Question about 2002 Isuzu Axiom

1 Answer

ENGINE NOT FIRING

MY STOP RUNNING ON IDLE.EVER SINCE THEN IT REFUSES TO START.BUT WHEN I TURNS THE KEK IT CRANKS BUT WILL NOT START.

Posted by on

1 Answer

Ask your mechanic about cleaning the "throttle wadding". I had the same problem as you. Sometimes, the wadding in the throttle cable gets real gritty and grimy and doesnt allow the throttle cable to adjust properly. Once it was clean, everything was back to normal. My mechanic did it for free since it took about no time.

Posted on Sep 08, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car cranks and starts. But turns off immediately. If I keep my foot on the gas it keeps running.


if it is a carby engine then check the idle stop solenoid at the base of the carby is operational
check for vacuum leaks including missing hoses or rotten hoses to vents and auto if it has one

Aug 29, 2015 | Cars & Trucks

1 Answer

Stalling and stoping and not starting up cranks fine


low fuel pressure.. clogged fuel filter..malfuntioning emissions controls...bad auto shutoff relay.. check all..

Feb 02, 2014 | 1999 Lexus LS 400

1 Answer

Spec vin ecu specs


If it turns, then the battery is OK. Either spark plugs are not firing in proper order (wrong firing order), no power to spark plugs, or no fuel because of fuel restrictions (dirty fuel filter). Inspect the air filter to ascertain its not clogged air. If you smell gas, then you saturated the spark plugs, which is why it refuses to run.
Let it sit for half hour to let spark plugs dry. Inspect to ascertain its not dirty spark plugs, which will also prevent engine from running. After ascertaining its proper firing order, spark plugs are clean, and there's power to distributor cap, ascertain there's fuel in fuel lines by squirting half second (short squirt) of starting fluid into air filter. Close the air filter housing to trap flammable starting fluid gas. Turn engine without giving throttle. Let starting fluid be ignited by spark plugs. If it won't start, then spark plugs are not firing to ignite starting fluid gas. If it starts briefly, but won't run when you give throttle, but catches when a 2nd person squirts more starting fluid into air filter just before engine stalls, then its a fuel restriction issue or no fuel in fuel lines.

Nov 29, 2013 | Cars & Trucks

1 Answer

Lots of crank no ignition a little sputter but no start


If an engine cranks but refuses to start, it lacks ignition, fuel or compression. Was it running fine but quit suddenly? The most likely causes here would be a failed fuel pump

Jan 31, 2011 | 2002 Toyota Tundra

1 Answer

"cold" start issue - engine cranks and revs right


FICV
fast idle control valve
and a price problem
not hard to replace but a $200 part

Dec 08, 2010 | 1991 Honda Accord

2 Answers

'03 Jeep Liberty starts weakly and needs gas pedal to idle


Turning over is what the starter does to the engine ...you can turn an engine over with no spark plugs in it...but you can't start it. Turning over is cranking .....the starter turns (cranks) the engine over (comes from when you had to put a crank in the front of the engine and crank it.)
Does it crank normally but has trouble starting???????

Jun 27, 2009 | 2003 Jeep Liberty

1 Answer

Truck dies when i stop or slow down


Here is the most common cause of surges and stalls and low idle rough idle, it is the idle speed control air-bypass valve and throttle valve (IAC for short), they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Feb 17, 2009 | 2003 Dodge Durango

1 Answer

Long crank time before starts


Thoroughly clean interior of throttle body especially area where butterfly flap seats and all drillings, use aerosol carb cleaner, check air filter and spark plugs (platinum type only!). Then set idle with a consult unit or similar, engine management must be in service mode to set idle properly.
Also test coolant temp sensor it may be open circuit. If you don't know how to do this ask me.
Forget about earth if starter turns engine over at normal speed.

Nov 05, 2008 | 1996 Nissan Maxima

Not finding what you are looking for?
2002 Isuzu Axiom Logo

Related Topics:

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...