Question about 2007 Suzuki XL-7

Open Question

2008 suzuki xl7 wont turn over or start. it just makes a whinning sound when you try to start. the battery is brand new and yes the connection is good. just makes a humming sound when you try and start.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 4 wheel drive wont engage on 2oo1 suzuki XL7

Probably failed free axle air pump. This mounts below radiator on RH side of vehicle. Should be able to hear it buzz for a few seconds if you get down there and have someone else turn on the key and try to engage 4WD lever. No buzz-no work.

Our 2001 XL7 has gone through 2 of these in 150,000 mi. The unit is mounted low where it gets tire splash. Salt from road corrodes the wiring and it fails.

About 10 minutes to R and R.

Can get replacement through Southwest Suzuki on the Web for about $225.

Hope this helps.

Posted on Aug 11, 2009

jigsaw_9077
  • 308 Answers

SOURCE: suzuki XL7 -horn

The owner should locate the horn circuit . prepare the tools or equipment to be used.So that when the horn circuit is check it function properly.locate horn unit,horn relay,horn switch,horn power supply.check the fuse, check the relay,check the switch,check the wires,check the horn unit.Observe safety precautions.Use terms to describe checking horn circuit. If there are worn out or malfunctioning parts replace them.If there are loose connections of wires then reconnect it . But if the owner cant do it go to a car mechanic and the mechanic will do the job.










Posted on Sep 29, 2009

  • 1 Answer

SOURCE: how to replace headlight bulb in 2008 suzuki xl7?

http://www.suzuki-forums.com/2g-2007-xl7/19397-replacing-headlight-bulbs-2.html

Posted on Mar 11, 2010

  • 4336 Answers

SOURCE: Suzuky xl7 service engine soon light.

you have to resolve the issue before the light will stop.

Posted on Jul 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Buen dia tienen el manual para instalar la cadena de tiempo de una Suzuki xl7 modelo 2008 4wd motor 3.6 de 6 cilindros


spanish to and English forum. ok.
here ill run google on that.
"Good day they have the manual to install the time chain of a Suzuki xl7 model 2008 4wd engine 3.6 of 6 cylinders"]
where is this car, in USA or Spain, South America, where?
cars vary by COUNTRY.

yes, and the manual only for our cars here, we are USA forum
with USA cars, books and manuals. matching...

here is it is for 4 bucks (USD) its official book not a clone.
this is not spam its real.
the v6 are mostly all the same way. ]
RTM , read the manual here.

https://suzukipitstopplus.com/Products/1158-2008-xl7-service-manual.aspx

sorry only in English this book.
if not in USA go to your SUzuki dealer there, and buy the book.

Dec 20, 2016 | Suzuki Cars & Trucks

1 Answer

AWD. Remote starter causes lights to turn on and stay on but why doesn't engine start?


but does manual starts work, with key in dash key socket?????????
is this the factory remote start option?
do both FOBs fail>?

if yes, know that the factory version is very strict on cranking rules. (laws to OEM)
so if yes, then you must scan the pcm
if you see any DTC errors, bingo.

this is to prevent injury of those around any car with this junk. 15+ deaths and growing.
both keyless and remote start.

if you have tools, then get car serviced
the modern system will do that
if doors are ajar (real or switches lying)
if transmission shiftier in wrong state, (true or not (switches fail)
or gross engine or transmission errors detected.
or low battery (in car)
or,
(well the fsm on car tells you all this, read it?)

here it is.
just 4 bucks to read it
https://suzukipitstopplus.com/Products/1158-2008-xl7-service-manual.aspx

read about Remote start diagnosis.
if that sounds too hard,? (for most folks, yes)
get car repaired? at a shop?>
--------------------fsm excerpts to scare you-----
Remote Vehicle Start Inoperative

Diagnostic Instructions

Perform the Diagnostic System Check - Vehicle ) prior to using this diagnostic procedure.

Review Strategy Based Diagnosis for an overview of each diagnostic approach.

Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Description

Remote vehicle start (RVS) begins as an RF message received by the remote control door lock receiver (RCDLR) from a keyless entry transmitter. The RVS request is sent by the RCDLR to the body control module (BCM) via serial data. The BCM monitors system conditions such as content theft deterrent (CTD), hood ajar status, and body DTCs to determine if an RVS event will occur. If conditions are determined to be acceptable, the RVS message is sent to the engine control module (ECM). The ECM monitors system conditions such as engine control parameters and vehicle theft deterrent (VTD) to determine if engine starting will be allowed. If conditions are acceptable, the ECM will initiate engine starting. During the engine run time in a RVS attempt, before the operator enters the vehicle, the ECM may discontinue engine operation if system conditions require it or a message is received from the BCM requesting the engine be turned OFF.

Diagnostic Aids

NOTE

Important: If the vehicle has a current vehicle DTC that illuminates the malfunction indicator lamp (MIL), the cause of the DTC must be diagnosed before proceeding with the Remote Vehicle Start Inoperative diagnostic.

The RVS system will not operate if any of the following conditions are present:

A current vehicle DTC that illuminates the malfunction indicator lamp (MIL)

The vehicle is in valet mode.

More than 2 remote starts have been attempted.

The hazard switch is in the ON position.

A current hazard switch DTC is set.

The vehicle hood is ajar.

A current hood ajar DTC is set.

The CTD system detects an alarm trigger.

Excessive engine RPM

Excessive coolant temperature

Accelerator pedal position greater than 0 percent

Vehicle not in park

Vehicle theft deterrent malfunction

A current automatic transmission shift lock control system DRC is set.

A vehicle speed sensor signal is detected by the ECM.
end quote.

you can read the FSM online for $4 the real 100%
suzuki FSM, do so, or get car serviced like 99% do today.

This list will grow , after 3 top lawsuits
win cases and recalls, happen.
My prediction.... Carbon dioxide poisoning.
the silent killler.
rule 1, to be added.
cant exit car with it running... Keyless. starts.
and car can not keep running, if ambient CO is too high, a new sensor, added.
many older homes have zero protection for CO detection, nor properly sealed garages..
garage to home.
Innocent deaths, and some are unsolved !

Feb 12, 2016 | 2008 Suzuki XL7

1 Answer

How to fix control stability off Suzuki XL7 2008. Car turns on but wont crank.


battery dead, charge it or jumper cable start it , with running donor car, like AAA tow does, (watch them or call them?>)
battery post green with corrosion , clean them its a std service point.
check fuses....
stater hot wired, (above ok) wont crank is bad starter.\
if cranks hot wired, its a good starter by bad key line,
ill stop here, ask who to test key line if you get this far,

that 1st line on Stability , ive not a clue. why not be clear where you see that. (a warning lamp. or? what)

Nov 13, 2015 | Suzuki Cars & Trucks

1 Answer

Remove center console 2008 suzuki xl7


between seats.?
there are 3 choices for docs. to read.
a real FSM. by suzuki , book (buy one) used? at fleabay
alldata.com
and
just 4 bucks to read it
https://suzukipitstopplus.com/Products/1158-2008-xl7-service-manual.aspx


Feb 02, 2015 | 2008 Suzuki XL7

1 Answer

The horn won't work and the fuse is ok on my 2008 suzuki xl7


Trace where horn is and place multi meter on dc and connect to horn connector then press horn and see if voltage appears if so its your horn if not its possible your s-wheel or stalk connection. Hope this helps

Jan 23, 2012 | Suzuki GSX-R 600 Cars & Trucks

1 Answer

For about 2 weeks my car has been hard to start now it wont start it acts like the starter is not engaging to turn motor over when you try to start it it makes a whinning spinning noise we took starter off...


sounds like the battery wire to the starter is possibly the culprit, it may have a bad spot in it not allowing enough voltage to the starter. also depending on the brand solenoid you purchased it is possible to get a bad one. i recommend borg warner electrical products. i hope this helps.

Feb 13, 2011 | 1994 Lincoln Continental

Not finding what you are looking for?
2007 Suzuki XL-7 Logo

Related Topics:

367 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...