Question about 1992 Saab 900

1 Answer

900i 1992 int engine lamp on and int cuts out, fault code 22491,

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 78 Answers

Hi 22491 is a unknown code is this correct

Posted on Jun 22, 2009


Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need wiring schematics to troubleshoot some electrical shorts


Way to many diagrams to guess to send. What components are working. Check engine light on?

Nov 01, 2015 | 1992 Buick LeSabre

1 Answer

Find which fuse is for headlights?


I did a Google search for 1992 Dodge Dakota headlight fuse and this is a bit of what I came up with. There is much more. Hope this helps, if you still need it.
25168021-ta24y4oz4j14pbnm2h1xm3d1-2-0.jpg

Oct 01, 2014 | 1992 Dodge Dakota

1 Answer

Fault signal lamp of automobile engine always light,what is matter?my car brand is toyota


The key to read the related information of fault codes and the fault code occurs when the car diagnostic tool records through the diagnostic instrument (usually contain frequency, fault fault, fault speed, speed, temperature, air pressure, the number of kilometers and so on), analysis of the causes of failure by these information. Some fault code does not cause the engine sound changes, such as the vehicle speed sensor fault, oxygen sensor failure etc.. You say are associated with oil or air filter fault may be fuel too thin / thick oil gas path fault, maintenance of this case can be resolved.

Dec 02, 2013 | Cars & Trucks

1 Answer

1994 legend speedometer works once in a while


92 or 94?
is fuse 22 loose?
did the CEL lamp in dash glow at this FAILURE event
or S, D or D4 auto tranny lamps flash? BINGO,

did you look for ECU/PCM errors first.? that be first .
is the odometer dead? too, at same time?
on this car the VSS module (veh.speed sensor)
sends the speed data to 6 other modules. the speedometer is 1.
so of the other 5 are dead, its the VSS dead, if not its a bad speedometer.
on of those modules is the PCM, that runs the EFI engine.
so scan it, on this old car, you insert the diagnostic jumper
(service check conn.)
and read the flash codes from the CEL lamp in the dash.
this will show 17 error, VSS bad. if bad (its bad or bad conn)
easy huh?

log in to alldata.com and read the how to read OBD1 codes
it will be something like this. (photos missing)
When a fault is noted, the ECU (otherwise known as the ECM) stores an identifying code and illuminates the CHECK ENGINE light. The code will remain in memory until cleared; the dashboard warning lamp may not illuminate during the next ignition cycle if the fault is no longer present. Not all faults noted by the ECU will trigger the dashboard warning lamp although the fault code will be set in memory. For this reason, troubleshooting should be based on the presence of stored codes, not the illumination of the warning lamp while the car is operating.
All models are equipped with a service connector in side the cabin of the vehicle. If the service connector is jumped, the CHECK ENGINE lamp will display the stored codes in the same fashion.
The 2-pin service connector is located under the extreme right dashboard on Integra, Legend & 2.5TL; on Vigor models, it is found behind the right side of the center console well under the dashboard.
Codes 1-9 are indicated by a series of short flashes; two-digit codes use a number of long flashes for the first digit followed by the appropriate number of short flashes. For example, Code 43 would be indicated by 4 long flashes followed by 3 short flashes. Codes are separated by a longer pause between transaxles. The position of the codes during output can be helpful in diagnostic work. Multiple codes transmitted in isolated order indicate unique occurrences; a display of showing 1-1-1-pause-9-9-9 indicates two problems or problems occurring at different times. An alternating display, such as 1-9-1-9-1, indicates simultaneous occurrences of the faults.
When counting flashes to determine codes, a code not valid for the vehicle may be found. In this case, first recount the flashes to confirm an accurate count. If necessary, turn the ignition switch OFF, then recycle the system and begin the count again. If the Code is not valid for the vehicle, the ECU must be replaced.
and this warning
On vehicles with automatic transaxles, the S, D or D4 lamp may flash with the CHECK ENGINE lamp if certain codes are stored. For Legend this may occur with Codes 6, 7 or 17. On Vigor and Integra it may occur with codes 6, 7 or 13. In addition, the TCS lamp on NSX may flash with codes 3, 5, 6,13,15,16,17, 35 or 36. In all cases, proceed with the diagnosis based on the engine code shown. After repairs, recheck the lamp. If the additional warning lamp is still lit, proceed with diagnosis for that system.

Sep 19, 2013 | 1992 Acura Legend

1 Answer

Runs fine when cold, when it warms up and cuts out and only gets six miles to the gallon. The check engine light comes on but only when the car is moving when it is stopped check engine light shuts off.


Have the fault codes read It could be faulty o2 sensors ---ambient air temp sensors MAF sensors or any number of other faults. The codes will point you in the right direction.

Apr 01, 2013 | 1992 Isuzu Trooper

1 Answer

How do I disengage the ABS in 1992 Chevy Cavalier


Cluster warning lights

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS, MIL, CEL and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System, MIL Malfunction Indicator Lamp, CEL Check Engine Light.

Dec 19, 2012 | 1992 Chevrolet Cavalier

1 Answer

My nissan have 2 fault codes P1110 INT/VTIM CONT-B1 and U1001 CAN COMM CIRCUIT,what the solution for that problem


my car get a problem and engine check lamp was light on. The code name is p1135 b2 problem. Can u help me the way to fix it. My facebook mail is (netsoe.cyrix@gmaik.com) and same gmail too.

Jul 11, 2012 | Cars & Trucks

2 Answers

Where on the 93 Dodge Dakota do I find the spot for the code reader? under hood or engine compartment?


That is an OBD1 System

Your code reader won't work

You need OBD1 capable reader or
the adapter for an older scan tool

The connector is in the engine compartment

If you need to know where, I will look in my
1992 manual as I departed with my Dakota
june last year.

If you get code I will look them up for you
or tell me the problem your having.

I think the connector is hanging near the
A/C expansion valve on pass side

Jun 27, 2011 | 1993 Dodge Dakota

1 Answer

I want to know what is Code 42 in my Isuzu Rodeo 1992 model.


code 42
electronic spark timing circuit fault (c)
fuel cut -off relay malfunction or circuit fault (A)

it could be either one depend on engine size and all so vin#.

Aug 21, 2010 | 1992 Isuzu Rodeo

1 Answer

Airbag light 1992 camry


There is a fault int eh airbag system on one of the sensors or the airbag itself. You need to have this checked by a mechanic as it is possible to trigger the airbag if the test is done incorrectly.

Oct 12, 2009 | 1992 Toyota Camry V6

Not finding what you are looking for?
1992 Saab 900 Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

rgbypoet

Level 2 Expert

161 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...