Question about 1999 Dodge Grand Caravan
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: oil pressure light at low RPM
Before you have major repair done on your car because of the "oil pressure light", review the list and see if any of these might be the source. Some of the things on this list are things you can do yourself, some only done by a mechanic (inexpensively), and others require the aid of a mechanic.
1. Check to see if you have a leak. Low oil levels can make the oil sensor light come one. Check your oil level following the manufacturers recommended procedure or use the information listed here http://autorepair.about.com/od/regularmaintenance/a/checkoil.htm. If you do not have a low oil level, but still suspect a leak, place a drip pan under the oil plug overnight. If you have a leak, you'll see signs of it there. Then take the vehicle to a trustworthy mechanic and let them trace the leak. It is possible for your engine to only leak when it is hot, so make sure you get the engine nice and warm before you put the car away for the evening and place the drip pan under your vehicle. Other signs of an oil leak are listed below as well as an "oily" exhaust that leaves it mark on your bumper or "blue smoke" as you drive/idle.
2. Check the coolant levels. If the coolant is low, the oil will heat up faster and cause a viscosity breakdown. When the oil viscosity is low (= thin oil), the oil sensor light can come on. If the coolant is low, add more. Keep in mind that an engine running hot will heat the engine oil to the point that it thins out and burns off in the cylinders. If the coolant level is fine, have the coolant (water) pump checked. If the coolant is not circulating well through the engine, you'll probably have coolant boiling over, too.
3. If you can afford to do it, change your oil to a higher or lower viscosity. Refer to your maintenance manual and your trusted mechanic. I say this because, if your oil is thinning out too much because the viscosity is too low, your "check oil" light will come on. If your engine oil is too thick, you engine will need added internal pressure to get it to circulate. At lower RPM (just like thin oil), your engine oil light will come one.
4. Have the oil pressure checked by other than an electronic means. Your trusted mechanic can place an oil gage between your oil filter and the rest of the engine or on the oil fill cap of the engine. If you are having an oil pressure problem that is seal-related, that should narrow it down. If you can't afford to do that, when you get your next oil change, replace: the oil fill cap, PCV valve, and air filter. All these contribute to the measurement of engine oil pressure by that picky little oil pressure sensor.
5. Have the oil pressure sensor checked. You may need some weird add-on to make it behave. Do a search for the following part and read and you should have a better understanding: "part # 05017800AA a terminal/wire/vent to the oil pressure switch connector". Never forget that sensor are usually engineered to report a problem well before a catastrophic failure can occur.
6. If you're driving a high-milege car, make sure you are up to date on all of the engine-specific services. For some vehicles, it is recommended that the head gaskets are replaced. If you have internal engine leaks because of it, this will solve most of those issues. Signs of this include: coolant visible in the crankshaft area (you can see this with the oil cap off), oil fouling your coolant (you can see this in the coolant reservoir), or smokey exhaust. Expect your trusted mechanic to recommend that you change your spark plugs, timing belt, and cam shaft gasket at the same time.
7. See if the oil pump needs to be replaced. A faulty oil pump can contribute to low oil pressure as it fails (but hasn't failed, yet).
8. Do all of the above BEFORE you take to recommendation to have your engine replaced.
I have a 1998 Chrysler Cirrus (I know it's not a minivan, but hear me out). I've been the single owner and have learned more about how engineering oversights or over-cautiousness can send you to the mechanic for just about everything.
Hope this helps!
Posted on Jan 20, 2009
sometimes its behind the alternator real close to the firewall. Find the bigger of the two hoses and pipes the low side is always bigger. Also the cap is blue and the fitting for the charging can will only fit on the right valve.
Posted on Apr 24, 2009
you should be adding the 134a to the system the low pressure switch is doing its job by not allowing the compressor to kick on, it wont kick on until there is enough 134a in the system to be above the preset pressure for the low pressure switch.
Posted on Jun 27, 2009
Tips for a great answer:
Jun 09, 2011 | Dodge Caravan Cars & Trucks
May 30, 2011 | 2003 Dodge Grand Caravan AWD
Mar 30, 2011 | 2007 Dodge Grand Caravan SXT Minivan
Apr 08, 2010 | 1999 Dodge Grand Caravan
Apr 08, 2010 | 2005 Dodge Grand Caravan
Aug 10, 2009 | 1999 Dodge Grand Caravan
Jul 30, 2009 | 2000 Dodge Grand Caravan
Jun 27, 2009 | 2003 Dodge Grand Caravan AWD
Jun 09, 2009 | 2006 Dodge Grand Caravan
May 12, 2009 | 1999 Dodge Grand Caravan
247 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: