Question about Chevrolet Chevy

Open Question

Diagram to rebuild weber carb 32/36 - Chevy Chevrolet Cars & Trucks

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
landsend
  • 1066 Answers

SOURCE: howto install weber carb

Remove the old carb.  Bolt the new carb and gasket onto the manifold.  Hook up the fuel line and clamp.  Thread the throttle cable through the linkage and tighten.  Have someone hold the gas pedal to the floor, look inside the carb and make sure the throttle plate inside the carb is full open.  Next, wire in the electric choke, this should just clip on.
Now after the engine is running and warmed up...adjust the mixture and idle speed adjustments on the side of the carb.  Is this a two barreled cab and does it have a manual choke?

Posted on Mar 25, 2009

Ad
  • 90 Answers

SOURCE: 1984 datsun z24 carb swap

You can yes, but I think you will need to change the inlet manifold as well, sorry but its been a while since done a datsun.

Posted on Mar 25, 2009

muntejaya
  • 10421 Answers

SOURCE: I have a 1984 nissan 720 pu with the z20 motor

Please replace the pilot jet on your carburetor.

Posted on Jan 30, 2011

emissionwiz
  • 76846 Answers

SOURCE: Weber carb accelerator pump diagram needed . Not

We go by model and year. But suggest you goggle how to rebuild a model ______ weber carb.

Posted on Jul 15, 2014

nobody322
  • 20706 Answers

SOURCE: I need a diagram of fast idle link assembly on weber 34DGEC carb

Tammy , weber has the pages to fix webers, why not read there.
its all there. for custom carbs,
fixing cars is a labor of love, if not, dont buy custom cars.
and for sure webers.
TAKE Photos of your work, its free now , no Kodachrome.
the car came with Autolite/motorcraft, carter or Rodcheter carb.
not webers.

idle, all carbs you can set the idle to zero. with the fly plate closed
and the engine stalls.
so does your butterfly plate close.

IDLE DOWN, HOT or cold engine,? is the choke OFF?
if the choke is off you can starve it of all air. at the stop screw.
if not, then the throttle cable is tight,
or you have air leaks in the plenum somewhere.
but air leaks cause lean, but with a bad tuned rich weber, it will race with air leaks, bingo???? im a carb o holic. retire.

Posted on Jul 28, 2014

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Advise on replacing or getting carburetor for my car.suzuki vitara 1992 manual with carby 2 door soft top


welcome to USA forum
we dont have 92 vitara's here we do have sidekicks /trackers
but carbs are ******* here, this car, this year, so zero CARBS.
our 92 both engines are fuel injected, TBI/MPI

finding carb rebuild kits are super hard this old a car.
and a mech, willing to touch one. 10x harder.
in the USA we have older Samurai's (Jimny in Euro speak)
the SAMMI's had carbs, and most of them (carbs) all are long long dead and gone. for all the reasons stated above, (0 support on carbs)
so we put in A nice Harley CV cab.
it is 100x more easy to tune than any weber made.
the weber needs custom jetting to work on your G16 engine.
(G13?) nah. i bet its G16 engine, right, and UNSTATED.
custom jetting, so join Vitara forum and post there.
ever google that.
Vitara forum?
its amazing that. small step.
we dont have G16 custom fueling systems pages here.
this place is a massive deep, un indexed or unorganized forum.

here is one seller, (random picked, I never spam)
study up on how CV works, it makes tuning vastly more easy.
a fact. (physics)

http://www.lowrangeoffroad.com/sidewinder-suzuki-samurai-cv-carburetor-installation-kits-40mm-or-44mm-seu-cvck-40-seu-cvck-44.html


Oct 02, 2016 | Suzuki Cars & Trucks

1 Answer

Need Diagram of firing order foe 1984 nissan pickup 720


Here's a link Samson to your firing order. Need Diagram of firing order for 1984 nissan pickup 720 Google Search Ihave a 85 Nissan 720 4x4 with the 2.4 engine,I have put a weber carb in mine,here's a video to see. 85 Nissan 720 4x4 2 4 Weber conversion If you want to join a cool Nissan site,here's a link,type in 720world.com,I am a member,

Apr 22, 2015 | 1984 Nissan Pickup

1 Answer

I need a diagram of fast idle link assembly on weber 34DGEC carb


Tammy , weber has the pages to fix webers, why not read there.
its all there. for custom carbs,
fixing cars is a labor of love, if not, dont buy custom cars.
and for sure webers.
TAKE Photos of your work, its free now , no Kodachrome.
the car came with Autolite/motorcraft, carter or Rodcheter carb.
not webers.

idle, all carbs you can set the idle to zero. with the fly plate closed
and the engine stalls.
so does your butterfly plate close.

IDLE DOWN, HOT or cold engine,? is the choke OFF?
if the choke is off you can starve it of all air. at the stop screw.
if not, then the throttle cable is tight,
or you have air leaks in the plenum somewhere.
but air leaks cause lean, but with a bad tuned rich weber, it will race with air leaks, bingo???? im a carb o holic. retire.

Jul 26, 2014 | 1983 Jeep CJ7

1 Answer

Weber carb accelerator pump diagram needed . Not pumping .. anyone? ??


We go by model and year. But suggest you goggle how to rebuild a model ______ weber carb.

Jul 15, 2014 | Cars & Trucks

1 Answer

Ihave a 1991 nisan pickup 2.4


Could be a bad chain guide or tensioner.I've got a 85 Nissan 720 4x4 2.4 with a Weber carb.Had her since 1993.It had 108,000 miles on it when I got it.Not long afterwards,Carb went bad,no one could rebuild it,tried 3 places.Finally took to Nissan Dealer,they told me that the carb was a bad design and they could not rebuild,they told me it was junk,they were right,not long afterwards motor went bad,so I got a remanufactured Jasper motor,with 3 year-or 100,000 mile warranty,got it in 2009,I now have 61,000 miles on it with a new Weber carb and it runs awesome,never ever had a timing chain issue,speedo now has 344,000 miles on it.Had the engine installed by a Jasper engine installer,a pro,seems like whoever has been putting timing chains in your engine is clueless on these 2.4 engines,our Nissan's have a history of head gaskets blowing,never timing chain issues.Here is a link on how to replace your Timing chain. Repair Guides Engine Mechanical Timing Chain And Tensioner AutoZone com Here is a photo of mine,need more help,let me know.
85 nissan 720,4x4 king cab-tcwzaisq5qned4kkicf4rqau-2-0.jpg

Sep 01, 2017 | 1991 Nissan Pickup

1 Answer

Stock carb or weber 2 barrel whats going to best for mpg this is a daily driver 258 6cyl would like to get close to 17mpg


i would go with the weber.this is why.

Weber - This is probably the most common carb conversion for the 6 cyl Jeeps. The Weber is a very reliable, all mechanical carb that improves performance and drivability. The Weber is designed to supply the proper amount of fuel determined by the demand put on the engine. When demands are small, only the primary barrel is used, and when demands increase, the second barrel is used in to deliver the performance needed. Use of thie carb allows removal of all the electronics associated with the BBD. The 32/36 DGEV model claims 18% hp increase over the stock factory carb as well as 10-20% fuel economy increase. The 38 DGEV model is designed for higher power applications where headers, cam, and aftermarket intake manifold are used. $$

Oct 28, 2010 | 1985 Jeep CJ7

2 Answers

I need a diagram to rebuild the carb for my 67 250 inline 6


When you buy a carb. rebuild kit it will come with the diagram chart and spec to rebuild it.

Jun 10, 2010 | Cars & Trucks

1 Answer

My p/u 1988 mitsubishi 2.6L runs rough after replacing carb with


Have a qualified mechanic rebuild your original carburator and reinstall it with all the original vaccum hoses and controls functioning properly.

Someone smarter than you and I, designed this engine to function properly with the feedback carburator. Installing an aftermarket carb negates the entire emision control system and will not allow the engine to "Breathe" properly.

"KISS" (Keep it simple, Stupid)

Mar 11, 2009 | 1988 Mitsubishi Mighty Max

1 Answer

1988 jeep wrangler carb trouble


Ok... If you have any experience with carbs, you can get a rebuild kit. The most important part of any rebuild is to clean out obstructions in the passageways. Most times this can be done by using carb cleaner and spraying compressed air through them.Most times, just spraying cleaner into carb while installed is a waste of time as debris usually consists mainly of fine rust particles from inside the fuel tank, which will remain in the fuel bowl unless physically removed. If you can't do this, next best option is to search local junkyards for a similar unit. When replacing, cut the fuel line in a convenient place ahead of the carb inlet and put an aftermarket filter in the line, to prevent debris from re-entering and causing further problems. Most carbs have the adjustments blocked off. before using, it is wise to have someone who knows how to remove those plugs, do this for you so you can adjust it after installed.
Good luck

Jan 25, 2009 | 1988 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...