Question about 2008 GMC Acadia

1 Answer

What makes guages on dash quit - 2008 GMC Acadia

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 339 Answers

{: ) It depends. For example, if you can trigger the problem by driving on rough roads, or by simply bumping your hands around the cluster area, it's possible the wirings or connectors are at fault.
It can also be the cluster itself. But there is also a GM bulletin to reprogram the IPC in cases like this. A software issue that needs an updated calibration.

Posted on Jun 22, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Lumina troubleshooting


Ignition switch. This will cause all those problems. Turn it off, the gauges go blank/dead. Leave the lights on and remove the key, what happens..

Sep 07, 2014 | Chevrolet Lumina Cars & Trucks

1 Answer

2000 acura tl coolant fan after fluid change


New thermostat, installed, saw, new coolant made a little mess filling reservoir, (normal) checked fan fuse for some reason, and condenser fan fuse (xxx ?:), and temp guage, is slightly lower on gauge (than normal?) (disconnected xxxx? quit? a bit? to get to thermosta?.t no dash warning lights have a feeling I popped a relay.

Answer:

ok, you did a coolant service with STAT,

and it failed.

tell us what works right and wrong, symptoms only.

over heating? parked, (fan never comes on)? as it hits 225F?

under heating? ( fan stuck on , up North can cause huge cold engine)

dash gauge stuck low. (thermostat wrong heat range 180f is best. see FSM for spec. on this temp. spec..

Dash guage varies.? oddly (air in system)?

Dash gauge too high.? (Stat put in upside-down or bleed hole (jiggle) not UP side. higher side of mount , trapping air.)

Does something wrong happen only driving?

leaks?

does cap on rad hold 12-14psi pressure, hot.?

if car has fan belts, are they tight? (for sure water pump does)

Nov 19, 2013 | 1994 Honda Civic

1 Answer

Fuel guage not working


Could be the gauge on the dash, or the sending unit in the tank, or the wiring between the two components.

Jan 22, 2013 | Cars & Trucks

1 Answer

2007 F350 4x4 regular cab V10 gas guage quit working I had the sending unit and fuel pump changed the fuel guage went to 1/4 and sat there. Any tips? Fuel guage wont work.


I'm assuming this has dual tanks, do you know if it is not working on both tanks ?
Most people would check the circuit for the gauge at the tank. The sending unit grounds the gauge on the dash.

Aug 31, 2012 | 2007 Ford F-350 Super Duty XLT

2 Answers

Lights or fuse for my speed odemeter guage and heater/air conditioning system


These lights for the dash are controlled by a rheostat instrument control dimmer switch next to the main light switch for the headlights, it is either turned off (have seen this dozens of times) or it is defective. Below is a picture of the switch assembly I speak of. The thumb wheel next to the knob is the dimmer control.



2_13_2012_9_00_33_pm.jpg

Feb 13, 2012 | 2000 GMC Yukon XL

1 Answer

What causes the guages to quit working?


look for bad fuse on fuse block, sometimes under "guages" or "dash"
Look for broken ground wire

Dec 18, 2011 | 1997 Pontiac Grand Am

1 Answer

My temperature guage for my 1991 ford t-bird in the dash has quit working. When I turn on the key and start the car, the guage goes the opposite direction that it's suppost to. Can you help me?


you will find the temperature sender unit going to gauge is faulty
will be located somewhere near top of engine on cylinder head or thermostat housing check wire going to it make sure its not earthed or grounded in any way

Sep 23, 2011 | Ford Thunderbird Cars & Trucks

1 Answer

Dash guages quit working. Gas, temp, tach and


Try disconnecting battery for couple minutes and see if it starts working again I have done that in the past

Aug 05, 2009 | 2000 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...