Question about Nissan Titan

1 Answer

Have 04 tittan in shop when went in run great just needed breaks front end and 2 front tires everything worked now all it does is turn over changed battery and plugs wont move off lift now does this have a rollover swith also the service engine light now flashes whiletring to start

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 693 Answers

Ecm works in strang way, might reset your ecm by turning your key to on position then turn on a/c, then remove positive battery cable, wait 30 sec. then turn key off and replace battery cable. hope this helps, good luck.

Posted on Mar 27, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Front wheel wobbles


A bent wheel, a lost wheelweight, loose lugnuts, front end misalignment or any of a dozen other serious problems. Take it to an alignment shop, NOW, before you do need a new tire.

Jan 14, 2014 | 2005 Pontiac Grand Prix

1 Answer

Will bad front ball joints cause excess wear and tear on my front tires?


I vote yes. Any worn component of the front end be it ball joints,tie rods,wheel bearings,even tire balance will adversely affect tire wear.

Jan 22, 2013 | Toyota Cars & Trucks

3 Answers

2004 jeep wrangler X. front tires & steering wheel wobbles at 50 - 60 mph but stops after 60 & below 50 mph. Changed both side shocks, steering stabilizer shock, track bar, sway bar bushings, all 4...


Well the only thing you didn't change were ball joints and if it's four heel drive , the universal joints in the shafts. Since it is a balance problem I would suspect the drive shafts. Although these are uncommon to have a vibration at a certain speed, I wouldn't rule them out. Also the u joints can get stiff, this would cause your problem faster. Check them for a lot of rust at the caps. And just a note alot of front end guys miss the shafts on alignments.

Aug 01, 2011 | Jeep TJ Cars & Trucks

1 Answer

I just had my daughters 2002 searing serviced in the area she goes to school. I had new tires and a front end alignment done for a little over 500.00 all done October 6, and now, maybe 1500 miles later...


yes definably should been taken care of before the alignment was done
u can' t get a accurate alignment done with loose parts up front (ball joints get loose before they break)
and under most circumstances ball joints don't totally fail in a 2 month period of time

Now if your daughter drives on a lot of rough roads or hits a lot of pot holes and ball joint was dry (not greased in long time) (alignment shop should at least greased front end parts if possible some factory and cheap aftermarket ball joints are sealed and u cant grease them) There a slight chance ball joint could failed that soon but i highly doubt it

Now should u go back to shop ?? call them and explian to them what happened and see if they will warranty there work if they will more than likely day u brought in your car they where busy and behind and it just got over looked
if they wont warranty there work i would go some where else they did bad job first time and wouldnt want them doing same again

Far as cost goes that a hard one to tell u cause shops labor rates greatly across the country and even from shop to shop in same towns
for cost i would make a couple calls to few shops and get a ball park figure for your area

Dec 27, 2010 | 2002 Chrysler Sebring

1 Answer

What is required for the 30,000 maintenance


Hi,

#1) Oil and Filter Change.

#2) Transmission Filter & Gasket Also Transmission Flush and new transmission fluid.

#4) Complete Brake Inspection Replace if Needed. Also Flush out Brake System with new Fluid.

#5) Inspect Front End for Worn Parts, Check for Alignment--Inspect Tires .Replace if Nessary otherwise Rotate.

#6) Check Wheel Bearings Front and Rear.or Struts -Shocks-

#7) Check and Flush out Power Steering Fluid. with new Fluid. Change power steering filter if Equiped.

#8) Inspect. ignition System, Replace all replaceable Parts. Or only the Damaged.

#9) Replace wiper Blades w/New

#10) Replace PCV Valve--Air Filters-Fuel Filter-Replace any Breather Elements and Check Vacum Lines for Cracks .Replace if Needed

#11) Inspect Radiator and Heater Hoses .Replace.

#12) Inspect Battery Condition, Check Battery Cables for Corrosion -Replace if needed.

#13) Remove and replace Spark Plugs.Cap & Rotor.

#14) Replace Spark Plug Wires,

#15) Check all Lights ,replace Bad lights.Interior and Exterior.

#16) Check Rear End/Diferrential if Equipted.Change out Oil (90) Wt.

#17) Replace Drive Belt (Serpitine) or Drive Bels.

This is what i recommend to reduce Uneccessary Break Downs,And Yhis is A Excellent Preventive Maintence.

By running through this list and replacing the neccesary parts. will also save in Future Everything gets more Expensive as the Days Pass.

Hope i've given what you needed.Please let me Know by Voting for the Quality of My Solutions and a Testamony would be Greatly Appreciated.

Thanks From ==d_hubbs

Oct 05, 2010 | 2007 Chevrolet Avalanche LTZ

2 Answers

I OWN A 2004 FORD F250 4-2.WHEN I BRAKE AT ANY SPEED THE FRONT END SHAKE VERY BAD . YOU DONT FEEL ANY THING IN THE BRAKE PEDDLE.THE STEERING IS FINE .REPLACED ROTORS ,INTER AND OUTER BEARING,NEW BRAKE...


the struts in the front are broke this is what keeps your truck off the tire its sits inside the spring and if they break this will mess with the way it brakes and turns :) hope this helps

Mar 24, 2010 | 2004 Ford F250

2 Answers

My front tires are showing wear, and they toe out when in reverse


Be sure to have tires rotated every 5000-6000-miles. Walmart is good for that.
Outside wear is normal for fronts from the turns at higher speeds.
When tierod ends were replaced it is advisable to get front end aligned. Its not impossible to replace with minimum change but if settings were done with worn parts, new parts will change it.

Aug 18, 2009 | 1997 Mercury Grand Marquis

2 Answers

Audi A8L '04 - tire pressure system problem


The system has to be reset from the MMI under tire pressure monitoring using th changewheel option

Feb 16, 2009 | 2004 Audi A8

1 Answer

1996 Acura Integra LS


need to replace the strut

Sep 09, 2008 | 1996 Acura Integra GS-R

2 Answers

Car wobbles


yes make sure your lug nuts are all tight and the wheels are seated properly on the hubs, if they are tight bring the car to a tire shop and have them balance the two front tires, this will tell you if you have a bent wheel please rate -jeff

Sep 05, 2008 | 1988 Toyota Corolla 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...