Question about 1999 Dodge Durango

1 Answer

I have no turn signals, inside or out. my hazzards work thou. tried replacing fuse but still no signal

Posted by on

  • 1 more comment 
  • redbasic Aug 08, 2008

    I just want to know where is the fuse for the turn signal.....The manual does not have one listed.

  • stumped1999 Aug 14, 2008

    I would like to know this as well, we just bought a 1999 Dodge Durango for my son & replaced the fuse but still not turn signals - all other lights, etc work...


    Any help with this would be greatly appreciated!


  • slightlyhot9 Oct 28, 2008

    4 ways work, replaced fuse, turn signal stays in position but does not click or flash, if it does decide to flash it makes a really fast clicking noise then stops...no blinker light. Whats goin on??

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had the same prob. it turned out that the bulbs were loose. mess with them while the signal is on, not the hazards.

Posted on Aug 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My turn signals on my 2002 pontiac grand am wont work is it tha fuses or???


The gm line of that erra runs their turn signal through the hazzard switch, when your turn signals are inop, try depressing the hazzard switch a few cycles, if this alows your turn signal to function again as hazard switch will be required to repair the problem, hope this helps

Mar 02, 2015 | 2002 Pontiac Grand Am

1 Answer

Turn signal not working / has a short cant seem to find the sort


sounds strange, but does your hazzard lights work? If they do play with your switch wiggle etc while trying your turn signals. I have seen the hazzard light swith malfuction and cause this issue in the past. Good luck

Jan 04, 2013 | 1997 Nissan Pathfinder

1 Answer

2001 nissan sentra neither one of my turn signal bulb are working tried replacing the bulbs that didn't work.also tried switching the pigtail that didn't work either any idea what the problem


I had this problem with my car. Is ur hazzard flasher working? if they are working and the turn signals are not working. Try replacing the hazzard light switch. If the hazzard are not working then the combination flasher unit is bad. its what controls the signals and flasher.

Nov 10, 2012 | 2001 Nissan Sentra

1 Answer

Where can you locate the turn signal flasher unit on a 1992 plymouth acclaim


There are two flasher relays under the dash in the car. One for the hazards and one for the turn signals. They are next to the fuses under the steering wheel right by the hood release

Nov 05, 2012 | Cars & Trucks

1 Answer

My turn signals don't work but the hazzards flash


if your hazzards flash, that means your bulbs will be good but, your turn signal fuse is blown. you should check that first, & don't forget to turn off your hazzards before you can see if your turn signals work again. give it a try.

Dec 01, 2011 | 2000 Dodge Caravan

1 Answer

When turning left, push down signal and nothing happpens. Light does not turn on. Nothing happens. But the hazard lights works.


try checking the fuse for the turn signal if not that try replacing bulb turn signal is differnt than hazzards or try replacing flasher its a big grey cylinder on fuse panel.

Oct 10, 2009 | 1993 Mitsubishi Eclipse

1 Answer

Turn sinals won't work, turn on hazzards they worked but buttom /hazzard went into dash board


replace the turn signal switch fuse.if they dont work after replacing fuse.check to see if switch getting power if yes replace turn signal switch.if not you have a electrical problem.you have to remove the center cluster.like the radio.to reach the hazzard switch.besure to turn off radio. disconnect negative battery cable.wait 20 minutes let air bags discharge.when working on instrument cluster or steering wheel area.air bags has to be disable.

Jul 01, 2009 | 1999 Oldsmobile Alero

1 Answer

Hazzard Lights on 1998 Ford Crown Victoria won't work


The hazards are on a seperate fuse to the indicators, on the inside of the fuse box cover it will tell you which fuse it is, simply replace it with one of the same rating and your hazards should work, if not come back to me

Mar 16, 2009 | 1998 Ford Crown Victoria

4 Answers

Turn signals not working --- 2001 Cherokee Limited


Check the flasher under the dash to the left of the steering column. It's got about 8 or 10 wires plugged into it.

May 30, 2008 | 2001 Jeep Cherokee

Not finding what you are looking for?
1999 Dodge Durango Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...