Question about Buick Century

1 Answer

Somebody took off wires and i dont know where they go on coils

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,915 Answers

Need to know the year, model and engine in your buick to help you.

Posted on Mar 25, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I cant get my a985 F250 to stay running, bought a new Carb, bought a new ignition control module, new coil


Check the wiring from the ignition switch . When you got fuel as the engine was cranking then the power for the pump is on the start side of the ignition switch and not in conjunction with the run side of the switch.. IT could be a fuse in the run circuit or a faulty pump relay.

Feb 17, 2014 | Cars & Trucks

1 Answer

I have a 2002 rodeo with ignition coil malfuntion code ,but i change a coil pack 2 times with a new ones ,spark plugs ,wires timing belt and the problem still there and now i don't know what its can...


try the coil module locatrd by the coil on top of the engine.
It's a little flat chip looking device that regulates the ignition system,should cost somewhere arround $22.00

Nov 25, 2010 | 1998 Isuzu Rodeo

1 Answer

I have a 2003 ford ZX2 I have a number 2 and 3 cylinder are not getting spark the coil has been tested and found that is was grounded out on one side of the coil I replaced the coil after testing the new...


Coil on plug ignition or coil pack ? American vehicle or UK ? The PCM - engine computer controls the coil by the use of a transistor inside . Testin can be do with a test light . Video on youtube , posted by scanner danner , a teacher at a technical school . Should have B+ voltage on one side an the PCM supply's a ground . Have seen a number of fords coil shorts out frying the PCM . Would set a code .

Mar 11, 2017 | 2003 Ford ZX2

1 Answer

Took the efi 5.0 out my 89 bronco and installed a 351w carburated out a 84 bronco.wiring in the 84 was screwed.replaced the distributor with a points distributor and coil and no matter how i wire it it...


I dont know what "points distributor" you installed or how you made sure you installed it correctly. But a more simple way would be to get a distributor that has the coil pack built in. That kind only would require 2 wire connection. Positive 12 v and ground. also it has a 3rd connection you may use that is for the tac. very simple.
The one you have now ... do you get spark to the spark plugs. If so I would fool around more with being sure it is installed correctly, find TDC and be sure the rotor is pointing to the #1 cylinder, ALSO that you have the plug wires going in the right order on the cap. I dont think you will have luck with the computer compatible question.

Oct 01, 2009 | 1989 Ford Bronco

1 Answer

Battery light stay on


Sounds like you covered all the bases, which is good. I would now start looking at fuses and wires. Start at the battery. Other than the battery cables, look at the wires, look for anything loose, especially at connectors, wires that have worn or cut insulation, or wires that look burnt or are unusually soft. Check the connector and the wires coming out of the alternator too. Good luck.

Jul 01, 2009 | 2003 Hyundai Accent

1 Answer

Coil wire shorting out, replaced wire, still no spark


I HAVE A QUESTION THAT MIGHT HELP, THE 22-RE 4 CYLINDER HAS A STEEL TIMING CHAIN, IVE BEEN TOLD THAT THE V-6 HAS A RUBBER TIMING BELT ON THE SIDE OF THE MOTOR UNDER A COVER?

Feb 20, 2009 | 1991 Toyota Pickup

3 Answers

Wont stay started


Last tuneup? What was done at that time?

Oct 17, 2008 | 1991 Buick LeSabre

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...