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 160 Answers

Most likely fuel /demands more on higher speeds and too much at idle have seen few ecu problems however in this case i would check injectors first let me know and please rate this info

Posted on Mar 28, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What are the probable causes of recurrent DTC P0302?


Check the compression on the cylinder. Compare it to specs and to the other cylinders. If the compression is too low, it can cause misfiring. Low compression could be due to piston ring wear, cylinder wall wear, or improper valve seating.

Feb 14, 2016 | 1998 Volvo V90

1 Answer

Both coils do not fire on 1 and 4. Will start but only running on 2 cylinders. Could both coils be bad or should I look elsewhere?


Part 3 -How to Test the Ignition Module and Crank Sensor ...

easyautodiagnostics.com > Ford > 2.3L
Mar 1, 2012 - Spark plugs for cylinders #2 and #3 get spark at the exact same time. ...voltage -12 Volts) to both individual ignition coils within the coil pack. ... Ford Mustang or Ranger (or 2.3L Mazda B2300), this is what you'll need ... for this 'Switching Signal' at the coil pack... but you can also test this ... 1991, 1992, 1993.

How to Diagnose a Misfiring Cylinder (2.3L Ford Ranger ...

troubleshootmyvehicle.com > Ford > 2.3L
Apr 3, 2012 - Bad Fuel Injectors can cause a Misfire Condition. ... the ignition system on the 2.3L Ford Mustang or Ranger consists of 2 ignition coil packs, ...

2002 ranger misfire rough idle - Discussion on Topix

www.topix.com > Ford Ranger
Jul 27, 2007 - My truck is giving the code misfire in number 4 cyl. I replaced my spark plugs, Wires, Coil packs (both of them) and all my fuil ... three (3.0L v6) go bad, the fuel/air mixture gets messed up. Judged: 2. 2 ... My truck runs rough only at idle. ...code for ford ranger 2002, 2.3 5speed. truck runs like a champ but that ...

Extremely stumped! I need the best and brightest 1994 Ford ...

answers.edmunds.com > Edmunds Answers

Jan 31, 2016 | Cars & Trucks

1 Answer

What causes engine misfires to stay after new plugs and coil packs?


Try swapping the coil packs around - like swap #1 with #2, and swap #6 with #5, see if the misfires MOVE with the coil packs swapped to the new cylinders or if they stay with the cylinders. If they move with the coil packs, the new coil packs are bad. If they stay with the cylinders, there's a problem with those cylinders. You DID replace that camshaft sensor, right?

Have you checked your #1 and #6 injectors?

Aug 07, 2014 | BMW 528i Cars & Trucks

1 Answer

Feels like miss firing at higher speeds


Your caption says misfires at high, then you say low? You have a 95. Lots of miles I assume. So there are several things that would cause misfires at high and low. First is timing chain/belt, sloppy. Second, would be the valves and rings. Valves worn or bent, not seating right. rings just worn out, not holding compression. Do a compression test and see. Low speed or idle misfires can be from vacuum leaks. check hoses. Low and high rpm misfires can be from ignition problems. Wiring, coil/s, ignition modules.

Apr 04, 2014 | 1995 Chevrolet Tahoe

1 Answer

2002 saturn vue cylinder 1,3,5 misfiring when swapped coil pack it went away now cyl 2,6 misfiring.


having PO 304 = Misfire cylinder 4,PO 306 = Misfire cylinder 6, as I read above you have done the most. The thing that you have missed is to check whether the Catalytic Converter is faulty or not. To get an idea check whether you have a smell like rotten eggs at the end of the exhaust,you start having problems with cat and needs replacement. My advice before you go for a cat replacement is good to visit an MOT center and check your emissions and then you decide,

Aug 10, 2012 | Kia Rio Cars & Trucks

1 Answer

Po300 code multi cyl misfire any sugg


The code you got may not have indicated the correct coil, that was bad

I would put the old coil back in #6 & either walk the new coil to another cylinder, or get professonal help in the form of a scan tool in Mode $06,
if applicable on your vehicle & check for misfires that why

Forget the PO300

Jul 30, 2012 | 2004 Chevrolet TrailBlazer

2 Answers

Misfires. I have a 1998 Camry 2.2 with 200K miles. The


Hi, my first recommendation would be to take the plugs out and visually inspect each one and check to make sure they are properly gapped, if they look fouled at all i would replace them without hesitation. try throwing a set of NGK plugs in the car to fix the misfires. other than that you may want to look at the wires. good luck joe

May 22, 2010 | 1998 Toyota Camry

1 Answer

Intermitent rough idle & slight miss at low speeds


Trying to solve same problem on my 1994 ford Taurus. So as I see it just need to rethink what we did wrong to begin with and we could have put one of the wires on wrong (in wrong placement) or bad conection.

Sep 14, 2009 | 2001 Toyota Camry

Not finding what you are looking for?
1995 Toyota Camry Logo

Related Topics:

351 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...