Question about 1994 Isuzu Trooper

1 Answer

My car is skipping basically. It also does this weird thing to where my blinkers wont work and when that happens it bogs down and wont switch gears and barely goes when you put it in 1st. We changes the flasher out and it ran great i turned the car off and it started skipping and all again.. I dont know what is going on with it but its a piece of ****.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 97 Answers

I had a similar problem with a '95 Rodeo. The transmission shifted gears based on electrical power sent to it. The voltage regulator in my alternator went defective and was outputting 16 volts. The higher voltage was fooling the transmission into thinking it needed to be in high gear from a dead stop when it really needed to be in low.

Take your alternator off and have Autozone test it to see if it needs replaced.

Posted on Mar 29, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 dodge grandcaravan starts but dies out.. it will start but wont, rev more than 4rpm and if u try n put it in gear it bogs down n dies ??? Its a 3.3 flex fuel


could be anything, needs to be investigated by mechanic. did it just go wrong after showng no signs of problems or did the problems just seem to happen out of nowhere.
If it doesn't rev Iwould check there is no water in the oil. If that is okay check plugs, leads, distributor cap. Are the plugs giving a good spark, (I am assuming it is petrol/gasolene not diesel or LPG.) Timing should be checked.
Some basic investigation should provide results.
When was it last serviced

May 27, 2015 | 2001 Dodge Grand Caravan

1 Answer

98 Yukon that is weird. when the left blinker is working the heat dose not work. when the left blinker is flashing fast the heater works. what could be the issue


Check to make sure all your chassis and body grounds are good. If they are not grounded properly weird things happen.

Feb 04, 2015 | 1998 GMC Yukon

1 Answer

Car fault finding


You may want to look at the neutral safety switch. The shift linkage!!! Weird things that things causes. I had 1997 Taurus would not start because it though it was in gear. When started and running you put in reverse the radio quit working. LOL weird man.Try to push the shift lever up or down one way when turning the key. If it start get a new ns Switch. $37 pretty easy to install.

Nov 04, 2013 | Cars & Trucks

1 Answer

1994 Geo Metro won't accelerate past 1/2 way through each gear. When it gets half way through first gear, the car bogs down and won't accelerate further. Shifting into second, it lugs until half way...


I would pay more attention to the air flow sensor and mass air flow sensor, putting this on a diagnostic machine will pinpoint the errors stored on the onboard computer. both sensors can be cleaned by a competent mechanic, most mechanics don't want to, they prefer just to swap items out these days because of costs. get a reading, then you will know for sure. good luck.

Oct 20, 2013 | 1994 Geo Prizm

1 Answer

P1152 Mustang 2000 GT 4.6 2v 5spd


Going to suggest a few things. Since each side has an identical O2, just switch 1 bank's O2 for the other and see what happens. Maybe replacement part was bad.

Also want to add that wiring of the heater on O2 sensor is not always electrical. Some O2 sensors have hollow wire for heat venting. You say that the shop rewired ECU to O2 but must have used solid core wire to do it. This will not work if you needed a hollow core wire from the O2.

Sep 04, 2012 | Ford Mustang Cars & Trucks

2 Answers

1997 Dodge Ram 4x4 1500 transmission shifting problems.


good day, you may try replacing your automatic transmission fluid, a good run will be noticeable, hope this helps, have a nice day

Feb 08, 2010 | Dodge Ram 1500 Cars & Trucks

1 Answer

My car turns on but it wont shift into any gear


dear friend-your blinker light has nothing to do with your gearbox problem,i surgest you have a look at the hazard switch.regarding you gearbox problem i think we must start at the gear lever.make sure that when you press the button on the shift that it does dis-engage,then while having the shift in hand move the car forward and back wards,try to dis-engage,if not you will have to remove the sump and look at the meganism inside,it has a half moon operating the shaft that is connected to the lock meganism.

Jul 18, 2009 | 2001 Hyundai Tiburon

4 Answers

Blinkers wont turn on its not the bulbs or fuses 01 tahoe


Did you replace the hazard/flasher/blinker relays?- they are in the fuse block usually.

This is weird, but try this: Turn on your hazard lamps and turn your steering wheel all the way left and all the way right.
Then turn on your left blinker and hold the blinker on while you turn all the way left, then right. It will click and try to turn it off but keep it held down and turned on. Then do the right blinker the same way.
I have had this problem with every GM I've ever had, something about the detent-return and the blinker relays getting reset. I'm not sure why it works, but if your flasher relays are good and your fuses,bulbs and wires are good then this is probably what will fix ya. I've had this happen often enough that I always do this first. My GM vehicles were/are all 60s to 90s models- old school, but try this before you do anything else with it it's free and only takes about 15 seconds to do. Sometimes I have to do it more than once, but eventually the detents reset and they work. Viola!
Good luck and please rate this solution if it fixes ya!

Jun 21, 2009 | 2001 Chevrolet Tahoe

1 Answer

Transmission wont switch gears and nothing in dash cluster works


this could be a relay or body control module as all things are controled electricaly in your van relays are under hood near front of engine ---did you check fuses first? relays next --even trans is controled electricaly

Jun 12, 2009 | 1999 Dodge Grand Caravan

2 Answers

1996 oldsmobile 88 transmisson is doing very weird things


dear friend-it sounds like the output planeteries is stripped,your gearbox engages but no output,you will have to remove and repair the box.

Apr 18, 2009 | 1996 Oldsmobile 88

Not finding what you are looking for?
1994 Isuzu Trooper Logo

143 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...