Question about 1986 Ford Bronco

1 Answer

Starter keeps ingaged

Turn on vehicle and stater keeps turning and it has a new starter

Posted by on

  • Anonymous Mar 13, 2014

    the starer turns over, making a winning sound, doesn't seem its ingaging the flywheel, It was replaced new 2013 from dealer



1 Answer

Could be starter solinoid is sticking and not disengageing your starter new one is $10.00-$15.00 I think, but take it out and have it tested first

Posted on Oct 06, 2008


1 Suggested Answer

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why will the starter not ingage when i turn the key, but vehicle will bump start

The starter is bad or there is no power to the solenoid. No power can be caused by a fuse/relay/broken wiring

Sep 13, 2015 | Cars & Trucks

1 Answer

Starter will not ingage ?

1"battery low 2.stater bandex slip. 3 IG switch or harnis problam

Feb 18, 2015 | Cars & Trucks

1 Answer

When I turn ignition switch on to start vehicle, engine does not turn over it just makes clicking noise, then I turn off and try again then it turns over, any ideas what it could be, starter?

yes starter also chk battery volts along with tunning headlights on turn ign if lights dim hard stater is drawing to much current replace

Sep 24, 2012 | 2001 Dodge Caravan

2 Answers

Turn key, makes clicking noise but not start.

Double check your battery connections. If the battery is new and the starter makes a series of clicking noises when the key is held in the start position than you are not getting a good power supply to the starter or there is not a sufficient ground.

I’m happy to assist further over the phone at

Aug 01, 2012 | Cars & Trucks

1 Answer

After starting car starter stays firing with key off

Sounds like the starter solenoid is bad in your new stater

Jun 14, 2012 | 1988 Ford Taurus

1 Answer

My stater turns on without turnning the ignition switch

you should replace the ignition switch. I had that problem with one of my vehicles. replaced the switch and lock and it worked just fine after that. Have them check the starter though because having it keep running like that can do damage to the starter itself

Apr 24, 2012 | 1993 Toyota Celica

4 Answers

Starting with key will not ingage the starter

Sounds like your ignition (mechanical) key assembly is bad. Key should turn freely through the full cycle. Off, on, run and start. Your vehicle should have 2 ignition switches, I.e., mechanical and electronic. Sounds like you either have a bad mechanical switch or perhaps even a problem with the steering column itself.

Sep 21, 2017 | 1992 Volkswagen Passat

1 Answer

1988 honda prelude manual tranny,won't start,put in a new starter and still the stater will not turn on, check fuse,oil,battery, what else can i check?

Have you checked the neutral safety switch? The switch is designed to prevent the vehicle from starting unless the clutch is fully depressed. I am not quite sure where the switch is located, it may be under dash on clutch shaft or the transmission. Keep me posted on this matter.

Jun 29, 2010 | 1988 Honda Prelude

1 Answer

Toyota starter problrm


Mar 03, 2009 | 1996 Toyota T100

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

210 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides