Question about 2003 Ford Escape

1 Answer


Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    Visited the website for 3 consecutive days.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 50 Answers

You will have to remove the engine cosmetic cover. The 2.0 four cylinder has 1 and the 3.0 V6 has two The 2.0 is a standard single coil pack and will be clearly visible when you take the cover off, just follow the wires and remove the spark plug boots and voila. The V6 uses 6 coil packs and you will have to unscrew their bolts and remove each of them to get at the spark plug underneath them. Make sure you blow away any debris, from around the plugs before taking them out. hope this helps

Posted on Mar 28, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2003 ford escape have changed egr sensor, fuel pump and filter and plugs but will turn over but won't crank

Do you have spark, the right fuel pressure, are the injectors firing? Scan the ecm for any codes for electronic problems.

Jul 17, 2017 | 2003 Ford Escape

1 Answer

Ford escape wont accelerate and jerks into gear

try checking fireing order of spark plugs sounds like some wires may be on the wrong plugs if this was helpful please give me a good review

Feb 23, 2013 | 2003 Ford Escape

1 Answer

2003 ford escape run sometimes but when it wont start their no spark

best have vechicle code scan could have faulty crankshaft position sensor or camshaft position sensor.could have fault PCM.replace spark plugs and wires see what happens.

Feb 11, 2013 | 2003 Ford Escape

1 Answer

My 2003 escape sometimes starts and when it doesn't it acts like it's running out of gas. i reset the fuel cut off switch but it didn't fix my problem

Have you tried changing the fuel filter? It may be clogged up. You may have a leak in the line or bad fuel injectors. The best way to tell if it is fuel related is by checking the fuel pressure. If that checks out, it may be a vaccum leak, the air filter, or a low spark in the ignition system. You could need a tune-up, spark plugs/coils, wires, distributor cap, rotor, Check the fuel first and let me know if you have any questions. I will help you the best I can.

Feb 18, 2011 | 2003 Ford Escape

2 Answers

Where are the spark plugs?


They are right next to the oil filler cap on either the 4 cylinder or the V-6. The ignition coils are on top of them is why they can't be seen.
The connectors and the coils need to be removed before you can take the spark plug out.
A very easy task,isn't it.
Wish you the best..

Aug 10, 2010 | 2005 Ford Escape

1 Answer

My 2003 Escape has a history P0351 and P0301. This vehicle is also surging at times, at idle or around 40mph. I've changed the affected coil and intake gaskets. Spark Plugs recently replaced. Any...

I had the same problem and replaced the spark plugs, and also the tubes that run from the coils to the spark plugs. there is a spring inside the tubes that was brooken and that fixed the problem.

Aug 24, 2009 | 2003 Ford Escape

1 Answer

2003 Ford Escape is running rough and has no power

try changing spark plugs, fuel filter, air filter.

Jun 28, 2009 | 2003 Ford Escape

1 Answer

Need to replace a/c belt and also the spark plugs

plugs located on the cylinder head look for 4 large round wires on front side of engine.plugs are connect to wires. plug gaps is .040 for the 2.5 engine .041 for the 2.0 engine.

Apr 08, 2009 | 2003 Chevrolet Tracker

1 Answer

03 ford escape v6 find & change spark plugs

i also have a ford escape. the other three plugs are under the upper intake manifold. You have to remove this to change them takes about an hour in a half if you have some experiance working on cars

Dec 10, 2008 | 2003 Ford Escape

Not finding what you are looking for?
2003 Ford Escape Logo

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides