Question about 1996 Plymouth Breeze

1 Answer

My 1996 plymoth breeze is 5 speed and earlier the shifter came loose and its stuck in gear what you think

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 176 Answers

Usually a case of shifter cable breakage. Goodluck

Posted on Mar 27, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the crank shaft sensor located on a 1996 plymoth breeze 2.0 engine


its located on the transmission bell housing where it bolts to the engine on the rear side. it is a 3 wire electrical connection.

Sep 28, 2014 | 1996 Plymouth Breeze

1 Answer

I HAVE A 1996 CHEVY Z-71 JUST HAD ****** REBUILT AND ONLY 1200 MILE ON IT. IT WONT SHIFT OUT OF SECOND WHEN DRIVING THEN I NOTICED THAT THE SHIFTER CABLE WAS POPPED OFF SO I CONNECTED IT BACK BUT ITS...


Speed sensor on the tailshaft of your ****** drivers side , i have a 96 k1500 5.7 it got stuck in second but still had reverse, i hooked it to a diagnostic cpu @ autozone and it was the speed sensor, about $80 and 5min. Good luck

Jul 09, 2012 | 1996 Chevrolet K1500

1 Answer

My starter keep going out in my 96 plymoth breeze.. Why is it doing tat?


Those are junk, buy a Honda, Toyota or a Ford vehicle. Chrysler Products are made to go to the Junk Yard.

Dec 28, 2010 | 1996 Plymouth Breeze

1 Answer

Ihave a 96 breeze 5speed manuel with a 2.0 had a clutch put in new and now it kicks out of 5th when going down the road and it will stall out it runs but it will not move like the clutch is stuck? also...


the cylinder for the clutch is near the brake fluid cylinder and is a smaller container. Whomever did the work needs to check it, they probably did something wrong-the vehicle 'kicking' out of gear sounds like an improperly adjusted shifter linkage.

Dec 23, 2010 | 1996 Plymouth Breeze

1 Answer

I was driving yesterday & it wont go into any gear. It's like its real loose. 5 speed Dodge Neon. Shifter just wiggles around. How can I tighten that or is it something major?


Well check if your gear shifter cable is not broken or off loose. Have somebody wiggles the shifter while you look around the transmission and see whets going in on. Good luck

Dec 11, 2010 | 2000 Dodge Neon

2 Answers

My break lights don't work even after I changed the bulbs. I have a 1996 Plymoth Breeze.


First check the fuse(s). If fuse ok then I would check the brake pedal switch...these often pop off their mount or become misadjusted when under dash work has been done(eg:remote starter installed,stereo,etc..)

Dec 08, 2010 | 1996 Plymouth Breeze

1 Answer

Stuck in gear audi A4 1.9TD 1996


Check the trans gear oil!!!
Also the cables from the shifter to the trans actuate levers on the trans that sometimes stick. Check the levers.

Dec 09, 2009 | 1996 Audi A4

2 Answers

My transmission wont shift, the speedometer quit working at the same time in my 1999 plymoth breeze. It is an automatic transmission.Before the problem happened the transmission gave a **** and the...


Most likely your speed sensors are bad, this causes the transmission to seem like its "stuck" in second gear or in "limp" mode. I can also be your TCM (transmission control module). But from your description, it's most likely the speed sensors located on the top of the transmission. Make sure you replace them with an exact replacement are they are not interchangeable.
Hope this helps.

Nov 22, 2009 | 1999 Plymouth Breeze

3 Answers

Saturn shifter linkage


Check the cable clips at the trans. Sometimes these clips come out and won't shift. Horseshoe clips that hold the cable housing.

Dec 21, 2008 | 2002 Saturn VUE

Not finding what you are looking for?
1996 Plymouth Breeze Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

Marvin
Marvin

Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...