Question about 2006 Hummer H3
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
What they meant by "they all leak" is that the sunroof seals around the glass are not meant to keep water from getting down in the sunroof, and tray and drains are there to drain the water that does get down in there. The problem most likely exists with your drainage tubes. They can either be clogged, or in my case with my 06 H3, the tubes were somehow disconnected and I had to drop down the roof panel to reconnect one.
Posted on Aug 18, 2010
My 06 was leaking during rain also. It turned out to be the sunroof. There are two drain tubes in the front of the sunroof that run the water down the corners to the ground and two drain tubes that drain water out the back corners. The water would seep around the glass, which is expected, but both of the tubes on the front of mine were plugged, and the water would overflow behind the dash and fill my floorboards. If my H3 was leaning to the left during a storm then the drivers side would be full of water. If leaning right, then the passenger side. I had to open sunroof and blow compressed air into the drain holes to clear them, but be careful, too much air will separate tubes from sunroof and then you will have to remove the inside paneling around sunroof to get to tubes and reconnect. You may only have one side plugged. you can test it by opening sunroof and pour a little water in the small catch pan in the front of the sunroof and see if it drains as expected (to the ground under the firewall on left AND right side). You can see the holes in each corner of catch pan to drain the water. Plug one with your finger, then the other to find the plugged side. Good luck!! Hope this helps!!
Posted on Mar 07, 2010
SOURCE: 2006 H3 Hummer fan problem
Hi if your internal fan not work in any position well i fixed up myself easy and save your money.
locate the fan motor air just outside right courtesy drawn document in front of passenger. go from down and look up you will see a motor with a big connector white with 2 screw secure inside the motor block. loose the two screws and pull out gently the connector from motor fan block. you will see a green multiresistor connected with this big connector. Usually the first + voltage connector is burnet out. disconnect the connector pull from resistor and check for any burn. in my case the first pin was burned out completely
you can buy another connector or you can clean the burned connector take out form connector weld a small copper cable of 5 mm dia from resistor to the burn cable and reconnect the connector without buy a new one. after replace again the resistor in the hole of motor blow with the 2 screw.
Done all work again without buy another new connector.
Gabriel from Italy Turin
H3 hummer 2007
loveling one and Humvee owner
Posted on Jun 11, 2010
Tips for a great answer:
Feb 27, 2015 | 2006 Hummer H3 SUV
Jan 16, 2015 | 2006 Hummer H3
Nov 12, 2013 | 2006 Hummer H3
Sep 01, 2013 | 2006 Hummer H3
Feb 19, 2011 | 2006 Hummer H3
May 17, 2010 | 2006 Hummer H3
Jan 26, 2010 | 2009 Hummer H3
Aug 17, 2009 | 2006 Hummer H3
Jul 08, 2009 | 2009 Hummer H3
650 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: