Question about 1999 Ford Taurus

Open Question

1999 Ford Taurus SE front drivers side turn signal bulbs burnt out. How do I change them?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

red54eyejp
  • 25 Answers

SOURCE: front driver side turn signal light doesn't flash

replace flasher......usually located in fuse block area...listen in this area....select passenger side ...then select driver side...you can hear flasher clicking...you have seperate flashers for each...FLASHERS are small cubes plugged into fuse block....probable bad driverside flasher

Posted on May 09, 2009

jaysonemanme
  • 500 Answers

SOURCE: 2002 Ford Taurus Driver Side tail light bulb replacement

open the trunk.
pull back the cover on the side you need to change, there are usually 3 black plastic nut you have to remove before doing this.
after the trunk interior cover is pulled off there are 3 nuts, 11mm wrench or socket will take them off. pull the taillight assembly out and twist the socket out containing the bulb that is blown. the bulb just pulls out of the socket. while the bulb is out you should inspect the socket for corrosion, it wont hurt to clean it up and put some die electric grease in there

Posted on May 19, 2009

moparownr
  • 667 Answers

SOURCE: mfuse box cover and diagram is missing, don't know which fuse to pull for lighter and dome light on 1999 ford taurus se

if you do not have an owners manual you can find it at https://www.fleet.ford.com the fuse chart is in the manual hope this helps

Posted on May 20, 2009

  • 14036 Answers

SOURCE: need replace turn signal bulb

YOU HAVE TO THE FRONT HEADLIGHT HOUSING TO REPLACE THE TURN SIGNAL BULB.

Posted on Aug 24, 2009

Testimonial: "thanks"

  • 120 Answers

SOURCE: 2007 ford 500 rear turn signal bulb replacement

This is straight from the owner's manual.

#1 Make sure the headlamp switch is in the OFF position and open the trunk.
#2 Carefully pull the carpet away to expose the backside of the tail lamp assembly.
#3 Remove the nut and washer assemblies, then pull the lamp assembly away from the vehicle.
#4 Remove the bulb socket by rotating it counterclockwise, then pulling it out of the lamp assembly.
#5 Pull the bulb straight from the socket.

Install new bulb(s) in reverse order.
Good luck

Posted on Jan 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

All signals and other flashers work but passenger front flashers do not work


Use a test light, test for power and ground at the bulb contacts. Then test for power and ground at the wires. Probably needs a new socket, common problem.

Oct 27, 2015 | 1995 Ford Taurus

5 Answers

2000 taurus left turn signal flashes rapidly and the left rear turn signal lamp does not work. Does ford have burned out bulb sense circuit that would give this indication? The right side flashes normally.


Yes - the fast flashing is a warning that a bulb is burned out. Change the bulb (be careful to put it in the same as the old one as it probably is 2 bulbs in one , parking and turn/stop) and you should be fine.

Jul 08, 2011 | 2000 Ford Taurus

1 Answer

Easiest route to change a front turn signal bulb in a 1998 ford taurus se ?


Get needle nosed pliers & go under the hood thru the hole right above the blinker.

Apr 01, 2011 | 1998 Ford Taurus

2 Answers

Right turn signal flashes fast


One of the bulbs is burnt out. Turn on hazard lights and check bulbs.

Dec 31, 2010 | 2005 Ford Taurus

1 Answer

How do you change the front turn signal bulbs?


I can help you change the turn signal bulbs on your 1997 Ford Taurus

Oct 04, 2010 | 1997 Ford Taurus

4 Answers

Front signal light not working and rear signal lights flashing fast on 1999 intrigue


Your front turn signal socket is shot. Buy a new one at the dealer for about 30.00. It will fix it. You may be able to clean it and wiggle it to get it to work. But it wont last very long. I had the same problem. Replaced the socket and it is fine. Note: If one side is bad the other side it not far behind. Probably 2 or 3 months it will go also. Good Luck.
Bill

Apr 17, 2009 | 1999 Oldsmobile Intrigue

1 Answer

1998 ford taurus left turn signal blinking fast


Replace the bulb that stays on and doesn't blink, if that doesn't solve the problem, let me know.

Apr 13, 2009 | 1999 Ford Taurus

1 Answer

Left rear turn bulb is burnt out


Pull the trunk carpet back behind the lamp assembly. Remove the 3 nuts from the bolts and pull the lamp assembly away from the body. Then disconnect the connector to the bulb then twist the socket cc to remove the socket then pull the bulb out of socket.

Mar 15, 2009 | 2002 Ford Taurus

1 Answer

Turn signal problems


Turn signals have a relay (its a small switch that charges and discharges current) which controls your turn signals blinking speed and interval. This is most likely your problem. You should be able to get a new one at your local parts store. Follow these instructions, in this order, and let me know how it works.

Step 1:Turn on the hazard lights and walk around the Taurus checking that all four turn signal lights are working. If any of them are not working, replace the bulbs. A non-working bulb in any of the turn signals will often make the turn signals appear that a flasher is going bad.

Step 2:
Locate the fuse box and check the fuses for the turn signals. There may be more than one. Replace any fuses that are blown and then recheck the turn signals again. If they still aren't working properly, then move on to replace the flasher. Step 3: Look for a round, silver-colored object near the fuse box. Put your finger on the object and turn on the turn signal. You should be able to feel a mechanical clicking as the turn signal blinks. This is the flasher. Step 4: Pull the silver flasher out of the socket and replace it with the new one. Each of the flashers should have two pins sticking out of the bottom side. Start the Taurus and recheck the turn signals to ensure that they work. Joel

Mar 04, 2009 | 1999 Ford Taurus

1 Answer

Front left turn signal bulb replacement on 99 taurus?


take the headlight assbly. out two bolts on top under hood

Feb 14, 2009 | 1999 Ford Taurus

Not finding what you are looking for?
1999 Ford Taurus Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...