Question about 2004 Suzuki Verona

1 Answer

Dash board lights show two codes . one is the ABS which i can figure out , but the other is a DRL code which i have no idea about. I was unable to find a chilton manual . also the car idles between 2000 & 2400 rpm's and if gas peddle is held at 3000 rpm's it will cut out every 2 seconds . I just got this car at auction I hope I don.t get beat up in repairs

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Daytime Running Lights (DRL)

Posted on Apr 09, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 ford f150 supercrew lariat. Odometer is all dashes. All lights headlight tail lights park lights are all on even with switch off and keys out. Horn won't blow. Engine will turn over but not crank.


Engine will turn over but not crank.???? Engine cranks but won't start an run .
Odometer
The instrument cluster receives odometer rolling count status from the PCM and stores the mileage in non-volatile memory (NVM). When the instrument cluster fails to receive the odometer rolling count status for more than two seconds, the odometer display will show dashes.

B2143 Odometer NVM Memory Failure Instrument Cluster INSTALL a new instrument cluster. REFER to Instrument Cluster in this section. CLEAR the DTCs. REPEAT the self-test.
Taking the vehicle an having it checked for DTC'S - diagnostic trouble codes would be a good idea ! Not to autozone or advance etc... Need a professional or factory scanner to check for these codes .
  • The headlamps are on continuously
  • Headlamp switch.
  • Circuitry.
  • Multifunction switch.
  • Daytime running lamp (DRL) relay No. 2 (if equipped).
  • DRL jumper (if equipped).
  • Headlamp relay (if equipped).
  • Remote anti-theft personality (RAP) module (if equipped).
  • Central security module (if equipped)
  • Light sensor amplifier (if equipped).
  • GO to Pinpoint Test F .

Feb 20, 2018 | Ford Cars & Trucks

1 Answer

Chevy Venture Van 2007 air bag light coming on dash board while driving


That means there is a fault in the airbag system. Every time you start the vehicle it will do a self check. If the self check fails the light will stay on.

You will need a higher end scan tool to pull codes from the airbag module. Once you know what codes are present you will have a better idea of what direction to head into.

Post the codes in the comments below and I'll do my best to help you figure it out.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Feb 27, 2015 | 2007 Chevrolet Venture

1 Answer

I have my service engine soon light that comes on and off periodically while driving. I have 3 codes that come up 1DTC U1040 Loss of Class 2 Communications with ABS 2)DTC U1088 Loss of Communications with...


Codes that light check engine lamp are emissions/engine performance related only. Your DRL and SDM both talk to the ECM for inputs (they need to know if its running), but they dont affect the engine or tell the engine module to change how it runs.
Your ABS can affect how the engine runs as it sends wheel speed information that is used to adjust engine output, transmission shifting, and fuel/timing in some circumstances.
Check the ABS module for signs of water or oil affecting it, or water in the connector plug. Also check the harness where it leaves the module to make sure it isnt rubbing thru anywhere you can see.

GM ABS modules are not uncommon failure items, however mostly they set module fault codes or motor amperage/function codes. Id start with further diagnostics of the ABS.

NOTE: using generic OBD2 scan mode will show you only codes that are check engine lamp related if you want to be sure. Enhanced scan mode shows you any and all, and some of them simply have nothing to do with the engine lamp being on.

Jan 04, 2018 | 2001 Chevrolet Malibu

1 Answer

Drl light on dash board


The DRL light is for the daytime running lights. Maybe you have a short in the wiring, or a bulb is going bad.

Jun 27, 2012 | 2002 Acura MDX

1 Answer

All dash warning lights come on and the temperature and tach needles drop to zero when the headlights are turned on.


Symptoms point to the cluster microprocessor. How was it proven? See diagram below.

c3933a0e-96fc-4737-982a-4d5825950ff8.gif

Jun 16, 2017 | 1997 Pontiac Sunfire

2 Answers

Abs light showing on dash board


Whenever abs light is on there could be a minor or severe damage to the wheel sensor..
Please check the wheel sensor to rectify the problem..
Thank you for using fixya..
Please rate me on fixya to continue my further assistance..

Jan 12, 2011 | Ford Focus Cars & Trucks

2 Answers

What is the DRL warning light on the dashboard of my 2007 Honda CRV?


On my 2007 Honda CR-V The DRL code appeared on the dash board. Additionally I had only one high beam (on the passenger side); both low beams were fine, but I did not have a Daytime Running Light on the drivers side. The DRL code was really misleading because the real problem was that the high beam element in the headlight bulb was burned out. Note that the daytime running light is not a seperate bulb -- it is the high beam element which is powered at a low voltage. Once I replaced the head light bulb everything worked fine and the DRL code on the dash board was gone. So if the DRL message appears what you really need to do is replace the headlight bulb (there are YouTube videos which show how to do this - but search for headlight replacement, not for DRL fix). Be careful not to touch the new bulb with you hands since premature burnout can occur from the grease off your skin. I got my bulb from Wal-Mart for $8.88 (it's a 9003/HB2 for the 2007 CR-V) -- that's a pretty cheap fix.

Feb 27, 2010 | 2007 Honda CR-V

1 Answer

Dash board parking brake and ABS lights stay


you have an abs fault. have your abs system scanned for codes.

your base brakes will continue to function normally

Apr 13, 2009 | 2002 Chevrolet Suburban 2500

1 Answer

1998 Firebird dash light and running lights...


There is a module under the dash that controls the Daytime Running lights or DRL. It might have something to do with it. You can find some more info here:http://www.chrisnovoa.com/166_camarofirebird-drl-module-color-codes

Also all that lighting goes thru the headlight switch. Try unplugging it and putting the fuse in. If it still blows its probably the module.

Jan 01, 2009 | 1998 Pontiac Firebird

Not finding what you are looking for?
2004 Suzuki Verona Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

80668 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...