Question about 1997 Chevrolet Lumina

1 Answer

I need to replace the pulley on my 1996 chevy lumina power steering. How do I put it on?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chevrolet Master
  • 975 Answers

Takes a special puller to remove,install is just a bolt thru the pulley and tighten with a nut,make sure the shaft sticks out of the pulley about 1/16 of an inch,if it's on too far the belt will be niosey. Autozone can rent you the puller for a few bucks.

Posted on Mar 25, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I tell if my 1997 chevy lumina's power steering pump is bad


yes if the aux belt is disconnected the pulley should turn free with slight resistance, sounds like a pump fault.

Feb 13, 2013 | 1997 Chevrolet Lumina

1 Answer

Replace power steering pulley on 200 chevy malibu


GM power steering pump pulleys are a pressed on type with an"interference" fit-the hole is .001" smaller than the shaft.You need a puller/installer tool.I bought one for about 30 bucks at NAPA,you might be able to rent one at an auto parts store.The tool clamps the pulley nose and has a screw to push the shaft out.(some Chrysler alternators use the same design).

Sep 06, 2012 | 2000 Chevrolet Malibu

2 Answers

Where is the water pump located on a 1999 chevy lumina ls 3.1L car


stand on passenger side of car looking directly to engine, the first pulley from left to right is the alternator pulley, the next one is the power steering pump pulley and the third one is the water pump pulley with 4 bolts on center attach to water pump (pulley does not have any grooves on it).

Feb 11, 2011 | 1999 Chevrolet Lumina

1 Answer

How can i remove an airbage when the steering 1996 chevy lumina


The airbags that i have removed in chevy steering wheels is easy, there are holes,one on each side of the steering wheel,you push something small and stiff in the hole and pull out ,do one side at a time. It shouldnt matter if the steering wheel is locked .

Apr 11, 2010 | 1996 Chevrolet Lumina Mini

1 Answer

Po306 code on a 1996 Chevy Lumina also ge a metallic squeak from the drive belt end of the motor. with the belt off as well


the bottom crank pulley is either lose! the keyway sheared and vibrateing against the crank sensor or the bolt in the crank pulley has backed off or fell out

Jan 21, 2010 | 1996 Chevrolet Lumina Mini

2 Answers

1996 Chevy Lumina Sedan Whining noise from engine


The pattern you describe is consistent with an alternator going bad. Maybe the fields are already rubbing together. Test it this way: Start the car and leave on idle, when the whine is worse, then start using up electricity, by increasing the demand. Turn on AC, then lights, then full blower and then high beams. If there is a change in the whine, then either alternator or voltage regulator is the culprit. When a compressor pulley bearing is bad, noise shifts just by turning AC on and off.

Jan 02, 2010 | 1995 Chevrolet Lumina

1 Answer

Removed the old fan belt. But don't know hos to


LOOP THE BELT UNDER THE CRANK PULLEY, START WITH THE RIGHT HAND AND GO AROUND THE LEFT HAND SIDE OF THE WATER PUMP, DOWN TO THE POWER STEERING PUMP, OVER THE A/C COMP, UNDER THE IDLER PULLEY, OVER THE ALTERNATOR, AND THEN THE TENSIONER.

ITS EASIEST TO SLIDE THE BELT UNDER THE IDLER LAST AND RELEASE THE TENSIONER.

Jul 10, 2009 | 1996 Chevrolet Suburban

1 Answer

1996 chevy lumina 3.4. service engine light on


You will need to replace the valve body in the transmission.

Mar 01, 2009 | 1996 Chevrolet Lumina Mini

2 Answers

Replacing a power steering pump on a 1996 Olds Delta 88 Royale


3 bolts should be holes in the pully too go thru with an extension if their are no holes in the pully then you nee a power steering pump pully remover it can be rented for 5.00 at auto zone

Feb 23, 2009 | 1996 Oldsmobile Eighty Eight

Not finding what you are looking for?
1997 Chevrolet Lumina Logo

176 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...