Need to remove drivers side door panel to replace side veiw mirror

If its the windshield mirror, gm usually uses a phillips or torx head screw to tighten the mirror to the base, which is glued to the glass with a special adhesive. If the screw is tight and it's the mirror joints that are loose, replace the mirror. If it's the door mirror, the inner trim on the door needs to be removed to tighten the mounting bolts. If the outside foldaway joint is loose, you will probably need to replace the complete mirror.

Did you remove the trim around the door handle. There is a bolt there that needs to be removed. There may be one where the side rear veiw mirror is.

you may be able to remove the mirror inner trim panel (small triangular shaped trim piece above door trim panel)
to access the mirror mount.
If not then you will have to remove the trim panel for access to the back side of the mirror

remove door panel.. there should be access hole to get to the bolts.

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. Then you'll need to remove the cover just beside the mirror and you should be able to get to the cables

how do i replace the side mirror on 94 acura integra

Remove the sail panel,the little panel on inside of door at the mirror.
Remove the window regulator switch plate, pry up on the front of it with a small pick or screw driver. Disconnect the electrical connectors.
Remove the top door trim panel screw that is behind the sail panel you removed.
Remove door trim panel screw at window regulator switch plate opening.
Remove door trim panel screw in the courtesy lamp housing. Remove the courtesy lamp lens.Remove the screw.
Remove the inside door handle trim cover.
Remove the bolt.
Remove the inside door handle.
Lift upward to remove the front door trim panel.
Remove the courtesy lamp.
Turn the courtesy lamp bulb socket one quarter turn and remove.
Disconnect the power mirror electrical connector.
Remove the three outside rear view mirror nuts.
Remove the mirror.

the door panel near the mirror must be removed if not the entire door panel inside u will find 3 nuts to remove to get the old mirror off. hope this helps please rate me

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008f768
Hope this helps!