Question about 1995 Nissan Altima

2 Answers

What is the best brand of starter to get for a 1995 Nissan Altima? Do I go with a higher priced remanufactured Bosch brand or the new lower priced Delco?

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 176 Answers

Both are good reputable brands... I would go with the cheaper one unless the Bosch has a much better warranty.

Posted on Mar 28, 2011

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 90 Answers

The higher priced starters are not any more reliable than the cheapest, don't let the boys down at the autoparts store make a fool of you.
They try and trick you with names like super premium platinum plus, but there is almost always no difference when it comes to parts which fulfill a particular function. There are different types of certain components (like spark plugs or tires), but with something like a starter or alternator or waterpump, you'll find the cheapest one to be just as good.

Posted on Mar 28, 2011

  • TXTEXAN Mar 28, 2011

    The Bosch rebuilt are built to a higher quality control level than those done by the no-names rebuilt ones that offer lifetime warranty.

    I would say the new AC Delco ones are as well.

    I used to peddle off the cheap rebuilt ones because I could put more money in labor in my pocket at the end of the day, but after a while when some vehicles with these cheap parts would come back time and time again because the part is junk.... who pays for that labor the second and third time? Their warranty wont, so it's down to the customer and shop owner to battle it out.

    You get what you pay for in many cases, you just also have to know where to shop.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change a starter


The starter motor on the Nissan Altima is located on the front of the engine and can be changed from the top of the engine compartment. Here's a link for the process: http://www.ehow.com/how_5822553_change-starter-nissan-altima.html#page=3

Sep 20, 2013 | 1995 Nissan Altima

1 Answer

I have a 1995 nissan altima GXE and it sputters


You are dealing with a ignition misfire,This can be from coil spark seeking ground,to a sparkplug cable seeking ground.

Mar 03, 2012 | 1995 Nissan Altima

2 Answers

1995 nissan altima starters bad how hard 2 replace


Not really easy.
It's under intake manifold , you need a lift.

May 25, 2010 | 1995 Nissan Altima

1 Answer

Howm do I replace a starter on a 1995 Nissan


Nissan 240SX/Altima 1993-1998 Repair Guide

Altima
(see Figures 1, 2 and 3)


ef972ea.jpg
Fig. 1: The starter is located to the left of the oil filter housing on the engine block


dfca7b3.jpg
Fig. 2: The starter motor is removed from the bottom side of the engine compartment


04c206e.jpg
Fig. 3: When installing, be sure to align the starter's mounting bolt holes with those in the engine block
  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle safely.
  3. Remove the starter support bracket, as required.
  4. Label and disconnect the starter electrical harness.
  5. Support the starter from beneath the vehicle using a jackstand.
  6. Remove the starter mounting bolts.
  7. Carefully lower the starter from the vehicle.
To install:
  1. Position the starter on the engine and support it using a jackstand.
  2. Install the starter mounting bolts and tighten to 30-37 ft. lbs. (40-50 Nm).
  3. Connect the starter electrical harness.
  4. Install the starter support bracket, as required.
  5. Lower the vehicle.
  6. Connect the negative battery cable.

Hope helped with this (remember rated this help) Good luck.

Nov 27, 2009 | 1995 Nissan Altima

1 Answer

How to change the starter of my Nissan Altima


Thats a simple on...

Disconnect battery

Take wires off starter

Take bolts out of starter holding it to block.

Pull starter out.

Reverse to reinstall new starter.

Nov 13, 2009 | 1995 Nissan Altima

2 Answers

2002 altima...was clicking no start..hit the starter and it finally started so i replaved the starter..now there is no clicking and it wont start..i9 am thinking i got a bad stater i had bought


Did you doublecheck all your connections for wiring? Battery connections and also is the area where starter goes into block clean and free of oil or grease. Alot of times the starter is grounded to the engine that way. It's possible, not probable that if you got a remanufactured starter, they don't always work as well as a new one. It's the old "you get what you pay for" kinda thing. Good luck.

Jul 01, 2009 | 2002 Nissan Altima

2 Answers

02 Grand Cherokee, 4.7l need new starter, quoted at $448 for parts and labor sound right??


I show the following for the part:
BOSCH Part # SR6423X moreinfo.gif {Remanufactured Starter) $150.00 US at Rockauto.com, so the price u where quoted is way high, get the part yourself, if the shop does it they double the cost of the part and pass it on to u, standard pratice in all shop's.

Mar 11, 2009 | 2002 Jeep Grand Cherokee

1 Answer

1998 Nissan Altima


If the starter/solenoid is new/replaced, most likely the cable from the battery to the solenoid needs replacing or the connection ends saned and cleaned for a good electrical contact, Also chek the gound wire connections (if any)

Aug 23, 2008 | 1998 Nissan Altima

1 Answer

Nissan Altima 98


The starter solenoid (must buy complete starter) -or-
The cable from the battery to the solenoid needs replacing or the connections need cleaning
If you are handy, the starter can be rmoved without too much work and exchanged for a rebuilt/remanufactured one

Aug 23, 2008 | 1998 Nissan Altima

1 Answer

1998 Nissian Altima Not starting


Nothing by either party was said about the starter. The battery and wires can all be in great shape, and if they are and the owner hears a clicking noise when trying to start it its a pretty good bet they may have a starter that's locked up.


One good 'ole trick on those starters. If you can reach the starter, a couple of sharp rapes with a hammer will have it starting again, then you know it time to replace the starter.
Bill

Aug 23, 2008 | 1998 Nissan Altima

Not finding what you are looking for?
1995 Nissan Altima Logo

Related Topics:

162 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...