Question about Jeep Grand Cherokee

1 Answer

Water in gas, car wont start,, if i put in a water remover in my gas tank , will the car then start,,

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,702 Answers

It depends on how mush water is in the tank, best guess is no if there is enough water that the engine will not start than i douht that by just adding a water separator that it will start, sounds like you need to drain the fuel tank.

Posted on Mar 27, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Run out of gas and put some watery gas in the tank, it cut off 3mins later


Just plain silly. Remove gas tank, drain and dry. Replace fuel filter. Fill gas tank with 5 gallons of fresh gas. Add a bottle of water remover to tank then start and drive. Good luck.

Aug 21, 2013 | Toyota Cars & Trucks

1 Answer

Ran out of fuel put some fuel in gas tank but still wont start


Try removing fuel filter, empty it and clean, try again, sometimes loose particals from bottom of tank may be picked up when ran dry

Jan 28, 2013 | 1991 Ford F150

1 Answer

1994 chevy k1500....has run in three years... wont start....need suggestions


lying for three years your compression is probably down
yes i would drain make sure no water in gas tank

Oct 19, 2012 | 1994 Chevrolet K1500

2 Answers

My daughters rodeo wouldnt start. Battery is brand new, sounded like it wasnt getting gas. Fuel filter was just black, it has been changed. Truck still wont start. Any ideas?


check the tank is it plastic... if so drop the tank pour gas in bucket if black stuff in the gas take a water hose and spray it out wait till dry put it back on and put gas and try to start it,,, if fuel pump in tank replace it... please let me know how it turns out,,, good luck

Jan 28, 2012 | 1995 Isuzu Rodeo

1 Answer

I ran out of gas and i put gas in it and now it wont start i thought it might have froze but i have it in garage with heater now it starts but i have 2 pedal it 2 keep it running then it dies and wont...


If it ran out of gas, there are two possible easy fixes. One is that the fuel filter is plugged up by junk from the bottom of the tank. The other is that water floats on top of gas and now your lines are a mix of fuel and water. I would change the filter and put water remover in the tank. Make sure there is a least 10 gallons of fresh fuel in the truck. If neither of these work, the pump may have been damaged as it uses the fuel to keep it cool.

Feb 23, 2011 | 2001 Ford Explorer Sport Trac

1 Answer

Water in gas tank


I would get some fresh gas, about 2 gallons in the tank, a couple cans of dry gas, to soak up the water, and get that thing fired up and drive it till it is empty. Then put in some fresh gas, and another can of dry gas, by then , you should have a nice clean engine and a clean tank. If you have to pull the air horn off and squirt some fuel into the throttle, do it, just to get it going. Once it starts, don't let it quit if you can help it, keep revving it and drive it. It will sput and cough bu it should be ok. The fuel pump should be fine and the filter will clean itself out of the water. Hope this helps.

Jul 03, 2010 | 2005 Chevrolet Malibu

2 Answers

I may have put water in the gas tank what should I do? i used two bottles of water evaporator already and it still wont start. Do I need to do major work now?


you will have to try and drain it out, if there is no drain plug, remove fuel tank, water evaporator will only deal with small amounts of moisture, you will also need a new fuel filter and drain the carb(unless it is injected) and the water can corrode the injectors after time

Apr 05, 2010 | 1997 Chevrolet Blazer

1 Answer

Car wont start after running out of gas


Try a new fuel filter. you most likely sucked up some junk or maybe water from the tank when it ran out. Check fuel pump make sure it runs.

Feb 04, 2009 | 2001 Pontiac Grand Am SE

1 Answer

Car wont start...


water in the gas. Have tank & lines drained. Add HEET to the tank to remove any residual water.

Dec 26, 2008 | 2004 Chevrolet Aveo

1 Answer

Gassed up and now wont run unless at 2k rpms or higher


I would suspect water in the gas...check with nappa they sell an aditive to disolve the water..other than that the tank will have to be drained. Gas floats on water,so the water if there is any will be sitting in the bottom of the tank, you could remove the filler pipe and push a hose in and pump the bottom of the tank, with an external pump.

Dec 25, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...