Question about 2002 Chevrolet TrailBlazer

1 Answer

Electrical Issue. Car not turning over. Charged the battery still won't turn over, all the accs work. Also key locks in, takes like 10 min to get out. I checked all the fuses and they are good. Is this an alarm issue? Alarm is stock.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 414 Answers

Have the battery checked, if it has a flat cell you may experience bizarre problems
like my mothers lincoln did (radio problems, security system problems, etc.) I would
also check the ground connections to the block and the chassis (I often clean and file
the block before reattaching grounds). Also check under the rubber boots on the
positive for corrosion (which happened on my 04 S-10 and caused a similar condition).
Hope this is useful.

Posted on Mar 27, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 oldsmobile sihouette I disconnected negative battery post for ten min then put back then I parked van now when I go to start it securety lock is on and I can't start car and it reads cal...


you have to do that cycle 3 times,battery needs to fully charged.
Hood to stay closed,doors also(roll down the drivers window)
Kill the DRL headlights if possible(try putting the E-brake on)
Crank and leave key on,10 min or till light goes out,then key off,,no need to wait 5 min here,crank again.leave key on,,,,,3 times.
By the way,disconnecting the battery in that vehicle will not do anything like clear codes or memory,may need the radio code in the owners manual also.

Jan 07, 2014 | Cars & Trucks

1 Answer

Ford focus 2000 died and wouldnt restart for 10-15 mins after wards


It shouldn't matter if the key is the original or not it has been programmed to the car immobiliser, have you changed the batteries in the key, a low battery can cause the key and immobiliser not to communicate, did you take it to a ford garage, Main dealers are always the best to deal with especially when ECU and immobilisers are involved, there may even be a software update for your car that addresses this issue, may even need a new key but they are expensive, don't buy off eBay they won't work, hope this helps

Dec 09, 2013 | 2000 Ford Focus

1 Answer

I have a 2001 chevy malibu. It will not crank nor turn over. Its not the battery I just replaced it. The theft light does not stay on (it goes off when all the other light go off). I have tried turning the...


I think i know the issue. I have had it happen to me it is your security system failing. Your car is on the list year make and model... I found a module that you can install yourself and it will bypass it allowing your car to start everytime.. Check it out and ask questions they are very helpful. Also for some reason if it does not work they will refund you %100 of your money.. this literally saved my car. Hope it helps
http://vatspasslockpasskeysecurityhelp.com/ Do It Yourself GM Security bypass

May 09, 2017 | 2001 Chevrolet Malibu

1 Answer

I don't know which it is


Your info is limited but when you say the "alternator" tries to turn I can only assume the engine is cranking. If it is and not starting check the security light on the instrument cluster.. If its blinking put the key to acc and leave it for 10 min or until the light stops blinking. Turn the key off then start it. This is a common passlock issue.

Aug 07, 2012 | 2003 Oldsmobile Alero

1 Answer

I just had my brakes changed on my 2006 passat. Now the electronic parking break sensor won't stop beeping but everything works. How can I get the fault to go away so It will stop beeping


also if u take battery off for 10 mins, hook battery back up again, turn car on, hold in break paddle for 35 seconds, then still holding in break paddle hold in handbrake button for 10 seconds, release all and start car up, press break button a few times, turn car off again take out key, lock and open car then press break button again and now all should b back to normal

Mar 27, 2012 | 2006 Volkswagen Passat

1 Answer

2007 jeep liberty suddenly won't start after


Try starting in neutral. Gear sensor may be heating up and not registering park.

Mar 03, 2012 | 2007 Jeep Liberty Sport

2 Answers

I replaced my battery on my 2008 Hyndai Sonata. My clock and dome lights and alarm does not work. My door locks only work with key on. My key chain lock does not work. My computer resets when key comes...


try this there is a manufactuer alarm that should set off when u put the key in and turn.. do that one more time(BUT makng sure alrm goes off then do it again) then dont take the key out turn offthen set it in the acc. postion in the ignition after the alarm goes off then wait about 5 to 10 min and turn on by then it should have reprogramed and kick on..the third time is when you should be waiting for the programming to be down...its very very important that you do the programming on the third time

Sep 12, 2010 | Hyundai Sonata Cars & Trucks

2 Answers

My 1996 Pontiac Sunfire wont crank...


tryy replacing the fule injectors and the fuel pump could possibly be shot as well. you have a fuel problem.

May 07, 2009 | 1996 Pontiac Sunfire

1 Answer

Keyless entry keylob want lock or unlock doors or trunk.change battery and checked all fuses.


You need to program the remote. Get in to the car and LOCK all doors with the switch on drivers side door. Take the key and insert it into the ignition cylinder in and out 6-10 times, until the flashers/hazards flash on your dash board. Or just keep putting the key in and out (nice and easy now, not fast) until you see the lights on dash flash. After the lights flash, turn the key into ACC mode to make the whole dash light up.(do not start car) .With the key in ACC position, hit any button on remote, that will make the hazards flash again. Turn key off and unlock door with switch again. Open door.DONE.
Good luck.

Jul 15, 2008 | 2001 Nissan Altima

Not finding what you are looking for?
2002 Chevrolet TrailBlazer Logo

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...