Question about 1990 Ford Escort
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The "inertia switch" which shuts off fuel to the engine in the event of a collision or jolt on a 1991 through 1996 models, as well as on 1998 coupes, is located in the rear of the vehicle, near the right (passenger's side) strut tower. On sedan and coupe models, open the trunk and remove the right-sided trim panel. On sedan and coupe models, open the trunk and remove the right-side trim panel. On hatchback and wagon models, there may be an access door secured by clips. On some models you may need to remove the lower quarter trim panel on the right side, however it is easier to cut an access hole directly above the switch.
Posted on Dec 04, 2008
If you look at your valve cover its at the back on the right, it comes up and then its an elbow, it comes over the top of the valve cover then down. the PCV valve is either the elbow or the piece in front of the valve cover after the elbow.
Posted on Jul 07, 2009
On board diagnostic (OBD) was designed on vehicles equipped with electronic fuel injection so you can generally retrieve the codes yourself. No need buying a scanner or running to any parts stores to check the engine light. This system is called obd1 and applies to most vehicles made before 1995 for domestics and 1993 on imports.
Ford owners can check their check engine light using the diagnostic connector located at the engine compartment by the fender near the battery. Getting the obd1 codes need a couple of tools: a 4 inch long gage 16 jumper wire and a 12 volt test light. Both tools are hooked up to the diagnostic connector and when the IGNITION KEY is turned on (without starting engine) the codes will begin to flash in the test light, not in the dash panel. If there is no code, you will normally get code 11 or 111. On Fords, there are 2 test modes, the KOEO (key on engine off) and the KOER (key on engine running). Both test modes should be used to get the accurate evaluation of the stored fault codes.
Most of the codes can be erased or cleared by disconnecting the battery negative terminal for 1 minute and reconnect. Just make sure to check your service manual in case you have electronic equipment such as radio or clock that needs reprogramming in which battery disconnection is not recommended. Finally after performing repairs on the culprit code, always go for a road test to confirm if the problem is fixed.
Posted on Nov 02, 2009
Tips for a great answer:
Feb 14, 2017 | Ford Cars & Trucks
May 08, 2016 | Ford Cars & Trucks
Dec 21, 2015 | Ford Cars & Trucks
Dec 31, 2014 | Ford Cars & Trucks
Aug 24, 2012 | 1990 Ford Escort
Sep 13, 2010 | 1990 Ford Escort
Apr 25, 2010 | 1994 Ford Escort
Nov 08, 2009 | 1996 Ford Escort 4 Door
Apr 13, 2009 | 1993 Ford Escort 4 Door
Dec 04, 2008 | 1991 Ford Escort
28 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: