Question about 2007 Chrysler Sebring Sedan

1 Answer

I have a Chrysler Sebring V6. I have changed the oil every 3,000 miles, but I am continually adding oil when I get gas. I have changed the PCV valve, but it has not made a difference. Is this something that can be diagnosed by my dealer with coverage under my extended warranty?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,050 Answers

You can try and get this covered under your extended, but from what I've heard, it will be difficult. Bottom line, you need an engine. There were a lot of problems with these engines and oil sludge. Some people have reported that switching to synthetic oil has helped reduce oil burning and sludge build up around the piston rings which is what causes this problem.

Posted on Mar 27, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How often should the oil be changed

Rule of thumb is every 3,000 miles for conventional oil longer if synthetic oil is used. Also some cars have a warning light that will indicate when the vehicle requires an oil change. Do not forget to check the oil often though if oil leaks exist.

Feb 16, 2013 | 2003 Chrysler Sebring

1 Answer

Why my oil light turns on every time i make a sto and the oil is fine?

Hello marco.... To reset the oil light do this. Turn on the key but do not start the engine. Pump the gas pedal hard three times in succession. Then turn the key fully on and start the engine. This will reset the oil light. It will come back on in about 3,000 miles as a reminder to change the oil. Joe

Thanks for choosing FIxya!

Jan 12, 2011 | 2004 Chrysler Sebring

1 Answer

What type of oil do u use 4 a 2004 chryslet seabring platium limited. V6

I use Castrol GTX 10w30 in all my cars all year long. I live in So. Calif. I've got a '92 Ford Ranger 3.0L V6 with 114,000 miles and hav'nt had a single problem with it yet. change every 3K-5K miles with a new filter every other time, Fram Extra Guard.

Dec 12, 2010 | 2004 Chrysler Sebring

2 Answers

How often should I change my oil on a 2004 sebring?

highway driving every 5,000 mules, stop and go every 3,000 miles

Sep 12, 2010 | 2004 Chrysler Sebring

1 Answer

Oil not lasting to next oil change. I have the oil changed every 3,000 miles at the dealership where I bought the car. For the last two years I have been forced to add oil before the 3,000 maintenance oil...

adding a little oil between changes is not unusual, depends on how much, are you checking your oil yourself ?? if not start !! check it in the morning once a week, if its near the full mark refuse anyone telling you to add, ( there are some stations that pay their employees more to sell oil) on the safe side put in a new pcv valve, its onle a couple of bucks

May 19, 2010 | 2000 Dodge Intrepid

1 Answer

Oil sending unit on 2004 chrysler sebring V6

Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove

Jan 03, 2010 | 2004 Chrysler Sebring

1 Answer

Check engine light on, car RPM stays at 1000 even at a stop, spark plugs jsut replaced when issue started. Vibrating when stopped or accelerating, added dry gas and then added fuel injection cleaner. 2.4L...

One of the easiest and cheapest ways to know for sure, or at least a good idea of where problem is, would be to stop at one of the big autoparts stores and ask for free diagnostic code scan. They will usually do it free, and if that doesn't point you in right direction, get back to us with those codes that were retrieved, and we will gladly help you out.

Dec 29, 2009 | 2007 Chrysler Sebring Sedan

1 Answer

Whats the best oil for sebring 2.7 rebuilt motor

Best oil you can use would be any synthetic oil 5W-30. But if your like me and most mechanic, any good 5W-30 brand of oil and filter will do as long as you do the regular service intervals. Every 3,000 miles.
Your going to need 4.7 liters of oil to fill the engine with a oil filter changed. Good luck and keep me posted, be glad to answer anymore questions you may have.

Oct 29, 2009 | 2001 Chrysler Sebring

3 Answers

Engine knocking and oil lampe illuminated during idle

Change oil and filter. Use a synthetic blend oil, add 1/2 pint of marvel mystery oil, and drive for a short time, 30 minutes or so. If knock continues, the damage is already happened. Use only synthetic blend or synthetic oil in the 2.7 litre engine.

Jul 09, 2008 | 2002 Chrysler Sebring

Not finding what you are looking for?
2007 Chrysler Sebring Sedan Logo

Related Topics:

260 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

80668 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides