Question about 1990 Chevrolet S 10 4WD

1 Answer

2002 chevy s-10 blazer. Car stopped at store. Fuel is not getting to engine. Starting fluid will immediatelt start motor but after it burns off it stops. I have changed the fuel pump relay, checked all fuses, changed the fuel pump and the inline filter on the frame. The nre pmp is still not working. Have I missed a sensor or relay? Any help would be appreciated. Thanks

Posted by on

  • 3 more comments 
  • Tesabo1 Sep 06, 2008

    The same thing happened to me. I was driving on the highway and had a sudden loss of power, the engine just went dead. I pulled off the road and tried to start the truck and all it did was crank, no firing! I pulled it home and poured some gas down the air throat and it fired for just a few seconds. I have a code that says it is the Mass Fuel Sensor, but my mechanic friend says a bad Mass Fuel Sensor will cause the engine to run rough and not cause it to die and not run. I plan to disconnect the fuel line after the fuel filter and turn the key on to see if any gas comes out.

  • givenup2 Dec 27, 2008

    truck is not getting fuel changed the fuel pump and still not running can you tell us where the mass fuel sensor is located? what else do we try to get the truck running?

  • Anonymous Mar 18, 2014

    car will not start without pumping the gas pedal. afraid of flooding the engine. is the fuel line shot?

  • Anonymous Mar 31, 2014

    Fuel pump relay getting hot and burning up relay

  • Anonymous Mar 31, 2014

    changed fuel pump and relay and still wont start

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Have you gotten your fuel injectors checked? fuel injectors seem to go bad on later model v6

Posted on Sep 09, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have 1993 cev s 10 blazer will only start wiht starting fluid,i canged modgle control,plugs ,fule filter,wiers .what can i do next


I have 2000 Chevy blazer 4.3 l v6 vortex I had the same problem I would spray starter fluid into the air flirted canester Nd it would start as soon as I stopped spraying the fluid the engine would die first I checked to make sure my gas pump was working in the gas tank second I checked my fuses under the hood and last the fuel pressure so my gas pump was on in the tank fuses were also ok but I had no pressure on the gas line so that ment my gas pump was bad I replaced it after replacing it my blazer fires problems free now

Jun 24, 2012 | 1993 Chevrolet S-10 Blazer

1 Answer

I have a 99 chevy blazer won't start but will turn


You may have a fuel pressure problem or the secuirty system has locked you out for some reason due to a false signal or failed part. Do you have any electronic engine control codes? Is the Security light on in the instrument cluster and fishing when you try to start the truck? To check the fuel issue get a can of spray starting fluid from the auto parts store or any hardware store and spray it into the air intake of the engine while someone cranks the engine, if it starts you may have a defective fuel pump, the pump is located inside the fuel tank, the fuel tank must be removed to access and replace the pump.

Feb 14, 2012 | 2000 Chevrolet Blazer

1 Answer

No start 1996 chevy Blazer


Timing chain. It's probably broke!

Dec 21, 2011 | 1996 Chevrolet Blazer

1 Answer

2000 chevy s10 blazer cranks but won't start????


Check for gas or spark problem on the engine. Check that starting fluid does start the car for a few seconds before dying, indicating a fuel delivery problem, like a fuel pump or circuit to it.

If the car won't start with starting fluid sprayed into the intake, then the ignition system may be at fault, or engine timing.

Dec 12, 2010 | 2000 Chevrolet Blazer

2 Answers

2000 chevy blazer (4.3 engine) has a hard time starting in the


dirty fuel filter or faulty pump....just a guess...

Feb 15, 2010 | 2000 Chevrolet Blazer

2 Answers

2002 chevy blazer won't start


There is a module in the ignition cap that is known to go bad. If it is this part, your truck will almost turn over, but not quite. I would check there first. Once you get it out, one of you local parts stores can test it.

Sep 14, 2009 | 2002 Chevrolet Blazer

4 Answers

2002 chevy Blazer hard starting did change fuel pressure regulator and fuel filter when we spray starting fluid in throttle body it will start.


replace the fuel injectors, that is the likely cause......

to test the injector, take the power clip off the top of the injector, take one wire and ground it to the body of the car, and another form the battery, to the other post on the injector, if you do not hear a pulsing sound coming from the injector it is bad, if you do, then you have a wiring problem.

Nov 26, 2008 | 2002 Chevrolet Blazer

3 Answers

Fuel Pump Relay 2002 Chevy Blazer


It could be your fuel pressure regulator, check this link for details:

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528022b9c4

8e44b4b.jpg That's what it looks like.

Oct 27, 2008 | 2002 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

487 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...