Question about Nissan Rogue
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Ford Front wheel bearings do have a torque spec. It is all over the new part to torque to MFR spec or damage will occur.
I have no idea what that spec is though.
Posted on Nov 07, 2009
Hub bolts are around 65-70 foot pounds, axle nut is about 120-130 ft pounds. These are not super-critical. Many at shops are installed using air guns and work just fine. Your main objective is to not have them come loose. If axle nut has a cotter pin, never back off on nut to install. always tighten to get holes for pin aligned.
Posted on Sep 15, 2009
To adjust wheel bearing torque. Tighten the nut fully until the wheel wont turn then unscrew slightly until the wheel turns freely. Replace the locking plate and its set.
Posted on Nov 17, 2009
i read your report. It 155 to 210 foot lbs. I recommend start off your lowest settings. I wouldn't any higher then 195 foot lbs. hope this info helps you.TY you for writing to fix ya.
Best Regards Richard
Posted on Dec 03, 2009
Tips for a great answer:
Mar 23, 2014 | 2004 Dodge Ram 3500 Truck
Mar 03, 2014 | Nissan Pickup Cars & Trucks
Mar 14, 2013 | 2006 Chevrolet Equinox LT
Dec 13, 2012 | Nissan Altima Cars & Trucks
Mar 17, 2012 | 2004 Mazda 6
Sep 10, 2011 | Nissan Altima Cars & Trucks
Oct 11, 2009 | 2002 Ford Mustang
1,329 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: