Question about Honda Accord

Open Question

How to change the dome light bulb in a 2007 honda accord

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 78 Answers

SOURCE: 2006 Honda Accord Dome Light

lok real carefull at the lense there will bee two little slots in the lense between the cover and the trim you can use a pockett screw driver or a butter knife and pry open the lense away from the trim it well be a little stuborn but dont worry you wont crack the lense

Posted on Nov 30, 2008

  • 1 Answer

SOURCE: Change Ceiling Light Bulb

See https://techinfo.honda.com/rjanisis/pubs/om/CR0202/CR0202O00285A.pdf
Pry the lens (the white part) from the rear near the two sides with a flat screw driver. Don't pry the ring/edge around it.Take the bulb straight out or pry it out. Press the new bulb in the slot and press the lens back on.

Posted on Jun 28, 2008

  • 15 Answers

SOURCE: 2005 Honda CRV dome light goes out, but not burned out

Without seeing it, I would guess that you have a problem with clean contacts. Especially in cars with smokers, the contacts of something like a fuse or a light bulb can become corroded just enough to stop the light from working. Wiggling it scrapes away the debris and allows for contact. I suggest that you take some steel wool and lightly scrub the contact points on both the light and the fixture. **Be sure to have all the doors closed so you dont short out the steel wool.** If you are concerned with the abrasive nature of the steel wool, a pencil eraser will sometimes work just as well. Either way, it just sounds dirty which is par for any car. Good luck!

Posted on Feb 27, 2009

dr_greg
  • 192 Answers

SOURCE: How to change headlight bulb, '06 Honda Accord drivers side?

remove a few of the clips on the inner fender liner, depending on which bulb u are replaceing(left or right?) turn the wheels in either direction and u will be able to slide ur hand or arm between the liner and fender to gain access to the bulbs and connectors..do not remove the battery .

Posted on Apr 05, 2009

  • 2 Answers

SOURCE: Honda Accord Map Light bulb

the cover is removed straight down, slowly working it with a thin tool or butter knife. WD40 to front and rear edge (there's nothing medial or lateral). The cover has 2 Y clips on each side, one about half way, and one that clips straight off of the hinge post. There are no "tabs". It will eventually unclip straight down. Then can replace with a DE3175 LED bulb (V-LEDs.com)

Posted on Oct 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

191 honda accord dome light not working


check fuses.and pull out dome light element make sure wires are conected

Dec 13, 2012 | 1991 Honda Accord

1 Answer

My battery died after leaving my dome light on overnight. I had AAA jump the vehicle and its working fine, however the ABS and BRAKE light are now on and wont turn off? Could this be related to the battery...


Yes, they can be related. If the PCM, (computer) did not have sufficient voltage it can throw all kinds of lights on. Shouldn't be anything to worry about. As soon as your vehicles PCM goes through a drive circle or two they should go off on there own.

Nov 08, 2012 | 2007 Honda Accord Sedan

2 Answers

How to change ceiling light on Honda accord 2007


  • Hi, I can help.

  • To change your map light follow these steps.
  1. On the switch side of the light you just take a Flathead screwdriver and gently pry off that clear cover.
  2. Then pry the bulb out.
  3. Replace with bulb # DE3175
  4. Pop the cover back into place. Job complete.
  • If you have any comments please feel free to leave them here.
  • Hope this helps and thank you for using fixYa.

Regards, Tony

Sep 02, 2011 | 2007 Honda Accord Sedan

1 Answer

1995 Honda Accord Brake lights not working. Center bulb was burned out. Changed the bulb, now the brake lamp light is on the dashboard and the brakes aren't lighting up


Did u change the bulb w/ the Honda's original BULB? They have a different type BULB in honda, the amperage and the base contact is different from a regular bulb. Hope that helps u out! taah!

Nov 16, 2010 | 1995 Honda Accord

1 Answer

My car is a Honda Civic 2007 model. The dome light


of the switch is working properly ON/OFF/DOORS , and the fuse is good. verify that there is voltage to the bulb. take a test light an dcheck each end of the bulb when it should be on. NO VOLTAGE-=problem between fuse and light. VOLTAGE on both ends of bulb= bad ground, usually there is a screw that may be loose holding the light up, loosen and tighten all screws up there.

Sep 24, 2009 | 2004 Pontiac Vibe

1 Answer

Help changing dome light bulbs in 2005 Accord


This is a real pain, took me forever to find mine... there is a little TINY slot that you can fit a VERY small flat head screwdriver in to pop it off.

Dont worry, the plastic is durable, just try to use a precision screwdriver if you have one and basically pry it open. it really will just Pop off once you get in there

Jun 28, 2009 | 2005 Honda Accord

1 Answer

Replace dome light bulb


insert a flay eyeglass scrwdriver in between the plastic lens and base, pry gently , the lens will pop out... u should see the small sections where to insert the screwdriver to pry off the lens

Mar 28, 2009 | 2004 Honda Accord

1 Answer

Change Ceiling Light Bulb


See https://techinfo.honda.com/rjanisis/pubs/om/CR0202/CR0202O00285A.pdf
Pry the lens (the white part) from the rear near the two sides with a flat screw driver. Don't pry the ring/edge around it.Take the bulb straight out or pry it out. Press the new bulb in the slot and press the lens back on.

Jun 27, 2008 | 2007 Honda Accord Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

347 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...