Question about Honda CR-V
Rear suspension mount rubbers , loose rim on hub, wheel bearings are all possible problems
Posted on Sep 02, 2017
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Does the noise have any sort of metallic sound to it? I had a '97 CR-V and when I turned hard right or left it would slighty bind the exhaust sytem. Just enough over time to cause the spot welds on the heat shield over the resonator (the "muffler" behind the catalyst) to fail. When I'd turn sharp, the heat shield would lift slightly due to the failed welds and vibrate against the resonator. Took a bit of head scratching to find this one.
Posted on Feb 27, 2009
I had the same problem that based on interner research is common for Fords trcuks/suvs. The common problem fro rear humming "rubbing"sound might be the rear wheel bearings/seal. These will need to be replaced as it will progressivly get worse and the noise louder and eventually the bearings can sieze. I would hesitate to take to a ford dealer if I were you as it can run $500-900. Take to mechanic that knows how to replace wheel bearings and seals. My mechanic replaced them for about $150. and the bearing and seals are around $40. A good way to test this is to raise the wheel were you can freely spin by hand...if does not spin or there is a lot of friction then it might be the wheel bearings.
Posted on Apr 11, 2009
inspect the braking system for warped or uneven rotor surface, as this may cause this noise and uneven pad wear. CV joints also could cause this if the boots are torn, have insufficient grease, are damaged,or have worn bearings. Hopefully this helps
Posted on Jul 22, 2009
check your cv axles in the front end. they are basically your drive axles. the popping while turning is usually the outer boots on the axle shafts have torn and the grease inside the boots has ran out causing the shaft to be dry and click or pop when steering. usually you can replace the boot thats torn but it must be done within a few days of it tearing otherwise you will need to replace the axle shafts.
Posted on Aug 10, 2009
Tips for a great answer:
May 29, 2014 | 2003 Honda Civic
Jul 31, 2017 | Honda CR-V Cars & Trucks
May 23, 2010 | 2003 Honda CR-V
Mar 12, 2010 | 2003 Honda CR-V
Oct 07, 2009 | 2007 Honda CR-V
Jul 22, 2009 | 2002 Honda CR-V
Jun 17, 2009 | 1997 Honda CR-V
Apr 29, 2009 | 2005 Honda CR-V
84 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: