Question about Ford Futura

1 Answer

How can i clean or change injectors myself - Futura Ford Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 89 Answers

This can be done by removing the fuel rail then gently pulling on the injector to remove it from the engine then gently cleaning the spray head with a nylon brisle brush and throttle body cleaner.

Posted on Sep 22, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi 2006 ford focus 1.6 tdci leaking injectors and carbon build up. How to clean it and would it be possible to do it myself any help would be great. Thanks in advance


the injectors have to set properly using specialized equipment after new tips are fitted so take them to a specialist diesel shop and have the job done properly ( cost around $60.00 a tip plus 1 hour labor generally)
if the carbon build up is around the injector body in the head
clean it out using a scraper of sorts
always fit new copper washers under the injector body on reassembly
there is not much you can do for carbon in the combustion chamber other than to pull the head but thee is every possibility that any excess carbon will be burnt off when the injectors are operating correctly

Oct 10, 2015 | Ford Cars & Trucks

3 Answers

How to remove and clean diesel injectors on mazda b2500d turbo intercooler


Remove the line on top of them and the unscrew like spark plugs u can clean them out with injector cleaner when you reinstall them do not tighten fuel lines all the way leave them loose just a little till fuel sprays out or starts when starts snug each one and crack each one at a time to bleed out the air if it where me I would just put sea foam cleaner in fuse and it won't take long and they will clean up

Jan 03, 2015 | Mazda Cars & Trucks

1 Answer

THE 91 NISSAN STANZA idlesreal good but when you press the gas it goes fast then slow then fast and slow again will not run smooth


could be clogged fuel injectors, fuel pump, fuel filter first what I would do is clean fuel injectors and replace fuel filter, if there is no codes, meaning your check engine light is not on, some times bad gas can do this or water in gas, better to try the easy things first, plus they real dont cost.much, now I use Lucas fuel injector cleaner myself, I have always got good response from it, plus if need to, you can put a tube in every day, thats if you use about 10 gallons of gas everyday so.try this first, cost for Lucas is around $6 also change fuel filter, cost any where from $7 to $25

Dec 04, 2013 | Cars & Trucks

1 Answer

I think my fuel injectors need cleaning or one may be failing is there away to clean them myself other than putting fuel injector cleaner in gas.is there anyway to tell if one is failing also is there


No, you cannot clean furl injectors. Fuel today contains cleaners and 99.9% of injector failure is due to an injector whose electrical winding create no or low voltage or high voltage. Either way the faulty injector will cause the engine to miss or run poorly. You can use a volt meter to check voltage. With the volt meter touch each probe to either terminal on the injector. A normal ohm reading would range from 11.8 -12.9 ohms. Any reading from 1.0 to 8.0 or 15.0 and higher, the injector is no good and should be replaced.

Oct 15, 2017 | 1996 Pontiac Trans Sport

1 Answer

2004 Jeep Grand Cherokee CRD 2.7L injector seal leak issue


I would contact the dealer and see if the parts dept has a revised seal.

Jun 14, 2012 | Cars & Trucks

1 Answer

2000 bravada . i need to replace a injector on #3 cylinder acourding to our mech how much trouble is it to do this myself


NOT TO BAD ..FIND INJECTOR RAIL LOOSEN BOLTS THAT HOLD LINE TO INTAKE ,PULL UP ON RAIL.REMOVE INJECTOR FROM RAIL ..CLEAN IT WITH CARB CLEANER ...MIGHT BE CLOGGED THATS ALL...IF NOT GO TO JUNK YARD AND GET ONE.MAKE SURE TO LUBE O RING ON INJECTOR EASY TO PUT BACK IN.

Aug 26, 2011 | 2000 Oldsmobile Bravada

1 Answer

In idol, comes extreamly close to dying on me. I have to keep on the gas to keep 'er going. Feels like there isn't enough either fuel or air getting to the engine. I just cleaned the air filter and put...


try changing the spark plugs and wires

oil change

replace the air filter if its the reguler one and not the cleanable ones

put some fuel injector cleaner in the car

these are some options ^-^

i hope this helps

Aug 06, 2010 | 1997 Volkswagen Jetta

1 Answer

How to change fuel injector bank one? My son's 97 mercury mystique to thorwing a P1131 code for the fuel injector in bank one. Also throwing a P0133 for the O2 sensor. How do I replace the fuel injector...


Yes they are i would try and change the o2 sencer first.Because it says your system is running to lean or to rich. And that 02 sencer is the problem

Apr 15, 2010 | 1997 Mercury Mystique

1 Answer

Changing a fuel injector on a Toyota Carina 1996 1800, anyone have an idea how to change before I start?


Disconnect the wiring plugs from the injectors, Then remove the fuel rail (which is attached to injectors). Then remove injectors from the fuel rail. Don`t forget to change the "O-rings", (little rubber things on the end of each injectors). Otherwise there`s a possibility of fuel leak.
Also I suggest trying to clean the faulty injector at first, It might be ok, just dirty inside.
How to clean: Use injector cleaning fluid on the end of the head of the injector. Attach minus and plus to the contacts of the injector to battery of the car or any other energy source, and start pulling the negative wire on the battery on and off. You should hear clicking sound in the injector. Use the fluid and this "technique" for couple minutes or more, until the injector starts spitting the cleaning fluid evenly, not rarely. If still the injector doesn`t spit the fluid, you might need to change it.


Hope this helps, sorry for my english. I`m a lithuanian

Feb 16, 2010 | 1996 Toyota Camry

1 Answer

When starting engine it runs rough for 35 to 45 seconds then smoothes out,also check engine light is on. I changed oil and spark plugs with no problems for a week,then problem returned.Car has 60000...


SOUND LIKE DIRTY FUEL INJECTORS.FILL GAS TANK UP.POUR A BOTTLE INJECTOR CLEANER IN GAS TANK.DRIVE CAR AROUND.SO THE CLEANER CAN CLEAN OUT INJECTORS.ALSO REPLACE FUEL FILTER.HEY YOU CAN GO TO AUTO ZONE OR ADVANCE AUTO THEY WILL SCAN YOUR CAR FOR FREE.

Sep 06, 2009 | 2005 Nissan Sentra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...