Question about 2001 Ford Taurus

1 Answer

Vibration when accelerating when you let off gas it stops already replaced tires and ball joints and alignment

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 53 Answers

Might want to check your motor and transmission mounts.. do this by turning the car on holding the brake and shifting the car into Reverse... with the brake pedal still pressed, try reving up your motor a few times and feel for a thunk noise do the same thing in drive.

Posted on Mar 27, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

When accelerating at 55mph, I start to get front end vibration. It happens in all gears. Goes away when I take foot off gas.


Sounds like wheel balance, check front wheels for loss of weights outter and inner rim, alloy wheels have sticky weights steel rims have clamp on weights either can be lost....say if you clip the kerb/sidewalk or just through centrifugal force. A garage will check wheel balance and attach weights if needed.

Oct 06, 2015 | Cars & Trucks

1 Answer

Steerling wheel vibration and shake plus abs light


bad tire, gad wheel bearings , loose steering tie rod ball joints , wheel alignment
take it to a front end specialist for a full inspection

Sep 10, 2017 | 2001 Ford Taurus

2 Answers

I have a 1994 chevey exstended cab 4 wheel drive it has a vibration in front it seems kije uts there when i accelerate then it kinda goes away but then when i brake and slow down it vibrates worst


sounds like you have a warpped brake rotor, bad ball joint, or a bad tire. I would recommed taking the truck to a tire shop and have them shake down the front end that will tell you if its a tire or ball joint

Mar 01, 2011 | 1999 Chevrolet Silverado 1500

2 Answers

Inside tire is so wear already


Have the front end steering linkage check out, and have an alignment done.

Aug 11, 2010 | Honda Civic Cars & Trucks

2 Answers

2005 Chevy Equinox - Front End Trouble


Likely whatever causes the noise also caused the problem with your tires. Have a competent shop or tech check your ball joints and c/v axle joints. It could be a bad hub bearing as well but usually they make more noise at lower speeds.
After you determine what is actually wrong and fix it, it is a good idea to have it aligned. Unless the alignment caster is severely "off" it should not cause any shaking. Caster is pretty munch non-adjustable on your car and will never cause a noise though. Ball joints if worn can cause the tires to "splay" out at the bottom causing uneven tire wear.
I'm leaning towards ball joints but without the advantage of being there to examine it, no one can say for sure.

May 01, 2010 | 2005 Chevrolet Equinox

1 Answer

Vibrates when gas pedal pressed.


1. Check the ball-joint.

2. Check the Tye-rods.

3. Your shock absorbers/ struts.

4. Wheel balancing and alignment.

Good luck.

Dec 14, 2009 | 2000 Chevrolet Silverado 1500

1 Answer

Winding noise and vibration when driving on front right tire


you could have more than one problem the vibration accelrating maybe an inner cv joint ,if you just had the tires replace and an aligment done they should have checked the front end for worn out ball joint and tierods but the wheel bearing may not have any movment but can still make noise

Jul 13, 2009 | 2003 Kia Sedona

2 Answers

Front end vibration


on both my Camrys, i had this problem. You could really notice it when you were driving down the road going 40-60 mph and punch the gas - car would vibrate, let off the gas - vibration stops, punch the gas - car vibrates...... On both, it was the CV joints. It is much easier to just replace the drive axles (with the new cv joints and boots already installed). For my last replacement, i think thy were only around $65 each.

Mar 30, 2009 | 1998 Toyota Camry

1 Answer

2002 land rover discovery vibration


could be the steering damper.... need more info like, steering vibration or the whole car shake?

Nov 25, 2008 | 2002 Land Rover Discovery Series II

Not finding what you are looking for?
2001 Ford Taurus Logo

451 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...