Question about 1998 Ford Windstar

1 Answer

Ford windstar 1998

The air flow does not come out of the back vent?

Posted by on

  • djjs58 Aug 03, 2008

    The air flow to the rear vents does not work, The blower is fine. The air does not come out of the rear vents

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,920 Answers

Its a problem with the control valve most likely...

Posted on Aug 24, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 ford windstar blowes cold air thru defrost only warm in back


For some reason this question was listed a dozen times within an hour or so.
Usually the problem is a blend door under the dash. The blend doors direct air thru the heater core and the vents.

Jan 12, 2013 | 1998 Ford Windstar

1 Answer

1998 windstar heater blows cold air


I used to have this vehicle. There are a couple of things that can cause this. In my case there was a disconnected vacuum line that caused the air to only blow through the defrost vents. The vacuum hose beneath the passenger side cowl is probably disconnected. It is behind the engine just below the passenger side windsheild wiper.

The other possibility if all of your vents are working and the air is just cold, could be because the heater core bypass valve vacuum hose came off. Check to make sure the heater core hoses have hot coolant flowing through them when the engine is at operating temp and while running.


The last possibility for this vehicle is the actual HVAC panel with your controls on it. This panel has colored vacuumn lines connected to it that like to break off over time. The switches themselves will sometimes leak air preventing it from functioning correctly.


Hopefully this gives you some clues on where to look.

Nov 24, 2012 | 1998 Ford Windstar

1 Answer

1998 ford windstar ac not blowing out front vent


i found lose vacuum line and started geting cold air front was working until my car start staling and check engine light came on car turn off code po172 ....some were is

May 23, 2012 | 1998 Ford Windstar

2 Answers

Ac is blowing out of defrosterandnot panels in the dash. Air is cool cold air will blow out of rear seat panel/vent 1998 ford explored


The most common cause is a bad blend door actuator which controls air flow throughout the cabin. When air flow only flows from 1 section (either floor, vent, or defrost) it's an indication that the blend door actuator is either stuck or broken.

Jun 02, 2011 | 1998 Ford Explorer

1 Answer

How do you change a heater core in a ford windstar


For A 1996 Windstar:
1. Disconnect Battery Ground Cable.
2. Drain Engine Coolant System.
3.Remove Cowl Top Vent Panel For Clearance.
4.Disconnect Heater Water Hoses From Heater Core Inlet And Outlet Tubes In The Engine Compartment.
5.Remove Ground Strap Attatchment (If Present) From Heater Core Tube.
6.Remove Cassete Box.Center Instrument Panel Support Trim.
7.Pull Out And Remove Cup Holder.
8.Remove Rear Seat Air Flow.
9.Disconnect Keyless Entry Wiring Harness, If Equipped.
10.Remove Center Instrument Panel Support Brackets.
11.Disconnect Climate Control Vaccum Line Connector.
12.Remove Heater Floor Duct.
13.Remove Heater Core Cover Retaining Screws and Remove Heater Core Cover.
14.Remove Heater Core.
15.To Install, Reverse Removal Procedure.

Jan 22, 2011 | 1998 Ford Windstar

2 Answers

MY 98 FORD WINDSTAR STALLS WHEN I IDLE OR COMING TO A STOP I'VE CHANGED AIR FLOW SENSOR, AIR FILTER, SPARK PLUGS, AND FUEL FILTER ANY IDEAS?


I'd be looking at removing IAC valve, and cleaning it out with throttle body spray cleaner, and checking mounting gasket as well. Usually some success with cleaning it & spray ports it came out of, but if not you may need to replace it.

Oct 12, 2009 | 1998 Ford Windstar

1 Answer

Heat and AC vent problem.


most likley you have a vaccume leak somewhere but also the linkage to the door that that directs the air flow may be in a bind. another possability is the hvac controlls. hope this helps

Jun 08, 2009 | 1998 Ford Windstar

1 Answer

No heat - ac stays on blowing through defrost vents


If you have the heater directed to the windshield, the AC will turn on. Move the control away from defrost.

Feb 01, 2009 | 1998 Ford Windstar

1 Answer

A.C.vent flow


headlights won't turn off.. 1998 fors tuarus

Aug 19, 2008 | 1998 Ford Taurus

Not finding what you are looking for?
1998 Ford Windstar Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...