Question about 2005 Jeep Grand Cherokee

2 Answers

Went to crank my Jeep..it started..then 3 seconds later it died..this happend 3 times. Now it wont crank at all. All lights are lighting up..radio, warning lights. My check engine light is on as well as something that looks like the oil light and a solid red blinking light! HELP PLEASE!!

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 26 Answers

Need to replace your battery and like you have a dead cell in your battery.

Posted on Mar 27, 2011

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Sounds like the computer has lost the 4 digit code same as the key code . call the dealer and get him to reprogram control module or there is a conflict with auto starter / alarm

Posted on Mar 27, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 Jeep Liberty- Why won't it roll (if pushed ) in Neutral? Won't start, but dash lights & security works !?


wow cathy 4 post now.
get it jump started, does it start now?
charge the battery to 12.6vdc rested
does it crank now, you mean it wont crank or
cranks robustly but will not start
or cranks and runs for 3 seconds.
is the IMMO light off, it has its own lamp, mine is sold read, no words, no icons, just red. if on, it WILL NEVER RUN.

key on
cranks does it crank.???
if not jumper start it. if IMMO is off.

Aug 28, 2014 | 2006 Jeep Liberty

1 Answer

No lights, cranks but wont start


try with starter cables if that works change your battery

Dec 09, 2013 | 1988 Chevrolet Blazer

1 Answer

Today i notied my wipers were moving quite slow en


Check your alternator and charging system

Jan 05, 2010 | 1991 Jeep Wrangler

1 Answer

98 jeep grand cherokee dies and starts back


replace the crank angle sensor and this should cure your problem

Aug 08, 2009 | 1998 Jeep Cherokee

1 Answer

1999 Jeep Grand Cherokee Died while driving home


check the fuel pump fuse/relay, could be just bad enough to cause an intermittent start/no start. and check fuel pressure,spark and the crank position sensor.

May 27, 2009 | 1999 Jeep Grand Cherokee

3 Answers

96 JEEP Gr Cherokee hesitates, surges, later stalls


You might want to start by replacing the crank sensor first.

Nov 24, 2008 | 1993 Jeep Grand Cherokee

1 Answer

Turns over but wont start


Briannatara:

Some questions to help in the analysis........

You say "it cranked for about 3 seconds and died as if I turned off the key" did it actually start and then die?
Have there been any clues (unusual happenings) recently that might relate to the current problem?

Is there a reason the battery went dead? was something left on? Lights, etc?

How old is the battery?


Loringh

Nov 09, 2008 | 2002 Kia Sedona

3 Answers

2000 jeep cherokee starts then stalls in approx 3 sec 4.0 has new crank sensor


I am going to assume that it will not run even if you push on the accelerator pedal?
Can you install or attach an old timing light to the spark plug wires, turn it one and try to start it. The light should flash with the engine running, but if it shuts off at time of engine die, and the engine is still spinning, you are losing spark, My suggestion is the cranks shaft sensor on bell housing.
Second, install a pressure gage on the test port on the fuel rail and watch it as you start the engine, fuel pressure should not drop as the engine dies, if it does, the pump is not working correctly. There are two modes of power to that pump, one to start and timed, for only a few seconds to prime the system, and one to run continuously. Find the wires going to the pump at the tank. Connect test light to those wires and watch what happens during crank and at stall, You should not have the pump shut off and the engine dies.
If you have spark, and fuel pump working, when did you last change the filter,,but I put that LAST.
It has to be one or the other of these.
Good Luck

Aug 04, 2008 | 2000 Jeep Cherokee

Not finding what you are looking for?
2005 Jeep Grand Cherokee Logo

341 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...