Question about 1993 Mazda MX-3

1 Answer

Will a transmission form a 6 cylender motor same car fit my 4 cylender their both standard

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 176 Answers

No because the bolt pattern on the 6 cylinder is much different, as well as the shaft splines.

Posted on Mar 27, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will a transmission from a 1990 F150 289 motor work with a 1996 F150 inline 6 300 motor?


if its look the same then it will work ,dont worry about gear ratios and all the technical stuff so long as the electronic stuff lines up away you go and it dont fit then make it fit

Nov 29, 2013 | 1982 Ford F 150

1 Answer

What is considered bank 2 on the nissa frontier?


it depends if it is a 4 or 6 cylender, if its a 4 cylender bank 2 would be the oxygen sensor closest to the converter. if its a v6 bank 2 is usually the passengers side.. is it bank 2 sensor 1, or?? they code them in a few different ways so its hard to explain... but on a 4 cylender bank 1 is cosest to the engine, and bank 2 is closest to the cadalatic converter..

Dec 03, 2010 | 2005 Nissan Frontier

2 Answers

I have a 2000 Mercury Cougar, I need help determining what kind of transmission I have..Any one know how you find that out, plus, where is the transmission range sensor located..


If it is the original transmission, you can contact the Mercury dealer (parts dept) with the V.I.N. # and they can pull it up on the computer

Oct 07, 2010 | 2000 Mercury Cougar

2 Answers

Will a 87 ford ranger v6 4 wheel drive trans. fit in a 86 ford ranger 4 cyl 4 wheel drive


If automatic transmission wont work engine block's are not the same, if stander transmission you could swap out bell housing held on with four bolt's from one to the other. Good luck and hope this was very helpful.

May 19, 2010 | 1986 Ford Ranger 2WD

1 Answer

1995 Dodge ram 1500 V-8 5.9 litre 4x4 short bed is feels like it is bumping when the truck shifts into cruising gear and RPMs drop truck smmoths out when you speed up bumping goes away if you shift...


Perform compression check between cylenders #1 and #3. These are right next to each other.
You might get away with a head gasket replacement, if the compression between these cylenders is the same, indicating a blown head gasket between cyl.#1 and #3 not valves which will give different readins between these cylenders.

Nov 29, 2009 | 1996 Dodge Ram 1500 Club Cab

2 Answers

Cylender order for spark plug wires


5.0L HO Firing Order: 1-3-7-2-6-5-4-8
4.6L Firing Order: 1-3-7-2-6-5-4-8
3.8L Firing Order: 1-4-2-5-3-6
2.3L Firing Order: 1-3-4-2

If you need a diagram, follwo this link...
http://www.moddedmustangs.com/reference/firing-orders.php

Nov 18, 2009 | 2006 Ford Mustang

1 Answer

Leal misfire 2 4 6 cylender code


recheck the firing order of the motor and compare it to the order you have the plug wires in.

Robert

Sep 18, 2008 | 2001 Hyundai XG300

2 Answers

I have 6 that runs on 4


Do a balance test on the injectors. Unplug the injectors one by one. You'll be able to remove an injector plug and nothing will change with the way it runs. That particular one is having the problem. Replace that injector. You may have 2 bad.

Aug 17, 2008 | 1993 Oldsmobile Cutlass Supreme

1 Answer

Cylender


Hi,

Depends on whether your Tribute has the 4cylinder or a V-6.

4 cylinder - standing at front of vehicle, #4 would be right most;
V-6 standing at front of vehicle, #4 would be left most on the bank closest to front.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Jul 07, 2008 | 2001 Mazda Tribute

Not finding what you are looking for?
1993 Mazda MX-3 Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...