Question about Ford Windstar

1 Answer

I need to replace the transmission on my 1996 Ford Winstar minivan. The car is front wheel drive. Can i please have instructions on how to do so? Ive been told it is the same transmission as a Ford Taurus

Posted by on

1 Answer

Have a Trans Repair Shop do that job

Any transaxle job, is not for the home driveway
Really need a lift

Posted on Mar 26, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 ford winstar. When I drive long distance. A light on my dash that says O/D OFF STARTS FLASHING. CAN ANY ONE HELP PLEASE?


You have an internal transmission problem . you need to scan the PCM to pull the code and pinpoint what is causing the transmission to set the light.

Aug 01, 2015 | Ford Cars & Trucks

1 Answer

Ford ranger 4wd i have a 1996 ford ranger


Go to a junk yard and obtain a 1966 Ford Ranger transmission. Remove the old unit and do an exchange.

Aug 04, 2013 | Cars & Trucks

2 Answers

My Ford winstar 98 is having OD light on. Same time while I'm driving this car is slipping. I took it to trasmission specialist who took reading and out of 9 codes 5 is transmission related, but...


Try to replace the sensor yourself. Its accessable throgh the left front wheelwell, next to the axle. It is a 8mm or 10mm bolt holding the sensor in. Good luck. Turbine Shaft Speed (TSS) Sensor Removal and Installation
  1. Disconnect battery ground cable (14301) and positive battery cable. Refer to Section 14-01.
  1. Raise and suitably support vehicle on hoist. Refer to Section 00-02.
  1. Remove LH front tire and wheel assembly.
  1. Disconnect turbine shaft speed (TSS) sensor electrical connector.
  1. Remove one bolt and TSS from transaxle.
  1. To install, reverse Removal procedure. Tighten TSS retaining bolt to 9-12 Nm (80-106 lb-in).

  2. ddll111_36.gif

Mar 10, 2011 | 1998 Ford Windstar

1 Answer

Hi, I own Toyota Emina Estima TD permanent


There may be more to it.. Transmission- P.T.O(Front wheels)-Rear Differential(Rear wheels). Or may have Transmission-Transfercase drives front differential(Front wheels) and rear differential(Rear wheels). So if one was rebuilt there should still be another that is still the root of the problem. Find out what exactly was rebuilt.

Apr 19, 2010 | 1996 Toyota Previa

1 Answer

How do you remove the steering wheel to a 1996 ford windstar minivan?? I bought my van which is a old postal vehicle. After owning it a couple of weeks the horn stopped working. I replaced the fuses and...


horn is only to be used to attrack attention of nice looking woman ,if the driver in front is asleep at the traffic lights or on the mobile and doesnt move off ten seconds before they change ,or attracting the attention of someone on the top floor of apartment building so you do not have to get out of vehicle and ring bell.-----right airbag removal ,disconnect battery then look under the steering wheel for air bag fitting retainer ,two types one is a sprung lever that has to be moved to one side and the other is a small bolt head with either a 8mm headaed bolt or a star drive .

Mar 05, 2010 | 1996 Ford Windstar

2 Answers

Where is the reset switch for a 2003 ford winstar minivan computer after a wreck?


Fuel pump cut out switch. One of the back quarter panels(ford likes the left). Same kind of place the jack hides in most minivans. Typically little black box with little red button.

Sep 18, 2009 | 2003 Ford Windstar

1 Answer

Will a 1996 auto trans fit a 1999 winstar


call local junk yard those guys know the answer

Mar 26, 2009 | 1999 Ford Windstar

1 Answer

Rear brake drum 1996 Ford winstar 3.8L


relase your hand brake also loose the brake adjustment to get gap between the darum and shoes.

Oct 19, 2008 | 1996 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...