Question about Ford Futura

1 Answer

I have a 1999 au falcon. Engine not starting. I was told to look at petrol filter, that is new. The told to listen for petrol pump, I heard it making a noise. What else could be at fault?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Ford Master
  • 987 Answers

Check to see if you have a spark at the plugs, IF not then change the crank sensor and you will be fine.

Posted on Mar 26, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Au2 2000 dedicated gas have dash lights but engine will not turn over dash just beeps with dte 37


gas or petrol a normal fault code motor should still crank

dte is a data type fault
wonder if the ecu or a module has failed

anything mentioned in this au repair manual pdf download

Ford Falcon AU 1998 2002 Workshop Manuals Factory Service Manuals

Oct 27, 2016 | Cars & Trucks

1 Answer

1999 Corsa B 1.6i my timing jumped and since then


Since you have replaced most of the engine parts I would check you are getting a spark at plugs first and then fuel from pump! I think these are the most probable reasons for not starting!

Oct 18, 2014 | Cars & Trucks

1 Answer

Where do you add automatic transmission fluid in 2000 ford futura au


in a plug on the side of the gearbox under the car (16mm),running in "D" with the engine running at 1000 rpm with the box warm but not hot,pump it in until it runs out of the plug, a pit,hoist or solid ramps will be needed for this as well as 2 people

Oct 16, 2014 | 1999 Ford Falcon

1 Answer

AU Falcon turn over no fuel pump no start could it be the transponder in key


Check fuel cut-off switch if fuel pump is not turning on and you have checked the fuses.

May 20, 2014 | Ford Falcon Cars & Trucks

1 Answer

93 rodeo turns over but wont start


probably should ask petrol or diesel how ever ill go with petrol. if at all possible get some one to operate key while you get close to the fuel tank and listen for the fuel pump operating, another way to check is disconnect fuel return line and crank over engine being careful as if pump is working fuel will pump out possibally causing a fire hazard so once again only a quickflick of the key is needed , usually the pump can be heard operating if you go close enough to the tank. so I guess we will start there , is there fuel getting to the engine?

Feb 28, 2014 | Isuzu Cars & Trucks

2 Answers

I have a 1999 zr2,when you give it cas under a


You didn't say if there was an engine light on. I'd check the t.p.s. throttle position sensor. It could be a jumped timing belt,based on the year , it's got milelage.

Jun 21, 2009 | 1999 Ford Escort

1 Answer

How do you replace a driving belt on a 1999 AU ford falcon


start by unplugin the electric fans then remove the two 10mm bolts holding them in, the bottom of the fans are held in by a slot that they sit in so after you remove 2 bolts just lift the fans out. then you will see a tensioner i think it has 3/8 drive square hole in it( could be 1/2'' drive) just pull it down with a long bar with a 3/8 end on it to release the tension, while doing that slide the belt of,. if your car doesnt have a picture diaghram on the under side of the bonnet for drive belt routing draw a picture incorprating all the pulleys an how the belt goes around them. once the belt is of put the new one on exept over the power steering pump pulley, then pull on the tensioner again to release tension and slide the belt over the p/s pulley. these instruction are for the 4.0l falcon motor, the 5.0 v8 is really similar

Aug 21, 2008 | 1999 Ford Super Duty F 550

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...