Question about 1990 Plymouth Sundance

1 Answer

How do you put transmission fluid in a 1990 plymouth sundance 5 speed

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

The fill plug is on the left side of transaxle look for a black rubber plug pop it out use a suction gun to fill it up

Posted on Mar 28, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What causes temp gage on my 1990 Plymouth Sundance to flucate


loose connection on the temp sender unit, broken wire to temp sender unit
low coolant level in the system/ air lock

Dec 11, 2016 | 1990 Plymouth Sundance

1 Answer

I cant get spark on my 1990 plymouth sundance. I tried replacing the ignition coil, i put a new pick up point and cap too. any thoughts?


Please make sure that the trigger required for the coil to give out the High voltage to spark comes from the pulsating voltage at the coil LT( low tension).
So check for the make /break on the coil- on one side you will need the positive and on the other the trigger. Once this is seen then the distribution can be checked, check the HT wires and contacts in the distributor.

Jun 21, 2011 | 1990 Plymouth Sundance

1 Answer

I have a 1989 Plymouth Sundance. ALL OF A SUDDEN NO REVERSE. fLUID IS FINE!


This can be the transmission mode switch (on the side of the trans), or worn clutches or bands. There can also be trash in the valve body or a stuck solenoid. Your best bet is to bring it to a transmission shop for the free diagnosis. Good luck!

Thanks for the vote.

Dec 22, 2010 | 1989 Plymouth Sundance

1 Answer

My car is loosing fluid between the engine and the transmission what could it be?


If the fluid is red it is your front transmission seal, if it is black it is your rear main bearing seal in the engine.

May 11, 2010 | 1990 Plymouth Sundance

1 Answer

How do we fix a signal flasher on a 1990 plymouth sundance?


If not in fuse panel area under dash on drivers side near hood pull cable, then check behind glove box.

Jan 29, 2010 | 1990 Plymouth Sundance

1 Answer

Where do I put transmission fluid into my 1990 plymouth acclaim?


Add the fluid directly into the transnission dip stick tube,drivers side below the battery.

Dec 03, 2009 | 1990 Plymouth Acclaim

Not finding what you are looking for?
1990 Plymouth Sundance Logo

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...