Question about 1999 Dodge Intrepid
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
the water pump is timing chain driven and to replace it requires serious disassembly of the engine. it is a 13 + hour job and is not for the casual mechanic
Posted on Apr 13, 2009
if you don t see any spark plug wires then your motor has coil packs(black colored boxwith 2 small electrical wires) located on top of motor 3 on one side,3 on the other.disconnect negative terminal on battery,then disconnect wire connector at each coil pack and remove 2 screws that hold down coil pack, pull gently straight up and plug is right there below coil pack
Posted on Jul 04, 2008
SOURCE: Dodge Intrepid 1998
p1684 means the battery has lost power or been disconnected.u have nothing to do if your me machine refuse to light over. sounds like possibly a cam sensor or possibly a theft key issue.
have you checked for spark?
i suggest for the first step to get a starting cable and to see if start
Posted on Jul 28, 2008
Hi. I have put together a guide to help you with this replacement of the thermostat.
Step1 Raise your DodgeIntrepid with a jack and lower onto jack stands, or use wheel ramps.Disconnect the negative cable from the battery. Open the drain plug atthe bottom of the radiator and drain the coolant into a suitablecontainer. Reuse the coolant if relatively new and clean. Step2Follow the upper radiator hose to the thermostat housing in all enginetypes except the 2.7L. In Intrepids with 2.7L engines, follow the lowerradiator hose to the thermostat housing. Loosen the hose clamp at theend of the radiator hose with a screwdriver and pull the hose off thethermostat housing. Step3Unbolt the two bolts holding the thermostat housing cover on and pulloff the cover. In 2.7L Intrepid engines, it is easier to gain access tothe thermostat housing behind the alternator by working from beneath the engine. Step4Note the position of the old thermostat and remove. Install the newthermostat with the spring-side facing into the engine. Clean any oldgasket residue from inside the thermostat housing cover. Install thenew thermostat gasket. Step5Reinstall the thermostat housing cover and tighten bolts to 105inch/pounds. Reattach the radiator hose and tighten the hose clamp.Refill the radiator with reserve or new coolant. Reattach the negativebattery cable. Step6 Start your DodgeIntrepid and allow it to run with the heater on high until it reachesnormal operating temperature. Check radiator hose for leaks and tightenthe hose clamp to stop any leaks, if necessary.
Posted on Mar 26, 2009
Tips for a great answer:
Jun 21, 2011 | 1998 Dodge Intrepid
Dec 04, 2010 | 1998 Dodge Intrepid
Sep 25, 2010 | 1998 Dodge Intrepid
Jan 24, 2010 | 1998 Dodge Intrepid
Aug 29, 2009 | 1999 Dodge Intrepid
Jul 13, 2009 | 1998 Dodge Intrepid
Jul 22, 2008 | 1998 Dodge Intrepid
Jul 21, 2017 | 1999 Dodge Intrepid
134 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: