Question about Nissan NV2500

1 Answer

Is it just open drain plug and refill or is there aproblem of air pockets the tranny is 4x4 with transfer box in same housing

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 56 Answers

There is no need to blead air from the gearbox or transfer, or diff's
first the transfer and gearbox are together but use their own oils and are changed seperatly
remove the drain plug to drain, refit then refill through the filler flug, the correct level is thesame as the filler so when starts draining from the filler hole its full. car needs to be level/flat ground when doing this.
if its auto there will be a tube for checking the level, at the back of the engine under the bonnet. auto trans oil does need the engine running to check for correct level.
remove drain plug with the engine off, refill approx same amount of oil in to the dipstick tube, then start the engine, select each gear for a couple of secconds then back to neutral, check level with engine still running. adjust level if needed.

Posted on Mar 26, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How many qts of oil do i need


Depends on your engine.

1980 JEEP CJ-7 2.5L 4-cyl Engine Code [B]
CAPACITIES
Engine, GM without filter..........2.4 quarts[1]
Wix Filter ........ 51040
Cooling System, Initial Fill..........8.0 quarts
Automatic Transmission, A904, 30RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, A999, 32RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, Total Fill
3 speed A999, 32RH..........8.4 quarts
3 speed A904, 30RH..........7.0 quarts
Manual Transmission, 4-SPD, SR-4..........3.0 pints
Manual Transmission, 4-SPD, T176..........3.6 pints
Differential, Front..........2.5 pints[3]
Differential, Rear..........4.9 pints
Transfer Case,..........4.0 pints

1. Add extra oil when replacing filter. After refill check oil level.
2. With engine automatic transmission operating temperature, shift through all gears.
Check fluid level in NEUTRAL and add fluid as needed.
3. 1984-1992 Models with command-Track, add 5 oz of 75W-90 GL-5 to shift motor housing opening.

TORQUES
Oil Drain Plug.....25 ft-lbs
Manual Transmission T176
Fill Plug.....15 ft-lbs
Drain Plug.....15 ft-lbs
Manual Transmission SR4
Fill Plug.....20 ft-lbs

1980 JEEP CJ-7 4.2L 6-cyl Engine Code [C]
CAPACITIES
Engine, without filter..........5.0 quarts[1]
Wix Filter..... 51522
Cooling System, Initial Fill..........11.0 quarts
Automatic Transmission, A904, 30RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, A999, 32RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, Total Fill
3 speed A999, 32RH..........8.4 quarts
3 speed A904, 30RH..........7.0 quarts
Manual Transmission, 4-SPD, SR-4..........3.0 pints
Manual Transmission, 4-SPD, T176..........3.6 pints
Differential, Front..........2.5 pints[3]
Differential, Rear..........4.9 pints
Transfer Case,..........4.0 pints

1. Add extra oil when replacing filter. After refill check oil level.
2. With engine automatic transmission operating temperature, shift through all gears.
Check fluid level in NEUTRAL and add fluid as needed.
3. 1984-1992 Models with command-Track, add 5 oz of 75W-90 GL-5 to shift motor housing opening.

TORQUES
Oil Drain Plug.....30 ft-lbs
Manual Transmission T176
Fill Plug.....15 ft-lbs
Drain Plug.....15 ft-lbs
Manual Transmission SR4
Fill Plug.....20 ft-lbs

1980 JEEP CJ-7 5.0L 8-cyl Engine Code [H]
CAPACITIES

Engine, without filter..........4.0 quarts[1]
Wix Filter..... 51258
Cooling System, Initial Fill..........13.0 quarts
Automatic Transmission, A999, 32RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, A904, 30RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, Total Fill
3 speed A904, 30RH..........7.0 quarts
3 speed A999, 32RH..........8.4 quarts
Manual Transmission, 4-SPD, SR-4..........3.0 pints
Manual Transmission, 4-SPD, T176..........3.6 pints
Differential, Front..........2.5 pints[3]
Differential, Rear..........4.9 pints
Transfer Case,..........4.0 pints

1. Add extra oil when replacing filter. After refill check oil level.
2. With engine automatic transmission operating temperature, shift through all gears.
Check fluid level in NEUTRAL and add fluid as needed.
3. 1984-1992 Models with command-Track, add 5 oz of 75W-90 GL-5 to shift motor housing opening.

TORQUES
Manual Transmission T176
Fill Plug.....15 ft-lbs
Drain Plug.....15 ft-lbs
Manual Transmission SR4
Fill Plug.....20 ft-lbs

Oilman

Feb 02, 2013 | 1984 Jeep CJ7

2 Answers

I have a 1990 Chevy Cheyenne 4x4 with Automatic Transmission. It is making a "funny sound" in 2wd when coasting down hill that goes away if I switch it into 4wd. I have checked the U joints and...


get a manual in a parts place on troublshootn trannys--are very complicated and you need step to step procedure--car is 20yr--library has books too

Mar 29, 2011 | 1990 Chevrolet K1500

1 Answer

Where is the transfer case located, to drain and refill transmission fluid, on a 1993 Ford Explorer 4X4?


It is located under the truck, it is attached to the back side of the transmission, the rear drive shaft goesinto it. to drain it there is a plug on the bottom end of it, usually above the skid plate. to refill it there is another plug above the drain and to the right.

Oct 24, 2010 | 1993 Ford Explorer Limited

1 Answer

Got 55k on a 2004 Dodge Dakota any scheduled service for 60k....like belts transmission etc?


The 60K service on this vehicle requires the following....

Change engine oil and engine oil filter. X X X X X Change rear axle fluid. X X Change front axle fluid (4X4). X X Inspect brake linings. X X Inspect engine air cleaner filter, replace if necessary. X Replace spark plugs. X Inspect PCV valve, replace as necessary.* X Inspect auto tension drive belt and replace if required. X Drain and refill transfer case (4X4). X Drain and refill automatic tranmission fluid, change filter and adjust bands (3.7L). X Drain and refill automatic tranmission fluid and change main sump filter (4.7L).

Oct 13, 2010 | 2004 Dodge Dakota

1 Answer

How do you change the coolant in a 2002 Buick?


With any car you have to open the plug on the bottom inside of radiator using something to hold the fluid. Take off the radiator cap to release pressure. Once all has drained out, close plug tight with fingers. Refill 50/50 mix. Run car for 5 minutes with cap loosely on top. Add more coolant. You want to get the air pockets out for sure. Very important. You can also use a funnel if it fits right in radiator while running it to get air out but as it heats up the level will rise. Air pockets will overheat the car.

Sep 02, 2010 | 2002 Buick Regal

1 Answer

Need diagram to change fluids in transfer case and front and rear diffential for a 2003 dodge ram 3500 4x4


This is pretty straight forward once you have a few basic tools. You will need a suction pump and a bowl/bucket type container to put the old fluids into.

Both the front and rear diffs should have a rubber inspection plug you can remove to pump the old stuff out, and the new gear oil in.
Synthetic fluids last longer and work better.

The transfer case should have two threaded allen plugs (or similar) that are removed to drain and then refill the T case. Remove bottom then top to drain. Reinstall bottom then refill.Then reinstall top.

Aug 09, 2010 | 2004 Dodge Ram 2500

3 Answers

Water in heater box on a 1999 Dodge Ram 1500 4X4 Quad cab. I can hear water rushing around in the dashboard but have no visible leaks


make sure the drain is clear, it in engine compartment agaist fire wall were heater box is located.

Oct 09, 2009 | 1999 Dodge Ram

1 Answer

HOW DO I REMOVE A TRANSMISSION ON A 1993 S10 BLAZER 4X4


remove drive shafts remove cross member, and transfer case mount remove transfer case then remove tranny there are 6 bell housing bolts that hold tranny in 15 mm i think and 2 trany lines if its auto

Sep 18, 2009 | 1993 Chevrolet S-10 Blazer

2 Answers

Need to change shift fork,


Transmission are kinda tricky. Yes you'll have to take the t-case off. Transmissions won't just fall apart when you break them open. But first things first. What's it doing. And if you don't really know anything about transmissions, I would give it to a shop to rebuild. Won't cost very much.

Mar 11, 2009 | 1986 Toyota Pickup 4WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

153 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

723 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...